Accord Black Hybrid Alloy Wheels Sedan Auto Keyless Ac New Stability Power on 2040-cars

Auto blog

McLaren working on P15 supercar to slot between 650S and P1

McLaren has been busy these past few years. It launched the MP4-12C in 2011, the 12C Spider in 2012, the P1 in 2013 and (most recently) the 650S in 2014. But it's not about to stop there. It's got an "entry-level" model in the works, set to take on the Porsche 911, and - according to information reported by Car and Driver and confirmed by McLaren in correspondence with Autoblog - a new flagship model, too.
The project is internally codenamed P15, and it calls for a new flagship that will cap the company's lineup once the P1 finishes its limited production run, but carry a price tag in the neighborhood of $500k to slot in between the P1 and the new 650S.
Just how, you wonder, can McLaren possibly develop another supercar each year? Simple: underneath, they're all essentially the same. (Only we're sure it's anything but simple.) That is to say they're all based on the same carbon monocoque structure and powered by the same 3.8-liter twin-turbo V8 mated to a seven-speed dual-clutch transmission driving the rear wheels. What differentiates them is what the engineers in Woking build around that monocoque and how they tune the engine: +/- 600 horsepower in the 12C (depending on the year it was built), 640 hp in the 650S, or 727 hp in the P1 (with another 177 from the electric assist). The 911 fighter would likely develop in the 500hp range, and the P15 will probably land in the upper 600 (or lower 700) range.

Honda underreported 1,729 claims of injuries or deaths since 2003

Among these underreported cases were eight Takata airbag inflator ruptures not submitted. Following an independent audit of its safety reporting procedures, Honda has found massive holes in its methodology and practices that resulted in 1,729 claims of injuries or deaths going unreported to federal authorities dating back to July 2003. The cases should have been submitted to the National Highway Traffic Safety Administration as part of its quarterly Early Warning Reports (EWRs) under the TREAD Act, but they fell through the cracks for a variety of reasons. Honda blames the underreporting on three factors: data entry errors, computer coding problems and "an overly narrow interpretation of what constituted a 'written notice' under the TREAD Act." The first two issues were related to the computer program that collected the claims. If employees didn't enter a date in the "written claim received" field, then they were omitted from the EWRs. Also, the company's internal component codes didn't always match those used by NHTSA, and only the ones that were the same were disclosed. Finally, third-party documents, including police reports, were not considered. Honda says the computer error is now corrected, and the company is updating its data entry training. In the future, written and oral claims will be included in EWRs, as well. Among these underreported cases were eight Takata airbag inflator ruptures not submitted in Honda's EWRs, including one death and seven injuries. However, the automaker claims NHTSA was already aware of all of these incidents either from the agency's own records or from the company's notification outside of the EWR process. Unfortunately, this problem could have been stopped much sooner. The issue was first brought to light in 2011 but didn't result in a followup. NHTSA advised the automaker of discrepancies in January 2012, and it still did nothing. This third-party audit wasn't commissioned until September 2014. "Honda acknowledges that it lacked the urgency needed to correct its problems on a timely basis," it says in the announcement. Separately, the Japanese government is starting an investigation, as well. According to Reuters, the Japanese Transport Minister has created a task force to look into the Takata recalls and find out whether Honda under-reported incidents there. Scroll down to read the company's entire statement on the third-party investigation.

Acura NSX GT3 swings through New York en route to the track

Supercars are developed for the road, but sometimes the prospect of putting them on the track proves just too tempting to pass up. McLaren found out just that with the legendary F1, and now its racing partner Honda is doing the same with the new Acura NSX GT3 you see here. Unveiled here at the 2016 New York Auto Show, the NSX GT3 is based closely on the road-going version, but with several key differences. For starters, it ditches the trick hybrid all-wheel-drive system, not unlike the Type R we're expecting to follow. It keeps the 3.5-liter V6, but purely in twin-turbo guise (with no electrical boost in sight), driving the rear wheels through a six-speed sequential gearbox instead of the nine-speed dual-clutch transmission. The aluminum space frame carries over, but comes draped in extensively modified bodywork with more extreme aero to keep it cool and glued to the track. Since it's been designed to FIA GT3 regulations (and not the more advanced GTE), we shouldn't expect to see it competing at Le Mans against the new Ford GT (among others). But it will be in prime position to take on championships like the Pirelli World Challenge, Blancpain Endurance Series, and even the lower GT300 class of Japan's own Super GT series. Wherever it competes, though, it positively looks the business even sitting still, and we're looking forward to seeing it run. Acura Unveils NSX GT3 Racecar in New York Mar 23, 2016 - NEW YORK, NY - Twin turbocharged NSX supercar to campaign in North American competition starting 2017 - NSX slated to undergo homologation this fall as an FIA GT3 class racecar - Racecar body to be built by the Performance Manufacturing Center in Marysville, Ohio, the exclusive manufacturing home to the all-new Acura NSX supercar; engine to be produced in Anna, Ohio Acura took the wraps off a NSX GT3 racecar today at the 2016 New York International Auto Show, announcing its intention to campaign the twin-turbocharged NSX supercar in North America starting in 2017. The NSX is currently undergoing testing and slated for homologation as an FIA GT3 class racecar this fall. The unveiled Acura NSX GT3 racecar featured custom bodywork and aero components including a large deck wing spoiler, underbody diffuser and enlarged hood vents for efficient engine cooling.