1963 Ford Thunderbird Convertible on 2040-cars

Auto blog

Ford exec downplays idea of aluminum-intensive cars

Ford certainly made waves when it rolled out the all-new 2015 F-150 made primarily out of aluminum. But while trimming weight off its vehicles is a top priority for the Detroit automaker, we shouldn't expect the lightweight metal to be used as widely on passenger cars as it has been on its new pickup. Speaking at the Automotive News World Congress on Wednesday, top Ford exec Joe Hinrichs said that using aluminum in passenger cars isn't as beneficial as it is in trucks – primarily because the weight savings isn't as dramatic, or as deeply needed. Though improved fuel economy is certainly one advantage of aluminum construction in a truck like the F-150, low prices at the pump have prompted Ford to highlight another advantage, and that's capability: With less weight on its own, a lighter-weight truck can carry and tow more than a heavier one, because it all comes down to combined weight ratings. Ford is expected to make the new F-Series Super Duty largely out of aluminum for the same reasons, and we wouldn't be surprised to see the next Expedition use the material as well. But while certain components in Ford passenger cars will be made of aluminum, we shouldn't expect entire chassis and bodywork assemblies to use the material as extensively as on the F-150, or on more upscale passenger cars from the likes of Audi or Jaguar. Dearborn is, however, investing in other lightweight materials. It has a joint venture with Dow Chemical to put carbon fiber into mass production, much as BMW has with its i3. The Blue Oval will use a combination of carbon and aluminum on its 2017 GT supercar, and it has stripped weight by removing amenities from the 2016 Mustang GT350R, but apparently neither is a method Ford can practically apply to its volume models. Related Video: Featured Gallery 2015 Ford F-150 View 36 Photos News Source: TheDetroitBureau.com, Automotive News - sub. req.Tip: Ford Green Ford aluminum joe hinrichs

NHTSA probing 2000-2003 Ford Taurus and Mercury Sable models over throttle issue

A potential issue with the speed control cable collar has got the 2003-20003 Ford Taurus and Mercury Sable under the spotlight of the National Highway Traffic Safety Administration. If the collar breaks it can cause the throttle to be stuck open.
The issue is limited to vehicles with the 3.0-liter V6 Duratec. There are just 50 complaints so far out of 310,000 cars, but the NHTSA has begun an investigation into whether a recall should be issued.

NHTSA closes probes on Jeep Grand Cherokee, Ford Freestar and Mercury Monterey

The Detroit News reports the National Highway Traffic Safety Administration has officially closed its investigations into 2012 Jeep Grand Cherokee, 2004-2005 Ford Freestar and Mercury Monterey models. The separate probes found no issues that pose safety concerns. NHTSA began investigating certain Grand Cherokee SUVs over complaints that power steering hoses could detach during operation, thereby increasing the risk of a vehicle fire. Of the 24 reports of failure, none alleged smoke or fire in the engine bay, and Chrysler has since modified the power steering cooler assembly to reduce the likelihood of the failure.
Meanwhile, certain Ford Freestar and Mercury Monterey vehicles garnered a government probe after receiving complaints that the models were equipped with faulty scissor jacks. The agency had received six reports of the jacks failing or causing injuries, including one incident that resulted in a fatality. But NHTSA says the jack failure rate is similar to those found in other vehicles. In those six cases, the government agency found the jacks were being used for something other than changing a tire, and investigators could not determine whether the emergency brake was set or the rear tires were properly chocked.