2015 Gmc Sierra 2500 Slt on 2040-cars
17605 US Highway 441, Mt Dora, Florida, United States
Engine:Turbocharged Diesel V8 6.6L/403
Transmission:6-Speed
VIN (Vehicle Identification Number): 1GT12ZE8XFF128544
Stock Num: 128544
Make: GMC
Model: Sierra 2500 SLT
Year: 2015
Exterior Color: Summit White
Interior Color: Cocoa/Dune
Options: Drive Type: 4WD
Number of Doors: 4 Doors
Please call David at 866-291-3265
GMC Sierra 2500 for Sale
- 2012 gmc sierra 2500 denali(US $37,999.00)
- 2011 gmc sierra 2500 h/d(US $33,000.00)
- 2015 gmc sierra 2500 sle(US $44,453.00)
- 2015 gmc sierra 2500 sle(US $46,099.00)
- 2015 gmc sierra 2500 slt(US $50,519.00)
- 2011 gmc sierra 2500 h/d(US $42,920.00)
Auto Services in Florida
Yow`s Automotive Machine ★★★★★
Xtreme Car Installation ★★★★★
Whitt Rentals ★★★★★
Vlads Autobahn LLC ★★★★★
Village Ford ★★★★★
Ultimate Euro Repair ★★★★★
Auto blog
NHTSA opens safety investigations into Toyota, GM and Honda crossovers
Fri, 08 Jun 2012The National Highway Traffic Safety Administration is evidently keeping itself very busy these days, as the federal agency has just announced it is launching or renewing investigations into Toyota, Honda and General Motors crossovers.
2006-2008 model year Toyota RAV4 crossovers are under review for allegations of rear tie-rod rust which can result in failure. NHTSA also said it is probing some 35 complaints about 2005 Honda Pilot models with inappropriate activation of the vehicles' stability control system. The alleged malfunction can cause the vehicles to slow down or stop in bad unsafe situations. At the moment, NHTSA is reviewing a petition regarding the Pilot issue, a move that will determine whether it needs to open a full-blown investigation.
In addition, Saturn Outlook and GMC Acadia three-row crossovers built in 2007-2009 are getting looked at for "loss of low beam headlamp" function. One complainant said the wiring in his Outlook overheated and melted. NHTSA says it has received 415 complaints about the problem and a GM spokesman confirmed that the automaker already started a "Customer Satisfaction Program" in December to address the issue.
GM recalls 3,300 pickups and SUVs for new ignition-switch issue [UPDATE]
Mon, Oct 19 2015UPDATE: A statement from GM about the recall has been added below. The exact total of vehicles affected is 3,296, including 3,073 of them in the US. General Motors isn't letting an ignition-switch problem grow into a massive scandal again. The automaker is recalling about 3,300 North American trucks and SUVs. They are: the 2014 Chevrolet Silverado and GMC Sierra and the 2015 Chevy Suburban and Chevy Tahoe, as well as 2015 model heavy-duty pickups, the Detroit News reports, citing an Associated Press story. The issue appears to have been caught fairly quickly. In this case, the keys can get stuck in the "start" position and then slip to "accessory" if bumped. This is because the ignition lock gears have an outer diameter that's larger than the specifications allow. When that happens the engine shuts off, and the driver loses assistance to the steering and brakes. The airbags might also be affected. The vehicles get a new ignition-lock housing to fix the problem. According to the Detroit News, an employee who experienced the problem with the switch discovered the issue, and this person then let officials at the automaker know as part of the Speak Up for Safety program. A total of five reports of the fault were discovered. However, there are no cases of injuries or crashes. The claims to the automaker's resolution program eventually tallied that GM's previous ignition switch problem included 124 deaths and 275 injuries. The company also had to recall millions of vehicles and pay significant fines to the US government. GM Statement General Motors is recalling 3,073 full-size trucks from the 2014 and 2015 model years in the U.S. Some of these vehicles may have an ignition lock actuator gear with an outer diameter that exceeds specifications, which may make turning the ignition key difficult. The ignition key could get stuck in the "start" position. This may be more likely at higher interior ambient temperatures. If the vehicle is driven with the key stuck in the "start" position, and the vehicle experiences a significant jarring event or the vehicle's interior temperature cools, the ignition lock cylinder could move out of the "start" position, rotate past the "run" position, and move into the "accessory" position, leading to loss of power steering assist, power brakes and potentially air bag deployment in certain crashes. Dealers will replace the ignition lock housing.
GM recalls Colorado, Canyon, and Malibu for airbag problem
Wed, Mar 9 2016The Basics: General Motors will recall and issue a stop sale on 1,740 total examples of the 2016 Chevrolet Colorado, Malibu, and GMC Canyon. This includes 1,579 units in the US and 161 in Canada. The Problem: The second stage of the driver front airbag inflator might not be present. If this happens, the airbag won't fill as quickly as it should in a high-speed crash, which could increase the risk of injury, according to Reuters. This is not related in any way to Takata's inflator problems, and these parts come from a different supplier. Injuries/Deaths: None reported. The Fix: GM will replace the vehicles' airbag assemblies. If You Own One: GM spokesperson Tom Wilkinson told Autoblog he wasn't specifically sure when recall repairs would begin but said it would be "shortly." He expects the fixes to happen "quickly" because of the small number of affected vehicles, and many of them are either in transport or already in dealer stock. More Information: GM recalled the 2015 Canyon and Colorado in 2014 for a completely separate airbag issue. In that case, a manufacturing error improperly wired the connectors. Related Video: GM Statement GM is recalling 1,579 MY 2016 Chevrolet Colorado, GMC Canyon and Chevrolet Malibu vehicles in the United States and 161 in Canada to replace driver-side front airbags. The second stage of the airbag may not deploy properly in certain high-speed crashes. During a routine quality inspection, it was determined that a component required for a second-stage/high-output deployment was not loaded during the inflator build. Dealers will replace the driver-side front airbag assembly. There have been no reports of crashes or injuries related to this issue. This issue is unrelated to the ongoing Takata recalls.