2009 Gmc Yukon Denali 8cyl Warranty Call For Low Reserve!/ Loaded on 2040-cars

Auto blog

GM 6.2L EcoTec V8 rated at 21 mpg by the EPA

General Motors is already laying claim to best-in-class power for its new 6.2-liter V8 that will be offered in the 2014 Chevy Silverado and GMC Sierra this fall, and now it has released fuel economy numbers for the big engine. Available as an option on the Silverado LTZ and High Country (shown above) models as well as the the Sierra SLT and Denali trims, the 6.2L EcoTec3 V8 will return 15 miles per gallon in the city and 21 mpg on the highway on rear-wheel-drive trucks; these numbers drop by one mpg each on four-wheel-drive models.
These estimates are in addition to the engine's 420 horsepower, 460 pound-feet of torque and max trailering capacity of 12,000 pounds, and considering all that power it's not terribly far away from the fuel economy of GM's equally new 4.3-liter V6 and its rating of 18 mpg city and 24 mpg highway. This announcement comes just days after a report indicated that GM is unable to keep up with the demand of the 5.3-liter V8 in the fullsize Chevy and GMC trucks due to supplier issues. GM's official press release for the 6.2-liter V8's fuel economy is posted below.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM recalls 3.6 million vehicles for airbag-software problems

The Basics: General Motors is recalling 3.64 million vehicles across its lineup for an airbag-related issue. The recall covers the 2014-2015 Buick LaCrosse, Chevrolet SS, and Spark EV; 2014-2017 Chevrolet Corvette, Trax, Caprice PPV, Silverado 1500, Buick Encore, and GMC Sierra 1500; and 2015-2017 Chevrolet Tahoe, Suburban, Silverado HD, GMC Yukon, Yukon XL, Sierra HD, Cadillac Escalade, and Escalade ESV. The Problem: Affected vehicles have a sensing and diagnostic module that controls the airbags and seat-belt pretensioners. The software it uses has a defect that can prompt the module to run a diagnostic test under specific driving conditions, which will also deactivate the front airbags and pretensioners. This means that it would be possible for those safety systems to not activate in a crash, potentially leading to injury or death. Injuries/Deaths: General Motors began an investigation that led to the recall after a 2014 Silverado was involved in a crash in which the airbags did not deploy. No information was given as to injuries or deaths. The Fix: Owners can bring their vehicles to a local General Motors dealer where a software update will be installed to fix the issue. The fix will be free of charge. If you own one: General Motors will contact owners of affected cars, and owners can check whether their vehicles are affected by visiting entering their vehicle identification numbers at either the GM Owner Center website or the NHTSA website. Owners can then schedule a time to have the update installed. Related Video: