Leather, Memory, Heated Seats, Low Miles, Great Condition, Cd Changer, Luxury on 2040-cars

Auto blog

Ford issues six recalls covering 101,000 vehicles for multiple issues

Ford is announcing six separate recalls for a variety of issues affecting a dozen models and a total of 100,610 vehicles in North America. However, according to Ford spokesperson Kelli Felker, "None of them have caused accidents or injuries." Half of them cover fewer than 1,000 cars.
The largest recall covers 92,022 North American examples (about 83,250 in the US) of some models of the Ford Taurus, Lincoln MKS, Ford Interceptor, Flex and Lincoln MKT from the 2013 and 2014 model years; the 2012-2014 Edge and the 2014 Lincoln MKX. All of them have a potential issue with the halfshaft on the right side that might not be fully seated and could move outward over time. If it shifts too far, the models may no longer be able to drive, and the condition could also allow the vehicles to roll away, even when in Park. Dealers will inspect the shaft to make sure it's seated and will replace the part if necessary.
The next-largest recall covers 5,264 North American examples (4,867 in the US) of the Ford F59 Commercial Stripped Chassis from the 2011-2014 model years. It's possible that an electrical junction box can corrode in areas with salty roads and short circuit. The problem could potentially cause a fire. Dealers will replace the box with an improved design.

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

Hot-selling Ford Expedition, Lincoln Navigator get production boost

Ford is investing an additional $25 million in its Kentucky Truck Plant in Louisville to increase by 25 percent production of the hot-selling and all-new Lincoln Navigator and Ford Expedition SUVs. The investment adds to $900 million in previously announced spending at the plant, which also builds F-Series Super-Duty pickups and employs 8,400 workers. Assembly-line workers are putting in overtime and working voluntary weekend shifts to keep up with demand. The new investment will cover upgrades to the assembly line but does not involve further hiring, Ford spokeswoman Kelli Felker says. The popularity of the Ford Expedition and Lincoln Navigator is a bright spot as Ford stock has been battered by Wall Street amid concerns concerns about the automaker's future vision and slowness to detect trends. Ford says the investment is an example of its bid to improve "operational fitness," one of CEO Jim Hackett's common refrains. Ford says Navigator retail sales more than doubled in January, and Navigators are spending an average of just seven days on Lincoln dealership lots as customers trade in vehicles including Land Rovers and Mercedes-Benz. Nearly 85 percent of buyers are opting for high-end Black Label and Reserve trim packages, contributing to an average transaction price increase of more than $21,000 in January compared to a year ago. The 2018 Navigator won the North American Truck of the Year award and also topped a Detroit News poll of public favorites at last month's Detroit Auto Show. Sales of the Expedition, meanwhile, were up almost 57 percent last month as the full-size SUVs also spent an average of just a week on dealer lots. Platinum trim models represented 29 percent of sales, pushing transaction price increases up $7,800. Ford gave the 2018 Expedition an all-aluminum body to save mass in its first significant redesign since 2007. The plant last year got nearly 400 new robots, mainly in the body shop, to help increase line speed, and Ford added a robot lab where employees can test software tweaks or troubleshoot issues away from the factory floor. The Louisville plant also benefits from extensive new data analytics, with seven big-screen monitors providing minute-by-minute updates showing progress against hourly targets or alerting workers to pending parts shortages. A huge spare-parts "vending machine" lets workers more quickly locate needed parts and keep inventory at necessary levels.