2024 Jeep Gladiator Rubicon 4x4 on 2040-cars

Auto blog

Jeep Grand Cherokee, Dodge Durango still catching fire after recall

Automakers issue recalls all the time. It's part of the cost of doing business. We just assume that once the recall has been carried out, the problem in question has been fixed. But that's not always the case, as this latest investigation being undertaken by the National Highway Traffic Safety Administration goes to show. The problem stems back to a recall issued by Chrysler last summer. It revolved rather the sun visor in the SUVs it makes at its Jefferson North Assembly Plant – specifically, the screw affixing the sun visor could end up rubbing against the wiring for the lamp in the vanity mirror, potentially causing an electrical short and even a fire. 62 such short circuits, 38 fires and three injuries reported, prompting Chrysler to recall nearly 900,000 units of the 2011-2014 Jeep Grand Cherokee and Dodge Durango (over 650,000 of them in the United States). The plastic spacers they installed to rectify the problem, however, may not have done the trick. Eight reports (but none involving injuries) have been filed with the NHTSA regarding the same issue recurring, spurring the government agency to open a new investigation into the matter. If deemed necessary, the NHTSA could ask FCA to issue another recall to fix the issue again, which we may necessitate the installation of a fuze to prevent any such the electric short. Related Video: INVESTIGATION Subject : Headliner Fires Date Investigation Opened: MAY 01, 2015 Date Investigation Closed: Open NHTSA Action Number: RQ15003 Component(s): ELECTRICAL SYSTEM , INTERIOR LIGHTING Manufacturer: Chrysler (FCA US LLC) SUMMARY: On July 1st, 2014 Chrysler (FCA US LLC) issued safety recall 14V-391 to remedy a wiring-related fire hazard on the headliner of approximately 661,888 model year (MY) 2011-2014 Jeep Grand Cherokee and Dodge Durango vehicles manufactured between January 5, 2010 and December 11, 2013. The recall was in response to the Office of Defects Investigation (ODI) investigation EA14-001 during which data provided by Chrysler indicates that the fire is caused by an electrical short in the vanity lamp wiring for either one of the sun visors mounted on the vehicle. The sun visors are mounted to the roof of the vehicle through the headliner with three metal screws.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Maserati Levante crossover not Jeep based after all?

Maserati has been teasing its crossover project since 2011, which is when it first showed off the Kubang concept (pictured above). Still, the production version, rumored to be called the Levante, remains a complete mystery. The CUV was first rumored to borrow the platform from the Jeep Grand Cherokee, but new rumors indicate that the Italian, luxury crossover might actually take the underpinnings from the Quattroporte and Ghibli.
In a brief interview, Maserati CEO Harald Wester told CNN Money that the Levante wouldn't use Jeep's platform. Motor Trend spoke with an unnamed Maserati engineer who confirmed the rumor. Officially, the company says that no decision has been made.
We can add this to another long list of rumors about the Italian CUV. It was originally supposed to be built at Chrysler's Jefferson North assembly plant in Detroit. Then, plans were changed to build it in Italy.