1997 Gmc Suburban- Low Low Miles- Mint!! on 2040-cars

Auto blog

2014 GMC Sierra 4.3L V6 to offer segment-best 305 LB-FT

General Motors has released more information on the 4.3-liter V6 available in the 2014 GMC Sierra. The engine will serve up 285 horsepower and 305 pound-feet of torque, with a six-speed automatic transmission, and giving the V6 Sierra a maximum tow rating of 7,200 pounds in regular cab, short bed four-wheel drive configuration. GM claims that figure is 500 pounds more than the equivalent Ford F-150 equipped with a 3.7-liter V6, and 700 pounds more than the Ram 1500 with its 3.6-liter V6. Buyers can expect to see the 2014 GMC Sierra with the 4.3-liter engine start at $25,085 including destination.
While the engine does deliver more torque than either of its main competitors, it falls short on the horsepower front. The 3.7-liter V6 in the F-150 develops 302 hp while the 3.6-liter V6 in the Ram 1500 yields 305 hp. GM says fuel economy estimates for its newest entry will land later this year. Check out the full press release below for more information.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

2015 Chevy Colorado to start at $20,100*, GMC Canyon at $20,995**

General Motors has just announced pricing for its new midsize pickup trucks, the 2015 Chevrolet Colorado and GMC Canyon. Chevy's truck starts at $20,100, *not including $895 for destination, and the GMC starts at $20,995, **not including $925 for destination. These prices are for the base, extended cab models with the 200-horsepower, 2.5-liter inline four-cylinder engine.
Comparatively, these prices fit nicely with the $18,125 starting MSRP of the Toyota Tacoma and the $21,510 of the Nissan Frontier. Compared to the Colorado, the Canyon's extra $895 gets you niceties like LED running lamps, 16-inch alloy wheels, and a four-way power driver's seat.
Both trucks come standard with the 2.5-liter engine, and a more powerful, 305-hp 3.6-liter V6 will also be available. Pricing has not been announced for the upcoming diesel model, which is expected to launch for the 2016 model year.