1984 Jeep Cj-7 Laredo All Original 57k 4-spd on 2040-cars

Auto blog

Chrysler recalling over 200k vehicles across its brands

With more than 200,000 units across six separate recalls and almost all of its brands, it appears that Chrysler has officially jumped headfirst into the recall pool this month. The National Highway Traffic Safety Administration has issued three official recalls for the automaker, and The Detroit News is reporting that the automaker itself has announced three more.
The biggest of the recalls applies to about 120,000 Dodge Charger, Dodge Challenger and Chrysler 300 models for 2011 and 2012 due to faulty wiring harnesses for the seat-mounted side airbags, which could lead to these airbags not deploying in the event of a crash. A little more than 60,000 two-wheel-drive versions of the 2007-2008 Dodge Nitro and 2008 Jeep Liberty SUVs are being recalled due to a heat shield that could cause the driveshaft to break, which if that isn't bad on its own, could then hit underneath where the airbag sensor is mounted, causing the airbags to deploy. Wrapping up NHTSA's recall notices, about 20,000 Jeep Patriot and Jeep Compass models for 2012 are also being recalled due to a problem with the fuel tank transfer tube that could lead to the vehicle stalling. The LX car recall campaign is going into effect this month, while the other two will start next month - all three notices are posted below.
In addition to the official NHTSA recalls, The Detroit News is also reporting that Chrysler is recalling more than 16,000 Ram trucks and a small number of Dodge Dart sedans. Around 6,500 2013 Ram 1500 trucks will be recalled due to an improper adjustment of the parking brake cable from the factory, while 7,000 Cummins-powered 2013 Ram Heavy Duty trucks are being recalled due to an engine cover that does not have as much heat resistance as it is supposed to. Finally, a total of 46 Dodge Dart sedans are being recalled due to a problem with the brake calipers and/or parking brake.

Chrysler to accelerate production of 2013 Ram and V6 engines

Chrysler is adding a third shift at its Warren Truck plant to meet demand for the new 2013 Ram pickup. And with tight supplies of its Pentastar V6, the company is also boosting output at its Mack Engine plant.
The expansions will add 1,250 jobs and are part of a $238 million investment by Chrysler in the Detroit area. Warren's third shift will begin work sometime in the spring, a Chrysler rep told Automotive News. Mack's increased Pentastar production a could include both 3.6 and 3.2-liter engines.
The company says it also plans to invest $40 million in its Trenton Engine plant to allow for production of a 3.2-liter V6 as well as the Tigershark inline-four for the upcoming Jeep Liberty replacement.

Chrysler axes old V6s, goes all-Pentastar

Old technology has a way of lingering on, particularly at Chrysler headquarters in Auburn Hills. So while the Pentastar V6 has replaced the older engine architecture in just about every application, it still soldiered on in some export markets. But the introduction of a new 3.0-liter Pentastar V6, produced in Michigan and meant only for the Chinese market, has put the final nail in the old engine's coffin.
Fitted into the 2014 Jeep Grand Cherokee and Jeep Wrangler just introduced to China at the Chengdu Motor Show, the downsized six uses the same architecture as the larger 3.6-liter Pentastar V6. But because of its 2,997cc capacity, it can be exported to China without the increased duty the 3.6-liter or even 3.2-liter Pentastar engines would incur. The 3.0-liter V6 develops 230 horsepower at 6,350 rpm and 210 pound-feet at 4,400 rpm.
Admittedly, it's unlikely, but even though the engine was said to be created solely to undercut tax thresholds in China and Europe, the 3.0-liter Pentastar has recently surfaced in rumors of an application here: as the boosted heart of a potential Cherokee SRT with anywhere from 375 to 410 hp.