Van Wheelchair Handicap Rear Ramp Entry 1997 Ford Windstar Super Clean on 2040-cars

Auto blog

Car companies used to cook up sales with recipe books

The evolution of automotive marketing has undergone a number of strange phases. Few, though, match the strangeness of the 1930s to 1950s, when automotive marketers turned to cookbooks as a means of promoting their vehicles. Yes, cookbooks. We can't make this stuff up, folks.
This bizarre trend led to General Motors distributing cookbooks under the guise of its then-subsidiary Frigidaire. Ford, meanwhile, offered a compilation of recipes from Ford Credit Employees (shown above). The cookbook-craze wasn't limited to domestic manufacturers, though. As The Detroit News discovered, both Rolls-Royce and Volkswagen got in on the trend, although not until the 1970s.
The News has the full story on this strange bit of marketing. Head over and take a look.

Find out if the Ford Fiesta ST can match Europe's latest hot hatches

The V8 grunt of the Mustang has defined Ford performance cars in the US for the last 50 years, but in Europe, the Blue Oval has nearly as a long history of building some of the best hot hatches on the market with the Fiesta, Escort and later the Focus. The latest Fiesta ST has just hit the roads on both sides of the pond and has been enthusiastically received thanks to its combination of a peppy, turbocharged engine and hatchback utility.
However, Europe is getting a bumper crop of hot hatches at the moment, including the forthcoming, third-generation Mini Cooper S. Should Ford have waited to launch the ST until it knew how the competition performed? That's the answer that Xcar is after in its latest video, and it took the Fiesta to the track and some very misty, Welsh roads to find out. Scroll down to find out whether the ST stacks up.

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).