2003 Jeep Liberty Sport Sport Utility 4-door 3.7l on 2040-cars

Auto blog

FCA's Pentastar V6 gets more power, efficiency for 2016

Already a vital member of FCA's powertrain lineup, the 3.6-liter Pentastar V6 is receiving major efficiency improvements for 2016. Thanks to a massive amount of new tech attached to the mill, fuel economy is up six percent, and torque below 3,000 rpm jumps nearly 15 percent. The updates arrive first in the 2016 Jeep Grand Cherokee, but they should proliferate to other models eventually. At least in the Grand Cherokee, the tweaks push power up five horsepower to 295 ponies. FCA's engineers went through the Pentastar from top to bottom to eke out as much efficiency as possible. For example, there's now a two-speed variable-valve lift system that can run in low- or high-lift modes. This upgrade is responsible for 2.7-percent better economy, the company claims. A new intake manifold with longer runners and updated variable-valve times also helps boost the torque output. Further improvements come from pushing the compression ratio to 11.3:1, from 10.2:1 before. Perhaps most impressive is that despite all of the innovations, the latest Pentastar actually weighs four pounds less than the current version. Beyond the Pentastar improvements, all of the FCA US gasoline engines, except for the Viper's 8.4-liter V10, will be E15-compatible for 2016. The company says that it wants to be ready for the higher ethanol content fuel's greater use in the near future.

2014 Easter Jeep Safari kicks off with six concepts

The 2014 Easter Jeep Safari is set to begin this weekend in Moab, Utah, and while it's sure to be a blast for Jeep enthusiasts from all corners of the world, we're looking forward to the wild, off-road ready concepts that Jeep will be bringing to the red rocks. As you can see in our handy headline, there are six such vehicles in total, each of which sports a variety of tweaks and custom bits.
Unlike in years past, where Jeep graced us with some outrageous concepts like the Mighty FC or J-12, this year's vehicles are a bit more restrained and a bit more buildable by enthusiasts. That's not by accident, officials tell us. They wanted to put this year's focus on attainable vehicles and accessories from Mopar and Jeep Performance Parts that existing owners can use to augment their own vehicles. So let's get to it.
We'll start with the Wranglers first. There are three concepts of the jeepiest of Jeep coming to Moab - the Level Red, Maximum Performance and Mojo. The Level Red and the Mojo (seen above) are similar from a suspension and engine standpoint. Both boast a two-inch Jeep Performance Parts lift kit, which officials tell us is coming to market in the next few months. There are a pair of Dana 44 crate axles on both the front and rear, while a Jeep Performance Parts Rock-Trac transfer case has been fitted. The 3.6-liter V6 engines on both Jeeps can breathe a bit easier thanks to a new cold-air intake and exhaust system.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.