2003 Ford Taurus Sel Sedan 4-door 3.0l on 2040-cars

Auto blog

Check out Ford's fully automated self-parking car [w/video]

As automakers continue to find uses for autonomous and semi-autonomous vehicle technology, Ford of Europe has announced that it is developing a self-parking system for future use. More advanced than the Active Park Assist already offered in many Ford products, the new Fully Assisted Parking Aid can take full control of the vehicle and can navigate angled and perpendicular parking spots.
While today's Active Park Assist can only parallel park with the driver controlling the gas, brake and gear selection, Fully Assisted Parking Aid can operate steering, gas, brake and gear selection all while making sure the car is properly parked in the intended space. As with APA, the driver pushes a button to make the car look for a proper spot (at speeds of up to 18 miles per hour), and when an adequate space is located, the operator pushes another button (either inside the car or outside via remote control) for the car to park itself - the button must be pressed throughout the whole parking maneuver. Even though Ford says that the car can effect gear selections on its own, the system must still start from Neutral, and the automaker isn't saying whether the car can put itself into Park when done or put itself in Drive when the operator is ready to go.
Ford is also taking the opportunity to announce its new Obstacle Avoidance technology. This automated system is able to detect objects - including pedestrians - in the road, warn drivers of said objects and, if needed, stop and steer automatically to avoid hitting the obstacle. Both systems are still in the prototype phase, so there is no word as to when we could see either on a production vehicle.

Ford recalls 9,900 vehicles across two campaigns

Ford is recalling a total of 9,885 vehicles in two campaigns. The Basics: In one recall, Ford will recall 9,017 examples of the 2013 Escape with build dates from January 11, 2012, to April 1, 2013, and the 2013-2014 Focus ST produced between May 3, 2012, and October 14, 2013. The Problem: Splices in the engine wiring harness might not have enough compression, and this can cause the manifold absolute pressure sensor to send incorrect signals to the powertrain control module. This issue could cause the engine to stall. Injuries/Deaths: None reported. The Fix: Dealers will replace the current crimped splices with new splices, according to the National Highway Traffic Safety Administration. If You Own One: The repair campaign will begin on January 4, 2016. More Information: Ford recalled the 2013 Escape and Focus ST in August 2014 for the same problem, and this is an expansion of that campaign, according to company spokesperson John Cangany to Autoblog. The Basics: In the smaller of the two campaigns, Ford will recall 868 examples of the 2013 Explorer, Explorer Police Utility, Taurus, Taurus Police Interceptor, Flex, Lincoln MKS, and MKT. The Problem: The fuel delivery module can crack, which would cause a fuel leak. Injuries/Deaths: None reported. The Fix: Dealers will replace the fuel delivery module. If You Own One: Owners should receive notice soon because NHTSA's report says the recall begins in December. More Information: According to Cangany, this recall is an expansion of a campaign from 2013 for these vehicles. RECALL Subject : Engine Wiring Splices may cause Stall Report Receipt Date: DEC 02, 2015 NHTSA Campaign Number: 15V813000 Component(s): ELECTRICAL SYSTEM Potential Number of Units Affected: 9,017 All Products Associated with this Recall Vehicle Make Model Model Year(s) FORD ESCAPE 2013 FORD FOCUS 2013-2014 Details Manufacturer: Ford Motor Company SUMMARY: Ford Motor Company (Ford) is recalling certain model year 2013 Escape vehicles manufactured January 11, 2012, to April 1, 2013, and 2013-2014 Focus ST vehicles manufactured May 03, 2012, to October 14, 2013. Insufficient compression in the engine wiring harness splices to the Manifold Absolute Pressure (MAP) sensor may provide incorrect signals to the powertrain control module (PCM). CONSEQUENCE: The incorrect signals could cause the vehicle to hesitate or the engine to stall, increasing the risk of a crash.

Trump did talk to Bill Ford, but the Kentucky plant was never moving to Mexico

President-elect Donald J. Trump has been butting heads with Ford for a while now. A lot of it seems to stem from misunderstanding or misrepresenting facts about how the automaker currently does business and its plans for the future. After a sit-down with executive chairman Bill Ford Jr., the misunderstandings continue, but Trump has apparently convinced the company to make some changes. During his campaign, Trump claimed that Ford was going to fire US workers and move manufacturing to Mexico. That wasn't the case – yes, Ford planned to transfer Focus and C-Max production from Wayne, Michigan, to Cuautitlan, Mexico, but no, that wouldn't mean anyone losing their job. The Wayne plant will continue to operate, and likely busier than before, as it will be the home of the new Bronco and Ranger. So Ford CEO Mark Fields responded with the facts, and then chairman Bill Ford Jr. sat down with Trump over the summer. Things apparently weren't resolved to Trump's satisfaction, so he and Bill Ford spoke on the phone yesterday as he claims in this tweet: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Let's pick that apart. First off, it's not a Lincoln plant, per se – the Louisville Assembly Plant currently builds the Ford Escape and Lincoln MKC, two small crossovers that share a platform. Ford was considering moving MKC production out of Kentucky to Mexico, but it would not have resulted in many lost jobs if any – the union had already agreed to moving the MKC in 2015 negotiations, and taking production of the slow-selling Lincoln out of the plant would open up capacity for more Fords. Be that as it may, Ford has decided not to move MKC production out of the plant, either for political reasons of placation or because it didn't make the greatest deal of business sense, maybe a combination of the two. That means Trump isn't really saving any American jobs in the short term. If anything, this move could keep Ford supply-constrained and result in reduced sales, which in turn brings the company less money and affects the bottom line and all employees. But that's speculation, so we won't tweet it. There is of course the possibility that Ford will be convinced, either by sheer will or by a more attractive trade situation, to invest in increased US production, which could bear fruit later on. We are told by Ford that the two men did in fact speak yesterday.