1963 Ford Thunderbird Convertible Red on 2040-cars

Auto blog

NHTSA investigating Ford Fiesta for faulty door latches

The National Highway Traffic Safety Administration has opened a preliminary investigation on the 2011-2013 Ford Fiesta because the regulator has received 61 complaints from drivers, including one claim of an injury, about the doors on the subcompacts failing to latch and sometimes even flying open while driving. NHTSA has estimated that the problem could affect as many as 205,000 vehicles.
NHTSA is still gathering further data about the problem, but looking at the complaints so far, both front and rear doors appear to be potentially involved with the alleged failures. Among the reports, there are 12 claiming that the door opened while driving. Several also indicate the "Door Ajar" warning illuminating during this problem. The one purported injury happened when someone attempted to shut the door, and it bounced back.
Ford spokesperson Kelli Felker told Autoblog via email, "We are cooperating with NHTSA on this investigation, as we always do." Scroll down to read the report from NHTSA.

Ford car-camo artist works his craft on Australia's new Falcon XR8

Ford is among the kings of concealment when it comes to test cars. On one recent Mustang SVT mule, the automaker went to the extreme of putting baffles over the exhausts to hide how many there were. Sounds like a lot of work, right? In a new video, the Blue Oval has decided to take fans behind the scenes to show them what it takes to camouflage a prototype. In this case the subject was the recently unveiled 2014 Falcon XR8 for Australia.
Ford's prototype build coordinator Down Under has the very appropriate name of Neil Trickey, and it's his job to obfuscate the important bits of test cars to keep them out of spy shooters' camera lenses. Trickey calls his job a "dark art," and he shows off some of the tricks of his trade in the video. It turns out that the fabric we often see on mules is a type of lycra, but his team isn't above getting out a can of spray paint to conceal parts, too.
Scroll down to watch a video about a man who you probably wish could be a little worse at his job.

Tier 1 suppliers call GM the worst OEM to work with

Among automakers with a big US presence, General Motors is the worst to work for, according to a new survey from Tier 1 automotive suppliers, conducted by Planning Perspectives, Inc.
The Detroit-based manufacturer, which has been under fire following the ignition switch recall and its accompanying scandal, finished behind six other automakers with big US manufacturing operations. Suppliers had issues with trust and communications, as well as intellectual property protection. GM was also the least likely to allow suppliers to raise their prices in the face of unexpected increases in material cost, all of which contributed to 55 percent of suppliers saying their relationship with GM was "poor to very poor."
GM's cross-town competitors didn't fare much better. Chrysler finished in fifth place, ahead of GM and behind Dearborn-based Ford, which was passed for third place this year by Nissan. Toyota took the top marks, while Honda captured second place.