2009 Infiniti Journey Sport Luxury Sedan Premium Warranty Low Miles One Owner on 2040-cars

Auto blog

2019 Infiniti QX50

The 2019 Infiniti QX50 has arrived. All new engine and a whole lot of new technology.

Infiniti Prototype 9 is a wonderfully beautiful EV grand prix car

Few automobiles are as elegantly beautiful as the open-wheel grand prix cars of the 1940s, '50s and '60s. The simple, slender shapes of these cars bear no extravagant flourishes or adornments. The purposeful design is what gave these cars their beauty, and it's these classic machines that inspired the new Infiniti Prototype 9. Teased earlier this week, this concept blends old and new, with classic lines hiding a modern all-electric powertrain. The Prototype 9 will make its full debut next week at the 2017 Pebble Beach Concours d'Elegance. Infiniti says the car was built around a simple idea: what would a 1940s Infiniti grand prix car look like? While the silver paint may be more German than Japanese, the design could easily be mistaken for an actual '40s grand prix car. Only the Infiniti-styled grille gives it away. Everything about it, from the thin bias-ply tires wrapped over center-locking wire wheels to the bulging screws around the driver's seat, is pitch perfect. Underneath that achingly long hood rests a prototype electric motor and battery from Nissan's Advanced Powertrain Department. The combo sends 148 horsepower and 236 pound-feet of torque straight to the rear wheels. That's good enough to send the svelte 1,962 lb car to 62 mph in just 5.5 seconds. Top speed is right at 106 mph. While speed may die off towards the top end, all that torque and a 43/57 front to rear weight distribution should make the Prototype 9 a riot on a small, tight circuit. There's only enough juice in the battery for about 20 minutes of flat-out racing. The handmade steel body rests on a steel ladder-frame chassis. The front suspension uses a leading-arm rigid axle with transverse leaf spring while the rear uses a De Dion axle, also with a transverse leaf spring. The Prototype 9 also uses old-school hydraulic rotary type dampers. There's no power steering and no brake booster for the four-wheel disc brakes. The car was designed and built by a number of different departments within Infiniti and Nissan. A simple sketch expanded as more and more designers and engineers wanted to have a hand in the project. The steel body panels were all shaped and hammered by hand. The bare cockpit is only adorned with a thin seat, three gauges, a few switches, a gear selector and the steering wheel. The gauges are set into a fixed aluminum hub in the center of the steering wheel.

Nissan recalling GT-R, Infiniti crossovers over steering column issue

Nissan has discovered a problem with the steering column on some of its higher-end all-wheel-drive vehicles from a few years back, and has issued a recall in conjunction with the National Highway Traffic Safety Administration to address the issue. The issue revolves around the outer tube on the steering column, which may not be perfectly round. That would put extra stress on the upper steering bearing, which could cause it to fracture, disabling the car's steering ability and potentially leading to a crash. The problem affects Nissan's flagship GT-R supercar – specifically 2009 models manufactured between March 14, 2007, and April 25, 2008) as well as an array of Infiniti crossovers: namely the 2008 EX35 and the 2008-09 FX35 and FX45. In the case of the luxury crossovers, Infiniti dealers are being instructed to replace just the steering shaft, but Nissan dealers will have to replace the entire steering column assembly on the GT-R. All told, the recall is estimated to encompass 16,973 vehicles across the United States. RECALL Subject : Steering Column Tube may be Out of Round Report Receipt Date: FEB 02, 2015 NHTSA Campaign Number: 15V054000 Component(s): STEERING Potential Number of Units Affected: 16,973 Manufacturer: Nissan North America, Inc. SUMMARY: Nissan North America, Inc. (Nissan) is recalling certain model year 2008 Infiniti EX35 vehicles manufactured June 29, 2007, to April 25, 2008, 2009 Infiniti FX35 and FX45 vehicles manufactured October 31, 2007, to April 16, 2008, and 2009 Nissan GT-R vehicles manufactured March 14, 2007, to April 25, 2008. The steering column outer tube may not be round, resulting in extra stress being applied to the upper steering bearing. This stress may cause the bearing retainer to fracture, creating extra play in the steering wheel or a possible loss of steering. CONSEQUENCE: Extra play in the steering wheel or a loss of steering may increase the risk of a crash. REMEDY: Nissan will notify owners, and dealers will replace the steering shaft on the Infiniti EX35, FX35, and FX45 vehicles, and will replace the steering column assembly on the Nissan GT-R vehicles, free of charge. The manufacturer has not yet provided a notification schedule. Infiniti owners may contact customer service at 1-800-662-6200. Nissan owners may contact the GT-R hotline at 1-866-668-1487.