55 T-bird Conv 2 Tops on 2040-cars

Auto blog

Second-tier UAW workers promoted for first time after Ford hits quota

The United Auto Workers put out a statement on Friday that 55 Ford workers chosen by seniority would be moved from the Tier 2, entry-level pay rate of around $19 per hour to the Tier 1, non-entry-level rate of about $28 per hour. One of the stipulations in the 2011 UAW-Ford agreement was that only 20-percent of the total hourly workforce could be paid the Tier 2 wages agreed upon in 2007; after that, those workers had to be moved to Tier 1. Even so, the new Tier 1 status makes them less expensive to Ford than veteran Tier 1 workers because they receive fewer benefits. However, Automotive News had reported that same day that Ford was 69 workers shy of the limit, and when AN asked Ford about the situation Ford said it had "some room" on the entry-level roster. If workers do move to the higher pay grade, it will be the first time that's happened since the two-tier system was agreed. But it sounds like there's going to be some haggling between the UAW and Ford before that happens. Ford is the only one of the Detroit 3 automakers to have to work with a cap, since it didn't go through bankruptcy proceedings during The Great Recession; General Motors and Chrysler jettisoned the cap in 2009. GM is said to have 16 percent of its hourly workers at Tier 2 while Chrysler has 42 percent, but Fiat-Chrysler CEO Sergio Marchionne has long been opposed to the two-wage system. The UAW is preparing for its 2015 negotiations with the US automakers. It wants to eliminate the difference in pay by going to the higher scale, if there is a consensus among automakers it seems to be that they also want a single wage, but less than the higher scale, with the addition of profit-based bonuses. The recent statement from the labor union is below. UAW President Dennis Williams and UAW-Ford Vice President Jimmy Settles announced today that the union is delivering on its promise to convert workers DETROIT, Jan. 30, 2015 /PRNewswire/ -- UAW President Dennis Williams and UAW-Ford Vice President Jimmy Settles announced today that the union is delivering on its promise to convert workers making entry-level wages to traditional employees. "The 2011 UAW-Ford agreement allows for a contractual limit of entry-level employees. Once that threshold is surpassed, entry-level employees convert by seniority to 'regular, non-entry level employment.' At this time, fifty-five UAW-Ford workers will receive the wage increases, which put them in the category of non entry-level employment.

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.

Ford talking unibody Ranger replacement

Now here's some welcome news. Car and Driver reports Ford is seriously mulling a replacement for the recently deceased Ranger, but the successor to the compact pickup's throne may not look anything like what we've seen from the nameplate in the past.
While speaking at the 2013 Chicago Auto Show, Doug Scott, marketing manager for Ford Trucks, said there's still a market for a smaller pickup, but that buyers expect to see a larger differentiation between the smaller utility vehicles and their full size counterparts in price, capability and fuel economy.
According to Scott, that means a vehicle with a payload capacity of around 1,000 pounds paired with a towing capacity of 3,000 pounds and "a dramatic reduction in fuel consumption." But the biggest piece of that recipe is the price tag, and Scott says to keep the MSRP far enough away from the already cheap F-150, the answer could come in the form of a unibody design. Scott says target customers in this market don't care whether the truck has a traditional frame or not, so long as it's tough enough to do the job and has the capability they need.