1974 Jeep Cj5 4x4, 304 V8, 3 Speed Manual Transmission Excellent on 2040-cars

Auto blog

AEV Jeep Wrangler Unlimited Rubicon

After their rented 2007 Hummer H3 failed them during the brutal Rallye Aicha des Gazelles in Morocco, Amy Lerner and her sister Tricia Reina were on a quest to find the most capable production off-roader for their next competition - they chose a 2012 Jeep Wrangler Unlimited Rubicon. Their next mission was to find a company with the competence to configure it to win. After poring over Internet forums and perusing countless magazines for an outfitter who could meet their demanding requirements, they sent their bright orange JK ("Crush" is the official color) to American Expedition Vehicles (AEV) for some modifications.
The Michigan-based team at AEV kept the Jeep's 3.6-liter V6 and automatic transmission stock, but replaced the hood with a tall AEV Heat Reduction Hood and added an AEV Snorkel Kit for water crossings (it serves double-duty as its raised height helps to keep the air intake out of the kicked-up dust on the trail). Front and rear off-road bumpers were bolted in place, and AEV skid plates were added to provide additional undercarriage protection. A pair of IPF-900 off-road lights improve visibility, while a 10.2-gallon AEV Fuel Caddy (located behind the exterior spare) added some range. The suspension was upgraded with a 3.5-inch lift kit with Bilstein remote reservoir shocks, and 35-inch Falken Wildpeak A/T tires (LT285/70R17) were mounted at all four corners on AEV's beadlock wheels.

Watch this Jeep Willys return to its birthplace after 70 years

Earlier this month, a very significant Jeep was celebrated at the Toledo North Assembly plant. No, it wasn't the upcoming reincarnation of the Jeep Cherokee, but instead it was a 1943 Willys MB that visited the Toledo grounds where it had been built exactly 70 years ago to the day.
Of course, the actual building where the MBs rolled off the assembly line before heading to Europe for World War II no longer exists, but that didn't stop Italian owner Vittorio Argento from having the vehicle shipped to the US to make its trek back to its birth place. According to Chrysler, Argento's MB is still 95-percent original and it drove 1,000 miles from New Jersey to Toledo.
The whole adventure was chronicled on a blog aptly named A Jeep Comes Home. Scroll down for a brief video from Chrysler and for some photos of the Toledo visit and be sure to read more at Argento's blog.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.