2005 Mazda Rx-8 4dr Cpe Auto Low Miles Extra Clean Priced To Sell ! ! ! ! ! ! on 2040-cars

Auto blog

Takata airbag recall spreads to China with 42k Mazda sedans

The scope of the problem with the faulty airbag inflators from Takata continues to broaden and is now reaching China, as well. Mazda is recalling 42,732 Mazda6 units there, produced by its local joint venture partner China FAW Car Company, to replace the front passenger airbags. It comes as part of Mazda's recall of nearly 160,000 vehicles worldwide, including about 34,600 in the US, according to Reuters.
This is the same problem that caused seven automakers in the US to recall an estimated 2.1 million vehicles in late June. The airbag inflators can potentially explode instead of deploying the airbag, which hampers the bag's inflation. In some cases occupants are also hit by the metal shrapnel, which can cause further injuries. In the US, Mazda is repairing the 2003-2007 Mazda6 (pictured above), 2006-2007 Mazdaspeed6, 2004 MPV and 2004-2008 RX-8 originally sold in or currently registered in Florida, Puerto Rico, and Hawaii.
This is hardly the first instance of this issue. Since 2001, there have been 20 recalls tied to the exploding airbags supplied by Takata. The problem is possibly linked to the propellant in the inflators, but there's no conclusive evidence of that yet. Most of the automakers in the US limited the most recent recalls only to a few humid states because moisture potentially exacerbated the problem.

2016 Mazda MX-5 Miata a knight in white satin

We're not going to lie to you. The reason you're seeing the fourth-generation Mazda MX-5 Miata on these pages again is solely because this is the first time we're seeing the roadster displayed in a color other than the ruby shade it was first shown in. Okay, okay, so this is the first time the Miata is being displayed at a North American auto show other than SEMA, and we'd say that this is the first time Mazda is showing a US-spec model, but clearly this is a right-hand-drive car. Either way, there's still not much to it yet, especially since Mazda is still withholding power and performance figures.
As expected, the ND Miata, as it is already known among the cognoscenti, will receive a 2.0-liter Skyactiv four-cylinder and the buyer's choice of a six-speed manual or a six-speed automatic here in the US. The 1.5-liter model engine that had been linked to the car back in the rumormill stage will not make it to our showrooms.
Preliminary specifications still show the Miata measuring just 154.1 inches in length overall, with an increased track width to 68.1 inches and a low, low overall height of 49.0 inches. Despite the larger-displacement engine and its presumably heavier weight, Mazda is still claiming ideal 50:50 weight distribution and a weight loss of over 220 pounds versus today's NC generation. All of which sounds like the Miata has the right ingredients to make good on its promised Jinba Ittai ("rider and horse as one") driving experience.

Chicago Auto Show page claims 2016 Mazda MX-5 Miata to produce 155 hp [UPDATE]

UPDATE: Mazda wasn't willing to confirm or deny the figures cited by the Chicago Auto Show, although we're betting the 155-horsepower figure is a bit on the low side. As for the CAS page, a Mazda spokesman told Autoblog that they "aren't sure where they got that number." The horsepower estimate has since been pulled down. Well, someone may have made a boo-boo. The Chicago Auto Show is currently hosting a page that claims the Mazda MX-5 will produce 155 horsepower, courtesy of a 2.0-liter, Skyactiv four-cylinder. If this is correct, it'd be the first time the MX-5's US power output had been revealed. The 155 hp figure would account for a 12-hp drop from that of the outgoing MX-5, though, a corresponding weight loss should still improve the power-to-weight ratio for the 2016 model. Now, the CAS page could simply be following previous reports, including one from Autoblog. As recently as October, it was being reported that the MX-5 would be powered by a 2.0-liter, Skyactiv four-cylinder, a version of which is producing 155 horsepower and 150 pound-feet of torque in the Mazda3. Naturally, we've reached out to Mazda for comment – or perhaps even confirmation – on the info from CAS, although we aren't expecting a reply until at least later this morning (darn time zones). Of course, as soon as we hear anything, we'll update this story. Related Video: