2015 Gmc Sierra 2500 Base on 2040-cars

Auto blog

GM recalls 3,300 pickups and SUVs for new ignition-switch issue [UPDATE]

UPDATE: A statement from GM about the recall has been added below. The exact total of vehicles affected is 3,296, including 3,073 of them in the US. General Motors isn't letting an ignition-switch problem grow into a massive scandal again. The automaker is recalling about 3,300 North American trucks and SUVs. They are: the 2014 Chevrolet Silverado and GMC Sierra and the 2015 Chevy Suburban and Chevy Tahoe, as well as 2015 model heavy-duty pickups, the Detroit News reports, citing an Associated Press story. The issue appears to have been caught fairly quickly. In this case, the keys can get stuck in the "start" position and then slip to "accessory" if bumped. This is because the ignition lock gears have an outer diameter that's larger than the specifications allow. When that happens the engine shuts off, and the driver loses assistance to the steering and brakes. The airbags might also be affected. The vehicles get a new ignition-lock housing to fix the problem. According to the Detroit News, an employee who experienced the problem with the switch discovered the issue, and this person then let officials at the automaker know as part of the Speak Up for Safety program. A total of five reports of the fault were discovered. However, there are no cases of injuries or crashes. The claims to the automaker's resolution program eventually tallied that GM's previous ignition switch problem included 124 deaths and 275 injuries. The company also had to recall millions of vehicles and pay significant fines to the US government. GM Statement General Motors is recalling 3,073 full-size trucks from the 2014 and 2015 model years in the U.S. Some of these vehicles may have an ignition lock actuator gear with an outer diameter that exceeds specifications, which may make turning the ignition key difficult. The ignition key could get stuck in the "start" position. This may be more likely at higher interior ambient temperatures. If the vehicle is driven with the key stuck in the "start" position, and the vehicle experiences a significant jarring event or the vehicle's interior temperature cools, the ignition lock cylinder could move out of the "start" position, rotate past the "run" position, and move into the "accessory" position, leading to loss of power steering assist, power brakes and potentially air bag deployment in certain crashes. Dealers will replace the ignition lock housing.

GMC Syclone spools up a storm on Jay Leno's Garage

A storm was brewing on American roads in the early 1990s. That's when Detroit's automakers were producing some of the hottest performance trucks ever devised – models like the Ford Lightning, GMC Typhoon, and its flyweight pickup sibling, the GMC Syclone. Jay Leno just happens to have one of the latter in his garage, and took it out to showcase in this latest video segment. The Syclone was an exercise in absurdity, and could not only trounce any other pickup on the road, it could outrun anything else GM made and just about anything else on the road – beating Ferraris and Porsches off the line. In a pickup, for crying out loud. The kicker is that its engine wasn't such a monster, either: under the hood sat a 4.3-liter turbocharged V6 pumping out what would seem by today's standards to be an adequate 280 horsepower and 350 pound-feet of torque. Even the smaller of the EcoBoost V6s available in today's Ford F-150 produces more than that. But in a lightweight, compact pickup, those figures were enough to propel the Syclone to 60 in 4.3 seconds and run the quarter-mile in 13.6 seconds. Long before the dune-jumping Ford F-150 SVT Raptor or even the Viper-powered Dodge Ram SRT-10, GM made fewer than 3,000 Syclones based on the compact Sonoma (sister to the Chevy S-10) and another 4,700 of the Typhoon, which was mechanically similar but more practical (albeit heavier) wagon bodywork from the Jimmy. But as Jay aptly points out, the Syclone was the one you wanted. Scope it out in the ten-minute video clip above.

GM cutting vehicle trim options to save money for electrification

Information continues to filter out about GM's plans based on comments the automaker made during its Capital Markets Day event in February. GM President Mark Reuss said the company's push to save money by rationalizing the number of build combinations will continue in 2020, carrying on the work done in 2019. As GM Authority covers, last year, the carmaker cut 3,500 components across model lines, a 12% drop in the number of parts it needed to stock in its plants. Reuss used the next-generation Chevolet Equinox and GMC Terrain as examples for more cost efficiencies, saying build possibilities — which include international markets and their options — will be cut by more than 50%, and use more shared parts. "We will reduce total trim levels on Equinox and Terrain from eight to six," Reuss said, "reduce engine variants from 11 to 5, reduce build combinations from more than 200 to less than 100 per program, and see significant cost savings of an already paid-for architecture that took the mass out, helping us self-fund electrification programs." GM will plow a large amount of the money it saves into its ambitious EV program. In 2017, the automaker said it intends to have 20 electric vehicles on the market by the end of 2023, some of which could be shared between brands. An automotive analyst at Seeking Alpha and a piece in Automobile attempted to put specifics to what we should expect. As Automobile points out, the first two EVs in the 20-car program are already on sale, being the Ariv Meld and Ariv Merge eBikes available in Belgium and The Netherlands. We've seen the Cruise Origin autonomous rideshare taxi, although we don't know when it will hit the road. The next three, which we should see in the metal shortly, are two Cadillac EVs and the GMC Hummer EV pickup. The Cadillac pair are expected to be sized like the XT4 and XT5, and along with the Hummer, should hit the market starting in late 2021.