2004 Isuzu Rodeo No Reserve Auction on 2040-cars

Auto blog

Junkyard Gem: 1994 Isuzu Rodeo 4WD

After a decade in which Isuzu-built Chevrolet LUV pickups, Isuzu-engined Chevrolet Chevettes and Isuzu Geminis with confusing "Opel by Isuzu" or "Buick/Opel Isuzu" badges, Isuzu finally began selling Americans its vehicles with Isuzu badging in the early 1980s. There were Isuzu cars, sure, but the P'up pickup and (starting in 1984) the Trooper SUV showed that Isuzu was likely to rake in the most yen by selling trucks on this side of the Pacific. The three-door convertible Amigo appeared here in 1989, but it was a little too small and silly to sell much among the suburban-commuter set. For the 1991 model year, a five-door Amigo sibling showed up: the Rodeo. The early Rodeo is getting quite rare today, but I was able to find this fairly clean '94 in a Denver-area self-service yard a few months back. These trucks, which were based on the same chassis as the P'up (known as the Isuzu Pickup after 1987) sold well in Colorado. You could get the first-generation Rodeo with rear-wheel-drive, but the four-wheel-drive version made more sense if you wanted to slog through snow and mud in the Rockies (or just feel safe when crossing a parking lot dusted with the white stuff). This truck has true four-wheel-drive, not what eventually became known as all-wheel-drive, but at least the higher trim levels had automatic locking hubs instead of the manual sort that forced you to stop and kneel in the mud to switch. Americans loved automatic transmissions nearly as much in 1994 as we do today, but they cost a lot more relative to manuals back then. This truck has a five-speed manual. The MSRP on this truck was $19,249, or about $39,075 in 2022 dollars. If you wanted it with an automatic transmission, the price went up to $20,349 ($41,310 today). The air conditioning in this one cost an additional 850 bucks (1,725 bucks now). The engine is an Isuzu 3.2-liter V6, rated at 175 horsepower. This truck was built at Subaru-Isuzu Automotive in Indiana; Subaru eventually bought out Isuzu's share of the joint venture and now only Subaru models are built there. Just to add another manufacturer to the mix, Honda sold rebadged Rodeos with Passport badges (and rebadged Troopers as Acura SLXs). This one was well-cared-for, looking clean for a machine with close to 200,000 miles on the clock. We can assume that some costly mechanical ailment finally sent it to this, its final parking place.

16 things I learned about the Isuzu VehiCROSS

There are plenty of cars I remember existing, but actually know very little about due to the passage of time or just not particularly caring when they were new. Take the Isuzu VehiCROSS, which I fondly recall as this wackadoo off-roader from the late 1990s and early 2000s. But honestly, that's about it. So, since I've got a little extra time kicking about, I decided to fall into the rabbit hole labeled Isuzu VehiCROSS for an hour to see how much I could find out about this SUV (or "sport/utility" in 1999 parlance) that shared labeling with the watch I wore in 1999. Enjoy. 1) The VehiCROSS was not based on the Rodeo, as I always assumed, but rather the Trooper RS. Oh, so that bigger, boxier Isuzu they turned into an Acura? No, no, no. The RS was the two-door Trooper, and specifically the second-generation two-door Trooper, which I just discovered was a thing. And what a gawky, dorky, that-has-to-be-Photoshopped thing it was. Apparently, the Trooper RS was sold in the United States from 1993 to 1995, and in very small numbers. That is not surprising. 2) It was probably obvious, but the VehiCROSS was based on a concept car. Specifically, a concept car shown at the 1993 Tokyo auto show.  3) The quick turnaround from concept to its Japanese market introduction for 1997 was the result of some innovative manufacturing methods at the time (it arrived in the United States in 1999). According to the Motor Trend first drive, "There would be no time-consuming clinics, no 'courtroom drama' with the finance department, and to oversee the project, a 'Zip Team' consisting of 15-20 members was given the task of developing the vehicle in about half the normal time." Among its accomplishments, the team came up with a way to more quickly and cheaply produce the VehiCROSS' unique body pieces. Again according to Motor Trend, Isuzu used carbon stamping dies inside of the conventional cast iron dies. Though the carbon could be used far fewer times and result in a reduced overall capacity, they cost one-third to one-half as much and could be made in about six weeks – the cast iron ones would take four months and run about $1.5 million in 1990s dollars. Isuzu estimated they'd only be able to produce 2,400 VehiCROSSes per year until the carbon dies wore out. Then that would be it. According to sales data on Wikipedia, Isuzu managed to sell 2,005 in the U.S. alone in year 1 and 4,153 in total. In Japan, there were 1,805 sold in total.

Cummins and Isuzu to collaborate on prototype electric truck

Cummins, the company known best for its diesel engines, just announced a partnership with Isuzu to “create a prototype medium-duty, battery electric truck” for North America. Exploration of electric powertrains isnÂ’t totally new for Cummins, as itÂ’s talked about a transition to electric since 2017. In fact, Cummins even revealed a battery-powered truck back then, too. This electric truck with Isuzu is new, though, and itÂ’s going to put the Cummins PowerDrive6000 powertrain into IsuzuÂ’s F-Series truck that you can see in the photo above. Cummins does not detail specs for its PowerDrive6000, but weÂ’ve seen the drive unit used in a hybrid concept from Cummins previously. It provided 50 miles of electric range when the battery pack in that truck was full, but with this being a full battery electric vehicle, we suspect that Cummins and Isuzu are using a much larger battery pack for more range. We donÂ’t have any vital specs like range or power, but we suspect those will come at a later date. This year will see Isuzu and Cummins put the truck through a pilot and demonstration phase in North American fleets. After thatÂ’s been completed — assuming it is successful — the partnership could see Isuzu and Cummins collaborate on building battery electric trucks for commercial use here in North America. “We are excited to be working with Isuzu to accelerate decarbonization within the partnership,” said Amy Davis, Vice President and President of New Power at Cummins. “ItÂ’s through our joint commitment in innovation that we provide our customers with safe, reliable zero-emissions solutions.” Related video: