2008 Jeep Wrangler Unlimited X 4x4 4 Dr Lifted Manual 36688 Miles Hardtop Bimini on 2040-cars

Auto blog

FCA recalls 894k total vehicles worldwide in two campaigns

FCA is recalling a total of 893,698 vehicles worldwide in two campaigns to fix problems with inadvertent airbag deployment, failure of the anti-lock brakes, and stability control systems in the Jeep Grand Cherokee, Liberty, Dodge Journey, and Fiat Freemont. 559,703 of these vehicles are in the US. The larger recall affects 284,089 examples of the 2003 Jeep Liberty and 2004 Jeep Grand Cherokee, and there are also 13,411 of them in Canada, 6,277 in Mexico, and 48,212 outside the NAFTA region. Because of "electrical noise beyond the tolerance of the airbag electronic control module", part of that component can fail, according to the National Highway Traffic Safety Administration. This can cause the front and side airbags to deploy and the seatbelt pre-tensioners to activate inadvertently. FCA US has seven reports of alleged injuries from this problem. To fix the situation, the Jeeps need their Occupant Restraint Control modules replaced, as well as the front- and side-impact sensors. According to the NHTSA, the replacement parts won't be available until early 2016. Still, FCA US will advise owners about the problem in a letter by the end of December and will send a second notification when the components are ready. The second campaign affects 275,614 examples of the 2012-2015 Dodge Journey in the US; plus 78,148 of them in Canada, 36,471 in Mexico, and 151,476 left-hand drive units outside of NAFTA where it's sold as the Fiat Freemont. On these vehicles, water intrusion can disable the anti-lock brakes and electronic stability control, although a warning light often illuminates when this issue occurs, and the problem doesn't affect regular braking. There are also no reports of injuries or accidents. To fix the issue, dealers will seal the ABS wiring harness and will replace any already affected components as necessary, like the ABS module or the headlamp and dashboard wiring harness. Statement: Occupant Restraint Control Modules October 30, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 284,089 older-model SUVs in the U.S. to replace their Occupant Restraint Control (ORC) modules and front and/or side-impact sensors, as required. Within this vehicle population, FCA US became aware of seven injuries caused by inadvertent air-bag deployments and advised NHTSA accordingly. The affected vehicles are not equipped with Takata Corp. air-bags. The Company is unaware of any related accidents.

2016 Jeep Wrangler to ditch solid axles to save weight?

Hey, Jeep fans. If you think the idea of a funky-looking, car-based Cherokee revival is offensive, have a listen to what might be in store for the next-gen Jeep Wrangler. Automotive News is reporting that as Jeep develops the 2016 Wrangler, weight reduction is a crucial target, and the Wrangler's rugged solid axles could be sacrificed in the name of better fuel economy.
We've already heard the next Wrangler will go on a serious diet using aluminum body panels and an air suspension system, so the idea of a four-wheel independent suspension setup for this OG SUV isn't all that surprising. Besides, it's not like an independent suspension would limit the Wrangler's off-road abilities - just check out the Hummer H1. In fact, it might be the aftermarket parts companies - not Wrangler enthusiasts - who would be most disappointed by such a drastic suspension change, as the article states that the Wrangler's solid axles and coil-link suspension make it the most popular SUV for customization.
There are probably still a couple years before we'll start hearing any concrete details about the 2016 Wrangler, at which time it will be interesting to see how stricter fuel economy and crash safety regulations have been balanced with traditional Wrangler cues like its removable doors and roof and folding windshield. Let us know in the comments below if a Wrangler sans solid axles is any less of a Wrangler.

NHTSA investigating why Jeep recall fix is taking so long

Jeep's saga with the National Traffic Safety Administration and the voluntary campaign to repair 1.56 million vehicles for allegedly unsafe trailer hitches, is getting yet another chapter. The controversy appeared to finally be over in January when the automaker found a supplier for the replacement parts. Nothing is ever that easy, though, and the government regulator is now requesting documents from the company to clarify why the repairs are taking so long to begin.
Jeep parent company Chrysler has until July 16 to submit documents and answers to NHTSA explaining the situation. The regulator claims that despite its compromise to inspect and repair the models with improper hitches in June 2013, Chrysler didn't find a part supplier until December and didn't order the replacements until January. The government agency believes that the first components weren't manufactured until May of this year and vehicles may not actually be repaired until as late as August. According to the report, if the Chrysler doesn't supply what NHTSA is asking for, the agency could "take additional appropriate action as warranted."
Throughout this entire process, Chrysler has asserted that the vehicles met the applicable crash test standards of the time, and it has kept NHTSA abreast of the repair activity. In a recently released statement it said that the regulator analyzed eight rear impact reconstruction tests and found the replacement hitch to be safe. To keep up with the high demand for replacements, Chrysler is working with multiple suppliers, and they are running three shifts, six days a week to get the parts ready as soon as possible.