Find or Sell Used Cars, Trucks, and SUVs in USA

Alloy Wheels--low Miles--manual Transmission on 2040-cars

US $8,991.00
Year:2000 Mileage:35832 Color: Red /
 Black
Location:

Bradenton, Florida, United States

Bradenton, Florida, United States
Advertising:
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Dealer
Transmission:Manual
Body Type:Convertible
VIN: JM1NB3534Y0155831 Year: 2000
Warranty: Unspecified
Model: MX-5 Miata
Mileage: 35,832
Options: Compact Disc
Sub Model: LS
Safety Features: Anti-Lock Brakes, Driver Side Airbag
Exterior Color: Red
Power Options: Air Conditioning, Power Windows
Interior Color: Black
Number of Cylinders: 4
Doors: 2
Engine Description: 1.8L L4 FI DOHC 16V
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

Auto Services in Florida

Xtreme Auto Upholstery ★★★★★

Automobile Parts & Supplies, Automobile Seat Covers, Tops & Upholstery, Boat Covers, Tops & Upholstery
Address: 549 N Goldenrod Rd, Clermont
Phone: (407) 674-9523

Volvo Of Tampa ★★★★★

Auto Repair & Service, New Car Dealers
Address: 6008 N Dale Mabry Hwy, Valrico
Phone: (813) 885-2717

Value Tire Loxahatchee ★★★★★

Auto Repair & Service, Tire Dealers, Wheels-Aligning & Balancing
Address: 105TH Ave. North Unit #28, West-Palm-Beach
Phone: (561) 290-0127

Upholstery Solutions ★★★★★

Automobile Parts & Supplies, Automobile Seat Covers, Tops & Upholstery, Automobile Accessories
Address: 3099 Ste 2 Leon Rd, Jacksonville
Phone: (904) 318-6199

Transmission Physician ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Auto Transmission
Address: 30940 Suneagle Dr # 102, Astatula
Phone: (352) 383-0026

Town & Country Golf Cars ★★★★★

New Car Dealers, Golf Cars & Carts
Address: 1114 Bichara Blvd, Weirsdale
Phone: (352) 753-9392

Auto blog

Mazda recalls 193k CX-9 crossovers over corroded suspension

Wed, Aug 5 2015

An issue with the suspension on the CX-9 has prompted Mazda and the National Highway Traffic Safety Administration to recall 193,484 vehicles across the United States. The campaign specifically affects units from the 2007-2014 model years, manufactured between October 24, 2006, and December 28, 2013. In those affected vehicles, the ball joints in the front suspension may corrode due to water leaking into the fitting. According to the statement below, if the ball joint rusts, the front lower control arm could separate, resulting in a loss of steering control. And needless to say, that could lead to a crash. To repair the issue, Mazda will have to replace both the left and right lower control arms, and will naturally do so free of charge, but will undertake the repairs in stages. First, owners of the affected vehicles will receive a notification that a recall campaign is under way. Then they'll get a second letter when the parts are ready and they can bring their vehicles into their local dealers. The company will start first with 2007-09 vehicles, specifically those registered in the snowy states of the Northeast and Midwest. Specifically: Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin, and Washington, DC. (Oddly, states in the the western portion of the Midwest, as well as the Rocky Mountains and the Pacific Northwest, were not included in that initial phase. Nor was Alaska, for that matter.) After that they'll call in 2010-14 models in the same states before undertaking repairs on vehicles in other areas to the west and south. Related Video: RECALL Subject : Corrosion of Front Suspension Ball Joint Report Receipt Date: JUL 20, 2015 NHTSA Campaign Number: 15V451000 Component(s): SUSPENSION Potential Number of Units Affected: 193,484 Manufacturer: Mazda North American Operations SUMMARY: Mazda North American Operations (Mazda) is recalling certain model year 2007-2014 CX-9 vehicles manufactured October 24, 2006, to December 28, 2013. The affected vehicles have front suspension ball joints that may corrode from water leaking into the fitting. CONSEQUENCE: Over time, the ball joint corrosion may result in the front lower control arm separating from the ball joint, causing a loss of steering control and increasing the risk of a crash.

Mazda hits Vegas with a pair of Sixes

Tue, 05 Nov 2013

Despite the fact that the annual SEMA show is more of an exercise in what "could be" than what "will be," it gives automakers the chance to stretch the legs of some of its most important models. Take the 2014 Mazda6, for example - it's hardly new, having gone on sale early this year - but this year's SEMA expo marks the first time Mazda has been able to show off the customization possibilities for its sleek midsize sedan. To that end, the Japanese automaker has arrived in Las Vegas with two very different takes on its sexy Six.
First up is the Mazda6 Club Sport you see above, wearing a "motorsports-inspired" gray, black and red accent-color scheme that, as Mazda says, is "represented in not-so-subtle angular lines reminiscent of a car speeding past your line of sight." The whole car is done up in a base color of Composite Grey, and uses a Brilliant Black roof to match the similarly colored front, side and rear diffusers, as well as the rear spoiler. Mazda has fitted the Club Sport with Rays 57 Motorsport G07FXX 20-inch wheels, wrapped in Yokohama 245/35R20 tires. Powering the CS is Mazda's 2.2-liter Skyactiv-D diesel four-cylinder engine (that we'll get in the standard Six early next year), and other changes include an H&R spring kit, larger Brembo brakes and a Racing Beat exhaust.
And then there's the Ceramic 6 Concept, pictured right. The name comes from the car's Ceramic White paint, though we don't really get the Taupe Silver accent stripes. Mazda says they're meant to mimic "the linear frequency patterns found on the likes of couture dresses and flowing fabrics," but it just looks a bit overwrought to us. The Mazda6 already has so many clean lines, why add more?

Mazda patents show rotary engine for range-extended EV

Fri, Mar 17 2017

Two years ago, Mazda introduced a fascinating range-extended electric car called the Mazda2 RE Range-Extender. It took an electric Mazda2, and dropped in an itty-bitty 330cc rotary engine. It wasn't the rotary-powered sports car we had hoped for, but it seemed like a unique way to keep the quirky engine alive and kicking. But not long after the car's reveal, it seemed to disappear. Now the basic idea has resurfaced with a few modern updates in a couple of US patents. The first patent is pretty straightforward and describes a range-extended EV similar to the BMW i3. At the front is an electric motor driving the front wheels. At the back is an internal combustion engine that powers an electric generator. In the middle is a lithium-ion battery for storing and delivering electricity. It's the same set-up as that Mazda2. The second patent is for an engine start-and-stop system, but specifically for rotary engines. The system is designed to shut off a rotary engine when not needed, much as modern piston engines do. It also stops the rotor in a position that closes the intake port to ensure no fuel or exhaust emissions slip out through the intake tract. This is necessary since there are no valves in a rotary, and air and exhaust come through ports that are "opened" and "closed" by the rotor itself. The patent also describes the possibility of firing a spark plug after the fuel has been cut to eliminate any leftover fuel emissions. This system would theoretically improve a rotary engine's fuel economy and emissions significantly, which would be a boon as those are two of the rotary's major weaknesses. The rotary-engine patent also includes the same range-extended powertrain drawing as the first patent. It's there as a description of a possible application. And in such an application, where the rotary wouldn't have to run all the time, the system could take advantage of the rotary's inherent strengths. Weight can be kept low thanks to the engine's small dimensions, which should help in keeping the car sprightly and efficient. Rotaries are renowned for smoothness, too, so it shouldn't need too much refining and sound deadening, the latter of which adds more weight. The small size would also help with packaging, leaving more space for people, cargo, or possibly batteries. And since it has been patented, the company may be looking to bring the system to market.