2009 Jaguar Xf Premium Luxury Salvage Repairable Rebuilder Only 26k Miles!!! on 2040-cars

Auto blog

Rising aluminum costs cut into Ford's profit

When Ford reports fourth-quarter results on Wednesday afternoon, it is expected to fret that rising metals costs have cut into profits, even as rivals say they have the problem under control. Aluminum prices have risen 20 percent in the last year and nearly 11 percent since Dec. 11. Steel prices have risen just over 9 percent in the last year. Ford uses more aluminum in its vehicles than its rivals. Aluminum is lighter but far more expensive than steel, closing at $2,229 per tonne on Tuesday. U.S. steel futures closed at $677 per ton (0.91 metric tonnes). Republican U.S. President Donald Trump's administration is weighing whether to impose tariffs on imported steel and aluminum, which could push prices even higher. Ford gave a disappointing earnings estimate for 2017 and 2018 last week, saying the higher costs for steel, aluminum and other metals, as well as currency volatility, could cost the company $1.6 billion in 2018. Ford shares took a dive after the announcement. Ford Chief Financial Officer Bob Shanks told analysts at a conference in Detroit last week that while the company benefited from low commodity prices in 2016, rising steel prices were now the main cause of higher costs, followed by aluminum. Shanks said the automaker at times relies on foreign currencies as a "natural hedge" for some commodities but those are now going in the opposite direction, so they are not working. A Ford spokesman added that the automaker also uses a mix of contracts, hedges and indexed buying. Industry analysts point to the spike in aluminum versus steel prices as a plausible reason for Ford's problems, especially since it uses far more of the expensive metal than other major automakers. "When you look at Ford in the context of the other automakers, aluminum drives a lot of their volume and I think that is the cause" of their rising costs, said Jeff Schuster, senior vice president of forecasting at auto consultancy LMC Automotive. Other major automakers say rising commodity costs are not much of a problem. At last week's Detroit auto show, Fiat Chrysler Automobiles NV's Chief Executive Officer Sergio Marchionne reiterated its earnings guidance for 2018 and held forth on a number of topics, but did not mention metals prices. General Motors Co gave a well-received profit outlook last week and did not mention the subject. "We view changes in raw material costs as something that is manageable," a GM spokesman said in an email.

Audi and Jaguar Land Rover recalls address seatbelt issues

Audi and Jaguar Land Rover are each recalling several thousand vehicles for separate potential seatbelt issues. The recalls cover the 2022 Audi A3 and S3; 2022 Jaguar F-Type, F-Pace and XF; and the 2022-23 Land Rover Defender, Discovery, Discovery Sport, Range Rover Sport and Range Rover Velar. Examples of these vehicles may have shipped with seatbelt pretensioners that will not function properly in the event of an accident.  Audi is recalling its sedans for tensioner devices that may not adequately restrain drivers or passengers during a crash. The issue was discovered during Korean market crash testing of the high-performance RS 3.  "The seat belt tensioner in the affected vehicles serve the purpose of holding the passenger in his position in the seat," Audi said in its defect report to NHTSA. "In the event of a crash, the retention force of the seat belt may not reach the intended level. As a result, the position of the body can be further to the front of the seat, which leads to a negative influence on the whole restraint system, increasing the risk of injury." A different company, Jaguar Land Rover (JLR), meanwhile, also has an issue with a batch of pretensioners installed in its cars and SUVs. Pretensioners are the devices that fire off to rapidly retract the seatbelt when a crash is detected. Most utilize an explosive charge and pressure tube JLR says that some pretensioner devices provided by one of its suppliers may not have properly-specified pressure tubes that may not channel the gasses to the retraction mechanism correctly.  "A damaged front seat belt pretensioner tube may have been installed on the seat belt retractor," JLR's report said. "This may result in a reduced level or complete loss of pre-tensioning in the event of a crash and increased occupant injury." Owners of the models included in both recall campaigns should receive notices from the manufacturers in the coming months.  Related video: Recalls Audi Jaguar Land Rover Ownership Safety SUV Sedan

Watch Felipe Massa put the Jaguar C-X75 through its paces

Automakers who run their own racing teams enjoy the benefit of having top-flight professional racing drivers on call to help out with development work. Jaguar, unfortunately, has no such racing team, having sold its F1 operation to Red Bull back in 2004. So when it came time to put the C-X75 through its paces in this latest video, it turned to Felipe Massa. Why Massa, you ask? For one thing, having driven for so long for Ferrari, the Brazilian driver is used to applying his F1 skills in testing a supercar designed for the road. But since switching to Williams, he hasn't been called upon in that capacity. For another, it was Williams Advanced Engineering as much as Jaguar itself that spearheaded development of the C-X75. So Massa was the natural choice. The C-X75, for those who don't recall, represented Jaguar's plan to build a hybrid hypercar of its own. Having debuted way back in 2010 at the Paris Motor Show, the concept followed hot on the heels of the Porsche 918 concept unveiled earlier that year in Geneva – a predated by far the emergence of the McLaren P1 and LaFerrari. The original design called for a revolutionary powertrain combining a pair of micro-turbines and four individual electric motors in the wheels. When that proved unfeasible, Jaguar switched to a more conventional setup with a turbocharged hybrid powertrain. Unfortunately plans to put even that version into production were shelved. But the concept was revived for the filming of the latest James Bond movie Spectre. Check out the C-X75 being put through its paces by the eleven-time grand prix winner in the video above. Related Video: