2008 Gmc Sierra 2500 Hd Crew Cab Pickup 4-door 6.6l on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GMC could have used Jeep's prized grille design on its born-again Hummer

General Motors confirmed it's bringing the Hummer nameplate back on an electric, GMC-badged pickup by publishing a dark photo of its front end. The battery-powered drivetrain under the sheetmetal represents a tectonic shift, but we noticed another flagrant break with tradition: it wears six slot-like inserts instead of seven like on every previous Hummer and countless Jeeps. Adding an extra slot wouldn't have landed GMC in hot water. The seven-slot grille has historically been associated with Jeep, and the company proved it's willing to go to significant lengths to ensure another automaker — especially one it perceives as a rival — doesn't use it. Parent company Fiat-Chrysler Automobiles (FCA) bitterly sued Mahindra over the Roxor's design, including its five-slot grille, and won in 2019, forcing the Indian firm to unveil a redesigned side-by-side for the 2020 model year. And yet, stylists would have very likely been able to get away with it on the Hummer. While General Motors owns Hummer, the brand traces its ancestry to 1970, when American Motors Corporation (AMC) purchased Jeep from Kaiser and changed the name of its General Products Division to AM General Corp. The division manufactured the rear-wheel drive, CJ-based DJ for the United States Postal Service and began developing the Humvee in 1979. Jeep and AM General went their separate ways when Renault began investing in AMC. Foreign companies weren't allowed to own defense contractors, and AMC had more to gain by gradually selling out to Renault than by keeping AM General, so it divested the division to LTV Corporation in 1983. Humvee production started shortly after, but no one protested its seven-slot grille because there was no risk of it stealing sales from a comparable Jeep model. It was manufactured exclusively for the U.S. Army, and civilian sales weren't planned. H2SUV View 4 Photos The original civilian Hummer released in 1992 must have raised more than a few eyebrows but, here again, it didn't directly compete with one of Jeep's off-roaders, so no one complained. It was huge, correspondingly expensive, and its portal axles made the YJ-generation Wrangler wet its pants. It's the H2 concept (pictured above) unveiled at the 2000 Detroit Auto Show that set off alarm bells in Auburn Hills. DaimlerChrysler's lawyers counted the slots in the chrome-plated insert that dominated its front end and shuddered when they reached seven.

2014 GMC Sierra Regular Cab revealed

Despite initially launching in just the Crew Cab configuration, the lineup of 2014 GMC Sierra and 2014 Chevrolet Silverado trucks will eventually grow to include three cab sizes and three bed lengths. Oddly enough, our first look at the Regular Cab bodystyle has arrived in a General Motors press release discussing the aerodynamics of the new truck, with an image showing a Sierra Regular Cab testing in the wind tunnel. GMC's website says that Regular Cab and Double Cab models will be available by summer.
While it really didn't take too much imagination to figure out what the two-door version would look like, this Regular Cab Z71 looks pretty sharp with its standard-length (6.5-feet) bed - a longer bed will also be offered. In regards to the aero tuning of the 2014 Sierra, these images show just how far GM has gone in maximizing the truck's fuel efficiency and reducing its noise, vibration and harshness (NVH) levels. Interestingly, the press release shows visual evidence that keeping the tailgate up is best for aero - there's always been some Mythbusters-level contention about such things -but GM also says that adding tonneau covers (preferably soft) and running boards can also help improve the overall aerodynamics. Scroll down for all of this aero info in the official press release.