2008 Mazda Mx-5 Miata Grand Touring Convertible 2-door 2.0l on 2040-cars

Auto blog

Japan plans real-world diesel emissions test after companies fail

Japan's transport ministry plans to start real-world diesel emissions tests after an experiment found four models from Toyota, Nissan, and Mitsubishi that produced more nitrogen oxide (NOx) emissions than the nation's rules allow, according to The Japan Times. Regulators there usually only perform emissions checks in the lab. The VW diesel scandal has everyone double-checking their figures. Diesel versions of the Toyota Hiace van, Land Cruiser Prado, and Nissan X-Trail produced up to 10 times more NOx than allowed. The Mitsubishi Delica D:5 was up to five times over the limit, The Wall Street Journal reports. There was no evidence of defeat devices in the vehicles. Mazda performed well in the experiment, though. The CX-5 passed with nearly the same results on the road and in the lab. The Demio, better known as the Mazda2, did nearly as well with only slighter higher figures in the real world than in the controlled setting. The experimenters theorized the reason for the excessive emissions was that cold weather caused the engines' software to shut off the exhaust gas recirculation to prevent damage, according to the WSJ. However, this behavior also increased NOx production. Toyota, Nissan, and Mitsubishi don't have to worry about punishment from the transport ministry because this check was just an experiment. Their models already passed the mandated lab tests, which was the only requirement, according to The Japan Times. As governments begin greater real-world emissions tests, the results suggests diesels aren't very clean. A recent check in France found models from Ford, Renault, and Mercedes-Benz that didn't perform up to the standards. Regulators in India conducted similar evaluations and ordered VW to recall over 300,000 vehicles. Related Video:

Mazda rumored to bring rotary-powered RX-9 concept to Tokyo

Stop us if you've heard this one before: Mazda will bring a rotary-powered sports car to the next big auto show. Okay, so we stopped for a second, but the show must go on. Following an official teaser image (shown above) late last month, Motoring.com.au has what it claims are renderings of the curvy, two-door coupe – called the RX-9 – that Mazda will bring to the Tokyo Motor Show later this month. The images show a far softer styling than Mazda's current crop of Kodo-inspired vehicles, while the overall look screams of a modern-day Cosmo Sport, the Japanese brand's first rotary-powered vehicle. And though that connection alone might be enough to justify whisperings of a successor to the RX-7 and RX-8, Motoring claims there will be an even more overt sign of this concept's power source. "Look to the Cosmo Sport," an inside source told the Aussie website, signaling that the Mazda stand would feature the vintage two-door. "The Cosmo has no earthly reason for being there unless..." The rotary rumor, if it comes true, won't exactly be what we're use to. While Motoring brings up the previously reported 16X – a 1.6-liter two-rotor – it builds on our 2013 report. According to the Aussies, the new engine could feature a two-stage electric turbocharger, be paired with a hybrid powertrain, offer up to 450 horsepower, and we're guessing, be hilariously complicated. Joking aside, it sounds like Mazda's goals here are admirable. A rotary-equipped sports car that could counter the 1.3-liter RX-8 engine's appetite for fuel and improve on its mediocre low and mid-range torque would be interesting indeed. As for those renderings, Motoring has front and rear three-quarter images. Comparing the rear with our original teaser leaves the look open to interpretation, but after seriously upping the exposure on the teaser (thanks Photoshop), the taillights and overall profile shape look to be a spot-on match. In front, the long hood shares some Kodo elements, like the headlights and grille, but its undeniable coupe shape – a long hood and very short deck – are far more organic and, dare we say, calm, than Mazda's other vehicles. You can take a closer look at the renderings over at Motoring's website. Do that, and then head back and let us know what you think of these RX-9 rumors. Is Mazda finally going to be bringing a rotary back to market?

Mazda recalling 190,000 CX-7s due to rusty ball joints

UPDATE: This post has been updated with additional information from Mazda. The Basics: Mazda is recalling 190,102 Mazda CX-7 crossovers built between February 14, 2006, to May 9, 2012 – model years 2007 through 2012. The Problem: Water can sneak in between the suspension ball joint fittings. If snow and road salt are common in your neck of the woods, the joints can corrode and separate from the lower control arms. That's bad if you enjoy steering your CX-7. According to Mazda, owners of affected models may notice a rattle from the front suspension due to the loose ball joint in the lower control arm fitting. Mazda describes separation of the ball joint and control arm as a "worst case" scenario "after extended operation in such condition." Injuries/Deaths: It's unknown if the rusting issue has led to any crashes, injuries, or deaths. Autoblog has a call into Mazda for additional details and will update this post with any new information. There have been no reports of accidents, injuries, or fatalities related to this recall. The Fix: Owners should report to their local Mazda service center, where techs will replace the both front lower control arms. Any work done is free of charge. If you own one: Mazda will perform some automotive triage with this recall, focusing on CX-7s that have had the longest exposure to salt and are most likely to suffer control arm separation first. Owners of 2007s and 2008s come first, followed by 2009 through 2011 models. Mazda will also focus on vehicles registered in states where snow and road salt are most common – Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin, and Washington, D.C. If you live in a more temperate region or own a 2012 CX-7, Mazda will perform recall work as "parts are available." Owners can contact Mazda customer service at 1-800-222-5500 for additional info. Recall notices should hit the mail around October 10th. Related Video: Featured Gallery 2011 Mazda CX-7: Review View 21 Photos News Source: NHTSAImage Credit: Copyright 2016 AOL Recalls Mazda Crossover mazda cx-7