2012 Honda 2dr I4 Auto Ex-l Pzev on 2040-cars

Auto blog

Affordable, lightweight Honda roadster revival in the works?

There's a joke phrase from a popular movie that gets tossed around the Autoblog offices when ever a big change or announcement is coming: "Hold on to your butts." It's usually accompanied by a video of Samuel L. Jackson. That's the advice we'd recommend for reading this article. GTChannel is reporting that a new, small, lightweight, quick successor to the Honda S2000 is being "seriously considered."
Citing an unnamed source within the Japanese automaker, GTChannel goes on to list a few interesting tidbits about the new vehicle. From the sounds of it, though, if Honda is planning a new roadster, it's in the absolute earliest stages of development.
What's apparently being discussed is a car that's smaller than a Mazda MX-5, in terms of its dimensions. Under hood would be a VTEC engine, displacing anywhere from 1.3 to 1.5 liters, with GT Channel making the apt suggestion that the 1.5-liter, 132-horsepower mill from the Honda Fit could make its way into the new roadster. Curb weight would be in the realm of 2,000 pounds, which would make a 130-odd-hp engine seem absolutely heroic. Rear-wheel drive would be a given, although we aren't sure about the site's suggestion that a five-speed manual will be on offer. Styling could draw from the N-One, a popular, Honda-badged kei car.

Honda underreported 1,729 claims of injuries or deaths since 2003

Among these underreported cases were eight Takata airbag inflator ruptures not submitted. Following an independent audit of its safety reporting procedures, Honda has found massive holes in its methodology and practices that resulted in 1,729 claims of injuries or deaths going unreported to federal authorities dating back to July 2003. The cases should have been submitted to the National Highway Traffic Safety Administration as part of its quarterly Early Warning Reports (EWRs) under the TREAD Act, but they fell through the cracks for a variety of reasons. Honda blames the underreporting on three factors: data entry errors, computer coding problems and "an overly narrow interpretation of what constituted a 'written notice' under the TREAD Act." The first two issues were related to the computer program that collected the claims. If employees didn't enter a date in the "written claim received" field, then they were omitted from the EWRs. Also, the company's internal component codes didn't always match those used by NHTSA, and only the ones that were the same were disclosed. Finally, third-party documents, including police reports, were not considered. Honda says the computer error is now corrected, and the company is updating its data entry training. In the future, written and oral claims will be included in EWRs, as well. Among these underreported cases were eight Takata airbag inflator ruptures not submitted in Honda's EWRs, including one death and seven injuries. However, the automaker claims NHTSA was already aware of all of these incidents either from the agency's own records or from the company's notification outside of the EWR process. Unfortunately, this problem could have been stopped much sooner. The issue was first brought to light in 2011 but didn't result in a followup. NHTSA advised the automaker of discrepancies in January 2012, and it still did nothing. This third-party audit wasn't commissioned until September 2014. "Honda acknowledges that it lacked the urgency needed to correct its problems on a timely basis," it says in the announcement. Separately, the Japanese government is starting an investigation, as well. According to Reuters, the Japanese Transport Minister has created a task force to look into the Takata recalls and find out whether Honda under-reported incidents there. Scroll down to read the company's entire statement on the third-party investigation.

Clarion Builds 1991 Acura NSX Review | Restored to greatness

Few automobiles garner as much mystique as the original Acura NSX. I worshiped this car from afar, consigned to the fact that the closest I was ever going to get to the steering wheel was a Playstation controller. When I got the email inviting me to drive Clarion Builds' restored and tuned 1991 NSX, I thought it was spam, a chain email with some generic header sent to a dozen or so people to garner some press coverage. Surely this wasn't a real invite where I get to drive a real NSX using my real hands and feet. Some people say don't meet your heroes. Some people are wrong. I knew the car by reputation. In roughly 10 months, Clarion Builds, a division of the Japanese electronics company mostly known for high-end audio systems, worked with partners like AEM and AutoWave to transform a '91 NSX with nearly a quarter-million miles on the clock into what you see here. Everything, from the engine to the bodywork to the leather on the seats, has been upgraded and restored with a mix of both OEM and aftermarket parts. The final product is a stunner. It's tuned, but not slammed, stanced or any other adjective that describes a car with compromised performance and questionable looks. It's simply a tastefully tuned NSX. The NSX, especially an early car with pop-up headlights, is one of the all-time great car designs. There are no unnecessary lines or curves. It's all purposeful. As expected with something with 230,000 miles, this NSX had a number of dings and dents. Clarion Builds has fixed those, replacing the hood and spoiler with carbon-fiber parts from an NSX-R. The fenders are slightly wider than stock, helping cover the staggered Rays Engineering VOLK ZE40 wheels, 18-inch up front and 19-inch out back. After seeing it in the flesh with the blue paint, black roof and bronze wheels, I don't think there is a better fit for this car. The original but tired 3.0-liter V6 and five-speed manual have been swapped for a 3.2-liter V6 and six-speed manual from a 2004 NSX. Stock, this engine is a wonderful ode to the internal combustion engine. It sings a sweet song all the way to a sky-high 8,200 rpm redline. Still, it wasn't enough. The engine now wears a Whipple-style supercharger, pushing roughly 9 psi of boost. Other modifications include a one-off carbon-fiber intake, a hand-built exhaust and a new ECU, all from AEM. All in, Clarion Builds says this NSX makes 403 horsepower and 296 pound-feet of torque at the wheels. God, it feels good to push this thing.