2011 Infiniti M37 Base on 2040-cars

Auto blog

Infiniti Prototype 9 is a wonderfully beautiful EV grand prix car

Few automobiles are as elegantly beautiful as the open-wheel grand prix cars of the 1940s, '50s and '60s. The simple, slender shapes of these cars bear no extravagant flourishes or adornments. The purposeful design is what gave these cars their beauty, and it's these classic machines that inspired the new Infiniti Prototype 9. Teased earlier this week, this concept blends old and new, with classic lines hiding a modern all-electric powertrain. The Prototype 9 will make its full debut next week at the 2017 Pebble Beach Concours d'Elegance. Infiniti says the car was built around a simple idea: what would a 1940s Infiniti grand prix car look like? While the silver paint may be more German than Japanese, the design could easily be mistaken for an actual '40s grand prix car. Only the Infiniti-styled grille gives it away. Everything about it, from the thin bias-ply tires wrapped over center-locking wire wheels to the bulging screws around the driver's seat, is pitch perfect. Underneath that achingly long hood rests a prototype electric motor and battery from Nissan's Advanced Powertrain Department. The combo sends 148 horsepower and 236 pound-feet of torque straight to the rear wheels. That's good enough to send the svelte 1,962 lb car to 62 mph in just 5.5 seconds. Top speed is right at 106 mph. While speed may die off towards the top end, all that torque and a 43/57 front to rear weight distribution should make the Prototype 9 a riot on a small, tight circuit. There's only enough juice in the battery for about 20 minutes of flat-out racing. The handmade steel body rests on a steel ladder-frame chassis. The front suspension uses a leading-arm rigid axle with transverse leaf spring while the rear uses a De Dion axle, also with a transverse leaf spring. The Prototype 9 also uses old-school hydraulic rotary type dampers. There's no power steering and no brake booster for the four-wheel disc brakes. The car was designed and built by a number of different departments within Infiniti and Nissan. A simple sketch expanded as more and more designers and engineers wanted to have a hand in the project. The steel body panels were all shaped and hammered by hand. The bare cockpit is only adorned with a thin seat, three gauges, a few switches, a gear selector and the steering wheel. The gauges are set into a fixed aluminum hub in the center of the steering wheel.

Infiniti SUV recall marks latest chapter in Takata airbag saga

Automotive parts maker Takata is having a rough year with millions of vehicles equipped with its airbag inflators being recalled. However, it looks like there might still be problems with the company's quality control, if a new recall by Infiniti is any indication.
The Japanese luxury brand is recalling 1,912 total units of the 2013 Infiniti QX56 and 2014 QX80 in North America because of a manufacturing flaw with their Takata-supplied inflators for the driver's side front airbag. Of those, 1,848 are in the United States, according to the National Highway Traffic Safety Administration. Specifically, the outer baffle could be the wrong component and cause too much pressure to build up inside. According to documents submitted to NHTSA, it's possible in a crash for the part to rupture spraying metal shrapnel at occupants. At this time, Infiniti has not had any reports of this actually happening to drivers.
While this problem sounds nearly identical to the issue affecting millions of earlier vehicles, it must be noted that this is a different fault. According to the notice being sent to dealers on NHTSA's website: "This particular Voluntary Safety Recall Campaign is unrelated to two earlier campaigns that involved Takata passenger front air bag inflators on some older model Infiniti vehicles. This issue involves a much newer inflator and is a different, more isolated, Takata quality control issue."

Infiniti takes to Facebook to explain model names, mentions 550-hp flagship

Infiniti caused quite a stir this week when it announced that it would be changing its vehicle names so that all of its cars start with Q and all of its crossovers and SUVs start with QX. Many displeased fans and owners took to social media to voice their opinions, and Johan de Nysschen, the new Infiniti boss, responded today with a Facebook post of his own.
In the note, de Nysschen talks about the challenge of product expansions with alphanumeric names that allow for flexibility without encroaching on the trademarked names of other automakers, although we're sure de Nysschen's former colleagues at Audi aren't looking forward to a Q30 or Q50. He also says that as Infiniti grows to become a global brand, the new naming structure - which closely mimics Volvo - is also designed to reduce confusion (just don't tell that to current owners). One thing that de Nysschen assured wouldn't happen is a confusing "X" added to the end of all-wheel-drive model names that would result in names like the Q60X or, even worse, the QX50X.
While we are not looking forward to relearning Infiniti's product lineup, de Nysschen has given us something to look forward to courtesy of a new performance sedan. From the brief explanation of this car, which was used as a key example in explaining the validity of the new names, we learned that the new model will be a performance version of what is now the M sedan, and it will be powered by a "charged induction" 3.0-liter V6 producing more than 550 horsepower. The M's name will become the Q70, but as of right now, it isn't clear if this will be an IPL model or something else.