2001 Infiniti Qx4 Sport Utility 4-door 3.5l With Remote Start on 2040-cars

Auto blog

Race Recap: 2015 Canadian F1 Grand Prix is better behind the front

As of Saturday afternoon in Montreal, Canada, it was all about the number four. Lewis Hamilton put his Mercedes-AMG Petronas on pole position for the fourth time at the Circuit Gilles Villeneuve, and now his tally of pole positions matches his race number: 44. Nico Rosberg lines up beside him, which is the fourth time that particular one-two combo has occurred this season. Ferrari spent three engine development tokens to try and close the gap to Mercedes, Kimi Raikkonen making the most of it with third position on the gird. His teammate Sebastian Vettel got the worst of it, however, when the MGU-K unit failed during Q1, leaving him 160 horsepower down and out at the first hurdle. Valtteri Bottas put a revitalized Williams on the grid at fourth, ahead of a Lotus lockout of the third row with Romain Grosjean leading the way in fifth, Pastor Maldonado just beside. Nico Hulkenberg got the first Sahara Force India into seventh – the team is still waiting on the upgraded B car that should be available for Austria – ahead of Daniil Kvyat in the first Infiniti Red Bull Racing and a "pissed off" Daniel Ricciardo in the second Red Bull. Sergio Perez made it two Force Indias in the top ten, a welcome result from a team performing below expectations of late. When the lights went out, at the very front it was much ado about not that much at all. Hamilton got away clean and stabbed across the track to close the door for Rosberg, giving Raikkonen a chance to take the inside line into Turn 1 in an attempt to clear Rosberg for second place. That didn't happen, leaving the two Mercedes' to run in grid position for the entire race. It wasn't boring – Rosberg stayed close, rubber-banding the time gap to the leader from a little more than one second to just under four seconds, and Montreal is famous for race-rearranging safety cars and on-track incidents. But none of those occurred, so Hamilton crossed the line 2.285 seconds ahead of Rosberg after 70 laps to earn his fourth victory in Canada and the first-ever victory for the Brackley, UK-based Mercedes team. Valtteri Bottas drove his Williams to third position, the first podium place for the team this year and a welcome salve to heal the team's wounds from a poor showing in Monaco. That placing came courtesy of being in the right place at the right time, which was not far behind Raikkonen when the Ferrari driver spun at the hairpin on Lap 28 after his first pit stop.

Infiniti-Red Bull Racing will seek a fourth title with the RB9 [w/video]

This is the car and the team that everyone wants to dethrone. The stability of this year's regulations means that the Infiniti Red Bull RB9 is a seriously honed RB8; however, that's a situation probably no other team would complain about seeing that the RB8 recovered from early stumbles and reliability issues last year to carry Sebastian Vettel to a third consecutive driver's title and the team to a third consecutive constructor's trophy.
The most noteworthy revisions to the car are the partial vanity panel that omits the driver cooling slot, the even narrower rear end - a feature of just about every car launched so far - and purple sidepods to showcase new title sponsor Infiniti. Adrian Newey, perhaps the most feared designer on the pit lane, said the nose and front wing could be changed relatively easily throughout the season, but he wanted to make sure to get the middle of the car - everything from the sidepods, back - as good as possible since they're more difficult to re-engineer. His track record leads us to believe he did just that.
Below are two videos, one of the making of the RB9, the other the launch at team headquarters in Milton Keynes.

Infiniti Prototype 9 is a wonderfully beautiful EV grand prix car

Few automobiles are as elegantly beautiful as the open-wheel grand prix cars of the 1940s, '50s and '60s. The simple, slender shapes of these cars bear no extravagant flourishes or adornments. The purposeful design is what gave these cars their beauty, and it's these classic machines that inspired the new Infiniti Prototype 9. Teased earlier this week, this concept blends old and new, with classic lines hiding a modern all-electric powertrain. The Prototype 9 will make its full debut next week at the 2017 Pebble Beach Concours d'Elegance. Infiniti says the car was built around a simple idea: what would a 1940s Infiniti grand prix car look like? While the silver paint may be more German than Japanese, the design could easily be mistaken for an actual '40s grand prix car. Only the Infiniti-styled grille gives it away. Everything about it, from the thin bias-ply tires wrapped over center-locking wire wheels to the bulging screws around the driver's seat, is pitch perfect. Underneath that achingly long hood rests a prototype electric motor and battery from Nissan's Advanced Powertrain Department. The combo sends 148 horsepower and 236 pound-feet of torque straight to the rear wheels. That's good enough to send the svelte 1,962 lb car to 62 mph in just 5.5 seconds. Top speed is right at 106 mph. While speed may die off towards the top end, all that torque and a 43/57 front to rear weight distribution should make the Prototype 9 a riot on a small, tight circuit. There's only enough juice in the battery for about 20 minutes of flat-out racing. The handmade steel body rests on a steel ladder-frame chassis. The front suspension uses a leading-arm rigid axle with transverse leaf spring while the rear uses a De Dion axle, also with a transverse leaf spring. The Prototype 9 also uses old-school hydraulic rotary type dampers. There's no power steering and no brake booster for the four-wheel disc brakes. The car was designed and built by a number of different departments within Infiniti and Nissan. A simple sketch expanded as more and more designers and engineers wanted to have a hand in the project. The steel body panels were all shaped and hammered by hand. The bare cockpit is only adorned with a thin seat, three gauges, a few switches, a gear selector and the steering wheel. The gauges are set into a fixed aluminum hub in the center of the steering wheel.