No Reserve - 4.3l V6 - 5-speed - Southern Truck, No Body Rot on 2040-cars

Auto blog

GM faces possible class action lawsuit over 8-speed transmission

General Motors has been hit with a class-action lawsuit from owners who allege the eight-speed automatic transmission found in several rear-wheel-drive Chevrolet, Cadillac and GMC models between the 2015 and 2019 model years has a defect that causes the vehicles to hesitate and jerk when accelerating or slowing down. The lawsuit was posted to ClassAction.org and spotted by GM Authority. Problems with GM's Hydra-Matic 8L90 and 8L45 transmissions have been well-documented on Internet forums and via complaints filed with the National Highway Traffic Safety Administration, with many reporting damage to their vehicles. The lawsuit was first filed in December in U.S. District Court for the Southern District of Florida but appears to have been transferred recently to New York. Autoblog sought comment from Theodore Leopold, the lead attorney for the plaintiffs. "These transmissions have a common defect," the complaint reads. "Drivers attempting to accelerate or decelerate their cars feel a hesitation, followed by a significant shake, shudder, jerk, clunk, or 'hard shift' when the vehicle's automatic transmission changes gears." The problem also occurs when the vehicles accelerate in a single gear, without shifting, the plaintiffs allege. "Drivers have reported that the shift is sometimes so violent, they feel as though they have been hit by another vehicle." The problem is believed to center on the transmission, torque converter or both. The complaint says it causes undue friction, causing hydraulic systems and gears to function improperly and sometimes leaves metal shavings throughout the transmission, leading to costly repairs and replacement of parts or the entire transmission. It says GM has known about the problems since shortly after it introduced the transmissions, and has issued 13 technical service bulletins, none of which have resolved the problem. GM declined to comment on the lawsuit. The plaintiffs say GM should have warned consumers about the issues and covered repairs under each vehicle's three-year/36,000-mile bumper-to-bumper warranty. They're seeking statewide classes in at least six states: California, Florida, Illinois, New York, Oklahoma and Texas.

2014 GMC Sierra 4.3L V6 to offer segment-best 305 LB-FT

General Motors has released more information on the 4.3-liter V6 available in the 2014 GMC Sierra. The engine will serve up 285 horsepower and 305 pound-feet of torque, with a six-speed automatic transmission, and giving the V6 Sierra a maximum tow rating of 7,200 pounds in regular cab, short bed four-wheel drive configuration. GM claims that figure is 500 pounds more than the equivalent Ford F-150 equipped with a 3.7-liter V6, and 700 pounds more than the Ram 1500 with its 3.6-liter V6. Buyers can expect to see the 2014 GMC Sierra with the 4.3-liter engine start at $25,085 including destination.
While the engine does deliver more torque than either of its main competitors, it falls short on the horsepower front. The 3.7-liter V6 in the F-150 develops 302 hp while the 3.6-liter V6 in the Ram 1500 yields 305 hp. GM says fuel economy estimates for its newest entry will land later this year. Check out the full press release below for more information.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck