Find or Sell Used Cars, Trucks, and SUVs in USA

1990 Honda Crx Si Coupe 2-door 1.6l All Stock Not Modified on 2040-cars

Year:1990 Mileage:124920 Color: Black /
 Black
Location:

Lindenhurst, New York, United States

Lindenhurst, New York, United States
Advertising:
Transmission:Manual
Body Type:Coupe
Engine:1.6L 1590CC 97Cu. In. l4 GAS SOHC Naturally Aspirated
Vehicle Title:Clear
Fuel Type:GAS
For Sale By:Private Seller
VIN: JHMED9360LS012154 Year: 1990
Number of Cylinders: 4
Make: Honda
Model: CRX
Trim: Si Coupe 2-Door
Warranty: Vehicle does NOT have an existing warranty
Drive Type: FWD
Options: Sunroof, CD Player
Mileage: 124,920
Power Options: Air Conditioning
Sub Model: Si
Exterior Color: Black
Interior Color: Black
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

Up for sale is a Black 1990 Honda Cr-X Si.  


Mechanic owned.  Garage kept.  Great condition.  30+ miles per gallon.  Car being sold because have to make room for new vehicle.
Car was bought for restoration to original specs.  No rust on body or panels.  New original color paint job from previous owner.  
Engine runs strong without issues.  Transmission shifts smooth without any grinds.  Ice cold AC.  Good condition seats without rip and good dash without crack.  

The following parts were replaced for the restoration process with either original Honda or aftermarket OE stock if discontinue.

1.  New Clutch, pilot bearing, release bearing pressure plate (last than 1000 miles), axle seals.
2.  New both side front upper and lower control arms, both side inner and outer tie rod ends, both sides stablizer links.
3.  New both side rear trailing arm bushings, both side rear upper & lower control arms, both compensator arms
4.  New OE specs springs front and rear.  Tokico blue struts front and back.
5.  New rear muffler with finisher from Honda
6.  New rear quarter glass moldings, rear hatch molding.
7.  New timing belt and water pump,  new camshaft seal, crankshaft seal, rear engine seal, valve guide seals, valve cover gasket.
8.  New AC & alternator belts, spark plugs, spark plug cables, distributor cap, air filter, gas filter, pcv valve.
9.  New engine and transmission mounts. New shift linkage bushing.
10.  Cross-drilled rotors all around.

Car can run another 100k miles with no issues.  Car will be sold with original Si wheels.
Car is also being sold locally.  I reserved the right to end auction early.

Please bid only if you are serious and have the money to buy the car.  Non paying winner will be reported.

Auto Services in New York

Willowdale Body & Fender Repair ★★★★★

Automobile Body Repairing & Painting
Address: 92 S Bayles Ave, Greenvale
Phone: (929) 224-0634

Vision Automotive Group ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 1177 Fairport Rd, Rush
Phone: (585) 249-9000

Vern`s Auto Body & Sales Inc ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Parts & Supplies
Address: 107 W Main St, Fort-Johnson
Phone: (518) 843-3424

Valvoline Instant Oil Change ★★★★★

Auto Repair & Service, Auto Oil & Lube, Automotive Tune Up Service
Address: 56 W Old Country Rd, Jericho
Phone: (516) 931-7887

Valanca Auto Concepts ★★★★★

Automobile Body Repairing & Painting
Address: 1171 Zerega Ave, Larchmont
Phone: (718) 828-2111

V & F Auto Body Of Keyport ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting
Address: 6 Cass St, Staten-Island
Phone: (732) 739-6202

Auto blog

Honda already working on NSX roadster

Mon, 25 Nov 2013

Honda doesn't do many convertibles. There was the original Sports 360, the Civic del Sol, the S2000 and the Beat. But so far, that's pretty much it. The previous NSX was offered with a targa-style top, but the latest reports indicate that the Japanese automaker is already working on a proper convertible version of the new NSX, to be sold once again as an Acura in North America and a Honda in other markets.
Although it's not yet known whether the NSX roadster will offer a hard or soft top, sources indicate that it won't be a mere removable roof panel. Whatever form it does take, however, expect it to arrive a good couple of years after the tin-top version launches in 2015 with a similar form to the concept but with different underpinnings and a radical interior.

Boston woman's car finally free from 100 inches of snow

Thu, Mar 19 2015

It's a car owner's worst winter nightmare: Snowfall so heavy that you can't dig your vehicle out of it. That's exactly what happened to Jillian Tenen, whose 2007 Honda Civic was buried in the snow in Boston for seven weeks after historic winter storms. Tenen's car was initially stuck after a snowfall in late January, but she didn't dig it out because she had the flu. "I'm 5' 2," and it was all ice, an iceberg on top of my car," she told the Boston Globe. "I couldn't reach it. I couldn't lift it. And even if I could, there was nowhere to put it. I just didn't know what to do," she said. Tenen reached out for help to the city, her insurance company and a tow truck company, but they refused to help her. Finally when the weather warmed up, Tenen used an ice chopper to get into her car. The windshield was damaged, however, the car started on its own. "If I had to do it again, I would definitely do one thing differently... I would not park on the corner," Tenen said.

Honda's Acura NSX masterstroke: building the factory in Ohio

Tue, Apr 12 2016

When Honda announced it was going to build its NSX supercar in Ohio instead of Japan, it caught everybody in the industry by surprise. No one expected this proud Japanese company to build its most technologically advanced sports car anywhere but in its home country. Now Honda has a supercar production facility in rural Ohio that would be the envy of any Formula One team. The people at Honda call it the PMC, but its official name is the Performance Manufacturing Center. It's a building that started out as a shipping facility for suppliers, but Honda invested $70 million to transform it into a showcase facility that will build the NSX. Honda benchmarked the assembly operations at Ferrari, Lamborghini, McLaren, and Bentley before work began on its facility. The 200,000 square-foot building will also double as a customer reception center – Honda will open the doors for customers to come see their car being built. It's also going to offer them high-speed test drives at the gigantic Transportation Research Center just down the road. No one expected this proud Japanese company to build its most technologically advanced sports car anywhere but in its home country. Inside, the layout is wide open and well lit. There are no stripes or lines on the floor and none of the different departments are walled off. This creates a more welcoming appearance and lets you get a comprehensive view of the entire process at a glance. And with an eye towards future lessons learned, most of the equipment is of a modular design that can be easily reconfigured or moved. The body shop and paint shop are enclosed by glass walls so that anyone can see what's going on inside. And while you'll see some automation here and there, the idea was to achieve a blend between man and machine, not to try and automate everything. This is a low-volume facility with production targeted at only eight to ten cars a day. The plant runs four days a week with one ten-hour shift. Don't expect to see rows of new NSXs parked on any dealer's lot. The car will only be built to order. Honda is obsessed with ensuring the NSX is built to the most exacting quality standards. The plant people pored over the JD Power Appeal study to determine what supercar customers care about the most, then looked at which aspects of that directly tie into manufacturing. They developed their quality control strategy with three goals in mind. First, they wanted to build everything right the first time with no adjustments.