2004 Gmc Canyon **low Reserve, Below Kbb, Original Owner** on 2040-cars

Auto blog

GMC Syclone spools up a storm on Jay Leno's Garage

A storm was brewing on American roads in the early 1990s. That's when Detroit's automakers were producing some of the hottest performance trucks ever devised – models like the Ford Lightning, GMC Typhoon, and its flyweight pickup sibling, the GMC Syclone. Jay Leno just happens to have one of the latter in his garage, and took it out to showcase in this latest video segment. The Syclone was an exercise in absurdity, and could not only trounce any other pickup on the road, it could outrun anything else GM made and just about anything else on the road – beating Ferraris and Porsches off the line. In a pickup, for crying out loud. The kicker is that its engine wasn't such a monster, either: under the hood sat a 4.3-liter turbocharged V6 pumping out what would seem by today's standards to be an adequate 280 horsepower and 350 pound-feet of torque. Even the smaller of the EcoBoost V6s available in today's Ford F-150 produces more than that. But in a lightweight, compact pickup, those figures were enough to propel the Syclone to 60 in 4.3 seconds and run the quarter-mile in 13.6 seconds. Long before the dune-jumping Ford F-150 SVT Raptor or even the Viper-powered Dodge Ram SRT-10, GM made fewer than 3,000 Syclones based on the compact Sonoma (sister to the Chevy S-10) and another 4,700 of the Typhoon, which was mechanically similar but more practical (albeit heavier) wagon bodywork from the Jimmy. But as Jay aptly points out, the Syclone was the one you wanted. Scope it out in the ten-minute video clip above.

GM seeks national mandate for zero-emissions cars

DETROIT — General Motors says it will ask the federal government for one national gas mileage standard, including a requirement that a percentage of auto companies' sales be zero-emissions vehicles. Mark Reuss, GM's executive vice president of product development, said the company will propose that a certain percentage of nationwide sales be made up of vehicles that run on electricity or hydrogen fuel cells. GM says a nationwide program modeled on such a requirement in California could result in 7 million electric vehicles, or EVs, on U.S. roads by 2030. California wants 15.4 percent of vehicle sales by 2025 to be EVs or other zero emission vehicles. Nine other states, including Maryland, Massachusetts, New Jersey and New York, have adopted those requirements. In January, California Governor Jerry Brown set a target of 5 million zero-emission vehicles in California by 2030. The Trump administration criticizes California's ZEV mandate, saying it requires automakers to spend tens of billions of dollars developing vehicles that most consumers do not want, only to sell them at a loss. Reuss told reporters that governments and industries in Asia and Europe "are working together to enact policies now to hasten the shift to an all-electric future. It's very simple: America has the opportunity to lead in the technologies of the future." A national mandate also would create jobs and reduce fuel consumption, CO2 emissions and "make EVs more affordable," Reuss added. GM, the nation's largest automaker, will spell out the request Friday in written comments on a Trump administration proposal to roll back Obama-era fuel economy and emissions standards, freezing them at 2020 levels instead of gradually making them tougher. Under a regulation finalized by the Environmental Protection Agency at the end of the Obama administration, the fleet of new automobiles would have to get 36 miles per gallon by 2025, 10 mpg higher than the current requirement. But the Trump administration's preferred plan is to freeze the standards starting in 2021. Administration officials say waiving the tougher fuel efficiency requirements would make vehicles more affordable, which would get safer cars into consumer hands more quickly. GM on Thursday said it doesn't support the freeze, but wants flexibility to deal with consumers' shift from cars to less-efficient SUVs and trucks.

Torque time | 2017 GMC Sierra HD First Drive

It's not the truck that counts, it's how you use it. It's the heavy stuff you fit in its bed or the extremely heavy stuff that gets hooked up to the tow hitch. The ATV, the Jet Skis, the trailer with more square footage than a Greenwich Village apartment. Perhaps you need to get Seabiscuit or, uh, Mr. Ed to wherever they need to gallop next. In our case, there's a pair of very serious-looking snowmobiles perched atop the bed of a GMC Sierra. They spread out as wide as the extended tow mirrors, and their back halves are dangling precariously beyond the truck. Sterling Archer would be giddy; I'm a little nervous. But only because canyon roads and wide vehicles with a high center of gravity go together like peas and custard. The added weight is no sweat at all. That's because this is the 2017 GMC Sierra HD Denali, a truck with the sort of enhanced power, torque, suspension, and stopping capability expected of a heavy-duty pickup. And for this year, the power and torque get a serious bump courtesy of a new 6.6-liter Duramax turbodiesel engine reengineered from almost the ground up with 90 percent new parts. It's quieter and more efficient and it emits less, while most importantly producing 445 horsepower and 910 pound-feet of torque. That's up from 397 and 765, respectively. Chevy fans will note that the same engine is also available in the updated 2017 Silverado HD. Now, for those keeping score at home, that horsepower is best-in-class but the torque number still falls short of the new Ford Super Duty and its Power Stroke diesel V8's 925 lb-ft. Aw shucks. For the record, GM's engineers didn't seem too concerned that they weren't able to eke out an extra 16 torques just to say they're No. 1. "We wanted to first meet emissions and then deliver the maximum horsepower and torque we could, and deliver it over the widest usability range possible," said chief engineer Eric Stanczak. And let's be honest here, 910 pound-feet is herculean, and once again, a jump of 145 lb-ft. Or one Subaru Impreza's worth. Or 110 more than the best Ram can do on a 2500, and its Cummins turbodiesel's 800 pound-feet was eye-popping not too long ago. (The Ram 3500 maxes out at 900 lb-ft with the right transmission.) Ah, but here's the rub. That Cummins-equipped Ram 2500 can still tow more weight according to SAE-compliant measurements – 17,510 pounds for a Ram crew cab with a short bed versus 13,000 in the similar Sierra 2500. The Ford F-250 can manage 15,000.