2018 Land Rover Range Rover Hse Dynamic $61k Msrp on 2040-cars

Auto blog

Land Rover Defender V8 vs. Jeep Wrangler Rubicon 392 | V8 4x4s square off on paper

Land Rover pulled the sheet off its 2022 Defender on Wednesday, introducing another high-performance V8 to the off-road segment. This time, it's a 5.0-liter, supercharged V8 boasting 518 horsepower. It will be available in both the Defender 90 and 110 models. In the former, Land Rover says it can crack off a 0-60 run in just 4.9 seconds on its way to a top speed of 149 mph. The long-wheelbase 110 will be a bit slower, but "slow" probably isn't the right adjective to use here at all.  But Land Rover isn't the only automaker offering a high-performance variant of its off-road SUV. While Jeep may have been sneered at for presenting the 2021 Wrangler Rubicon 392 on the heels of the 2021 Ford Bronco's introduction, it starts to make a lot more sense in this context. There's reportedly a high-output Bronco on the way, too, so call Jeep the dinosaur of the group all you want, but you can't put a price on being first. Well, you can, actually, but that's not the point.  Thankfully, both Land Rover and Jeep have provided enough specs for us to rough out a comparison chart. Since the Rubicon 392 is offered only in four-door guise, we're looking at the long-wheelbase Defender 110 as its direct competitor here. Have a look: There are a few caveats to mention off the top. For starters, we don't have an official curb weight for the V8-powered Defender yet, as Land Rover has not finalized its U.S. specs. We used the European figures (as provided by a spokesperson), which we expect to be accurate within about 50 pounds. The 0-60 time provided by Land Rover was for the Defender 90, which is smaller and somewhat lighter than the 110. When equipped with the inline-6, the Defender 110 is about a tenth of a second slower to 60 than the Defender 90, so we figure it should be roughly the same for the V8.  While the Defender has nearly 50 horsepower on the Wrangler, that advantage disappears thanks to the Land Rover V8's monster weight penalty, which will fall somewhere between 600 and 700 pounds depending on equipment. Yikes. On the flip side, however, the Land Rover has the edge in top speed, and it's not even close. Chalk that up to the tires, we suspect. We know for a fact that the Rubicon 392's all-terrains dictate its speed limiter; Jeep's own engineers told us as much. This could make for a (hypothetically) interesting drag race, as the Jeep's advantage off the line may evaporate once triple digits come into play.

Land Rover to build Discovery Sport at new Brazilian factory

Looking forward to getting your mitts on a new Land Rover Discovery Sport? Well you should, because it promises to be a markedly better product than the Freelander/LR2 it replaces. Just don't assume it will necessarily be built in the UK, as just about every Land Rover has in the company's 66-year history. The new Discovery Sport (pictured above in Sao Paulo) will, of course, be built in the UK, at the Halewood plant where the Evoque is made and which has in the past handled the Freelander, the Jaguar X-Type and a variety of Fords. But it will also be assembled for local consumption at JLR's new factory in Changsu, China. And, according to the press release down below, it will also be made for the Latin American market at the new factory being built in Brazil. The new plant is being built in Itatiaia on the outskirts of Rio de Janeiro and will come online in 2016. Once it gets up to speed by the end of 2020, it will have the capacity to build 24,000 vehicles each year, ratcheting its workforce up from 400 when it opens to nearly 1,000 when all's said and done. The Discovery Sport will be one of the products made there for the local market, but it surely won't be the only one. As in China, we expect the Evoque will be built there as well, and we wouldn't be surprised to see the new Jaguar XE join it in the near future, either. Don't expect the Brazilian-made vehicles to be sold in the US, though: those will likely still be imported from the UK... at least, that is, until the facility said to be under consideration for the southern United States opens its doors. JAGUAR LAND ROVER CONFIRMS ITS ALL-NEW DISCOVERY SPORT FOR BRAZIL FACILITY - Jaguar Land Rover confirms Discovery Sport as one of the models to be produced at its new local manufacturing facility in Brazil - R$750m investment in the new facility in Itatiaia in the State of Rio de Janeiro - Annual production capacity of 24,000 units for the Brazilian market only – from 2016 Sao Paulo, Brazil – Jaguar Land Rover confirmed today, at the Sao Paulo International Motor Show, that its breakthrough Land Rover Discovery Sport will be one of the first models to be built at its new R$750m (GBP240m) local manufacturing facility in Itatiaia, Brazil. The new factory, which will see a total investment of R$750m (GBP240m) by the end of 2020, will supplement UK production and have the capacity to build 24,000 vehicles annually for the Brazilian market.

Who picks car colors and materials? Designers like Hannah Custance

As automotive journalists, we're often asked "how did you get that job?" People usually didn't even know you could do such a thing. In this 7 Questions series, we're highlighting other jobs in the automotive industry that you might not have heard about before. What do they do, how'd they get to do it and other questions about their particular corner of the car world. Slowly but surely, the automotive landscape is becoming more colorful. Look beyond the unrelentingly conservative palette of white, black and gray most buyers opt for and you'll see the increased use of exterior trim types beyond the usual chrome. There's gloss black, of course, but also other metallic finishes like gold or copper. Those can be found inside, too, where there's also an increase in colorful leathers and trims, innovative fabrics, new wood types and finishes, and greater creativity in general. So where is this change coming from? The answer is designers like Hannah Custance, the color and materials design manager for Jaguar Land Rover. Her team's latest effort is also its magnum opus, the 2022 Range Rover. Although saddled with the expectations that comes with one of the automotive industry's classic nameplates, the all-new Range Rover is also a celebration of cutting edge manufacturing and fashion-forward materials selection. We sat down with Hannah at the L.A. Auto Show to find out more about color and materials designers, how she ended up in the industry, and advice she might have for young designers out there. It has been condensed for brevity. Autoblog: What does a color and materials design manager to do?Hannah Custance: I basically look after a team of designers who design finishes for every A surface on the car. So, that could be exterior finishes. It could be interior trim materials, soft materials, hard materials, chromes, metals, woods, ceramic – that's one of the new ones – anything you can kind of touch and see is color material design. Autoblog: How early in the design process does your team become involved.Hannah: Right at the very start. In fact, we look at materials that don't have a product assigned to them or a car assigned to them. So, it takes actually a very long time for us to get materials approved and fully validated. We have to find suppliers that are willing to work in automotive and our test standards are incredibly high, some of the highest in the industry.