2002 Jeep Liberty Sport 4x4 * 1 Owner * Flawless!!!! on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Stellantis not looking for further mergers, including with Renault

MILAN — Stellantis Chairman John Elkann on Monday denied the carmaker was hatching merger plans, responding to press speculation about a possible French-led tie-up with rival Renault. Elkann said that the Peugeot owner, the world's third largest carmaker by sales, was focused on the execution of its long-term business plan. "There is no plan under consideration regarding merger operations with other manufacturers," said Elkann, who also heads Exor, the Agnelli family holding company that is the largest single shareholder in Stellantis. After abandoning the Russian market, at the time its second largest after France, and reducing the scope of its global cooperation with Nissan, Renault has been seen as a potential M&A target. Speculation intensified after an electric vehicle market slowdown forced it last week to cancel IPO plans for its EV and software unit Ampere. Its market cap remains stubbornly low at little over 10 billion euros ($10.8 billion) despite a financial recovery over the past few years. Stellantis, the product of a 2021 merger between France's PSA and Fiat Chrysler and one of the most profitable groups in the industry, has a market cap of more than 85 billion euros when unlisted shares are factored in. It has a 14 brand portfolio also including Citroen, Jeep, Opel and Alfa Romeo. NEWSPAPER REPORT Italian daily Il Messaggero had said on Sunday that the French government, which is Renault's largest shareholder and also has a stake in Stellantis, was studying plans for a merger between the two groups. A spokeswoman for Renault said on Monday the group did not comment on rumors. France's Finance Ministry had declined to comment on Sunday. Stellantis has crossed swords with the Italian government, which has accused it of acting against the national interest on occasions. Industry Minister Adolfo Urso last week raised the prospect of the Italian government taking a stake in Stellantis to help to balance the French influence. Renault shares pared gains after Elkann's comments to stand 1.2% higher by 1220 GMT, having initially risen more than 4%. Stellantis CEO Carlos Tavares, a Portuguese-national, last week said in an interview with Bloomberg that the group was "ready for any kind of consolidation" and that its job was to make sure that it would be "one of the winners". Analysts, however, question the rationale of a Stellantis-Renault merger, which would also expand the group's excess capacity in Europe.

Baby Jeep to join Renegade in FCA's plan for new Italian-built models

FCA is boosting its European production, introducing new models that will be built in currently under-utilized manufacturing facilities. Among the new models is a new small Jeep, smaller than the current Renegade, as Automotive News reports. FCA's Mike Manley mentioned the entry-level Jeep model earlier this year, also saying that the vehicle is targeted to European and possibly Latin American customers; in the summer, Autocar placed the launch date in 2022. The new "baby" Jeep would be made in the same factory in Pomigliano, Italy, as the small Fiat Panda, which is a top seller in Italy. The current generation Panda was introduced in 2011; if it gets a replacement in 2022, it could possibly share a platform with the Jeep model — or, the Jeep could be an eventual outright replacement for the Panda. One of Fiat's earlier core products, the Punto hatchback, was canned in August, and that production capacity will be used to make the Jeep Compass instead, at the Renegade-producing Melfi factory in southern Italy. The Compass has not previously been built in Europe. The Fiat model portfolio would be shrunk to just the 500 model family and the Panda — the 500 would also be FCA's key electric vehicle offered in Europe. It is not yet clear whether the electric 500 would be made in Turin, Italy, or in Poland; Turin might also get a Giardiniera-badged wagon version of the refreshed 500. As for the Alfa Romeo brand, it is set to gain an even bigger SUV model than the Stelvio, based on the Maserati Levante's platform. The Levante's sales have suffered recently in China, but Maserati does have light in the horizon: The Alfieri 2+2 grand tourer is still in the cards, with a launch expected for 2020 and both a convertible and an electrified version planned to follow. The Alfieri would be made in Modena, Italy, according to Automotive News' sources. None of these plans namedrop the storied Lancia brand, which has been shrunk to just the Ypsilon hatchback, based on the same platform as the current 500 and Panda. Despite that, the Ypsilon was again the second-bestselling car in Italy after the Panda in October. It is unlikely that FCA will be able to ignore this, but it is just as unlikely that any development money will be afforded to come up with a replacement for the Ypsilon, which is as similarly old as the Panda. Perhaps official announcements expected on Thursday will also clarify what will happen to Lancia.