1990 Honda Crx Si Coupe 2-door 1.6l on 2040-cars

Auto blog

Beleaguered Takata unlikely to seek automaker assistance

Takata is continuing to deal with the massive airbag recall for millions of vehicles, but even if it doubles production, it could take years the company to build enough replacement parts to properly repair all of the affected models. If the supplier takes a hard enough financial hit whether through fines, lawsuits or just the cost of making the components, then the business might not be able to keep up production. Such a situation could put automakers in the very difficult predicament of deciding whether to provide Takata with financial assistance. Honda for one has little interest in lending further support to the beleaguered supplier, according to The Wall Street Journal. The Japanese automaker recently dropped its annual sales targets to put a larger emphasis on vehicle quality, partially in response to the inflator recall. It also struck a deal with another company for replacement parts and was rumored to abandon Takata for some future business. Honda CEO Takanobu Ito did leave the door barely cracked for possible aid. "Takata itself needs to figure out how to fulfill its duties, but if it makes any request to automakers, then we would think about that," he said, according to The Wall Street Journal. There isn't much likelihood of Takata needing a bailout, though. According to The Wall Street Journal, analysts aren't concerned about the company's short-term fortunes, and the supplier had about $728 million in cash as of last September. News Source: The Wall Street Journal - sub. req.Image Credit: Toru Yamanaka / AFP / Getty Images Earnings/Financials Recalls Honda Safety Takata airbag recall

Honda execs take 'quality-related' pay cut after Fit Hybrid's 5th recall

Generally, the best policy in life is to admit when you're wrong and just accept the consequences. However, that attitude generally seems to be a bit less common in the world of business - at least without some government or legal prodding. So, it's especially surprising to learn that top Honda executives in Japan are taking a pay cut for the next three months following the fifth recall of the Fit Hybrid (pictured above) in the last 12 months.
According to Reuters, Chief Executive Takanobu Ito is taking a 20-percent pay cut to make amends for the quality issues. Also, 12 other high-ranking executives are taking 10 percent drops in their salaries. In addition to those temporary changes, Honda is creating a new position in charge of monitoring vehicle quality.
The latest recall fixes "noise-related defects," according to Reuters, on both the hybrid and naturally aspirated versions of the Fit, both variants of the Vezel (the sibling to the future HR-V in the US) and the N-WGN. There have also been three recalls for problems with the hybrid's seven-speed dual-clutch transmission. None of them have caused reported injuries or deaths, and these issues haven't affected US models.

James Glickenhaus' SCG 003 undisguised in street and track form

For James Glickenhaus buying a factory-made supercar isn't good enough; he wants to develop his own. Following up on the Ferrari Enzo-based P4/5 and later the P4/5 Competition, Glickenhaus' latest project is appropriately called the 003, and he's finally displaying it in road trim. These first undisguised photos of the SCG 003S show off a supercar with a front end reminiscent of a Ferrari Enzo. However, the rear evokes the look of a modern endurance racer with a fin running along the spine. A wing at the back connects it all together, and the massive diffuser should keep things planted too. Development of the 003 has been going for over a year by Scuderia Cameron Glickenhaus, but the company has set quite a challenge for itself to get just right. Glickenhaus wants his latest project to be a true racecar for the street. That idea gets thrown around a lot, but it might be true in this case. In motorsports trim, the SCG 003C (pictured inset) packs a mid-mounted Honda Performance Development twin-turbocharged V6, but the engine sits in a detachable rear subframe. When the time comes for the road, the car converts to the SCG 003S and allegedly swaps in a twin-turbo W12. It makes the vehicle the best of both worlds – at least in theory. SCG reportedly plans to show the 003 at the Geneva Motor Show, so we should get a better look then. Glickenhaus also wants to take the car racing in the 24-hour events at the Nurburgring and Spa later this year.