2003 Jeep Liberty Limited Sport Utility 4-door 3.7l on 2040-cars

Auto blog

Jeep Liberty under investigation for door fires

The Jeep Liberty has already had plenty of attention for possible fires thanks to the first-gen model's fuel tank, but now the midsize Jeep is under the microscope of the National Highway Traffic Safety Administration for another fire-related concern. NHTSA has opened an investigation for the 2012 Liberty after receiving two reports of electrical fires in the driver's door.
According to the investigation summary, around 80,000 vehicles could potentially be affected by this problem. In both reported fires, the drivers noticed smoke and then flames from the master power window switch, and they had to pull to a stop and exit through the passenger side of the SUV. According to Autoguide, there was one injury to a motorist who suffered burned fingers while trying to open the driver's door.
Interestingly, the Dodge Nitro is not yet involved in this investigation, even though it was still around for the 2012 model year; the Nitro ended production in 2011 about a year before the final Liberty rolled off the line for the 2013 model year. Scroll down for the official NHTSA investigation summary.

Finding surfing spots in the UK is tough work, even in a Jeep

You truly have to love surfing to practice the sport in the United Kingdom. The area isn't exactly teeming with warm beaches full of sunbathers, and absolutely no easy spots to find big waves. To be a UK surfer, you need to be a fearless adventurer, not to mention quite lucky. And driving a Jeep might help, too.
Surfers Oli Adams and Micah Lester are traveling around the British Isles in a Jeep Wrangler Overland trying to find the best surf spots out there. These guys don't fit the laid-back surfer stereotype, but that's because finding waves in the UK is hard work. They say that the waves at some of these spots only exist for about three hours every year when the current and winds are just right.
To find these surf spots, the Jeep's offroad capabilities are paramount. In some areas, as you'll see in the video, there isn't even a beach, just jagged rocks. It would be like the movie Endless Summer, that is, if it could start snowing at any moment. These guys are clearly dedicated to their sport.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.