2004 Ford Ranger Edge 4wd 4.0 Liter V6 Sharp Vehicle Look on 2040-cars

Auto blog

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

1969 Ford Talladega GPT Special is a SEMA showstopper

Rad Rides by Troy has unleashed upon the SEMA crowds this custom 1969 Ford Torino Talladega GT Special, and it's a beauty. The car calls to mind the classic Holman Moody stock cars that circled NASCAR tracks in the late 1960's, driven by the likes of Mario Andretti, Dan Gurney and David Pearson, who won the Grand National title in both 1968 and '69 in a Ford Torino.
Even though it has plenty of stock-car influence, there's nothing retro about the car's design or powertrain, other than the fact that the engine is based on a Ford Boss 429 block. Fuel injection, aftermarket aluminum heads and a high-tech custom computer system combine to send 750 reliable ponies to the rear wheels through a Tremec five-speed manual transmission. Brakes measure 14-inches all around, with six-piston Wilwood calipers up front and four-piston units out back.
There's custom bodywork abound, painted in a two-tone Tennessee Whiskey Gold and Daytona Sand finish. Check out all the amazing details in the image gallery below, and scroll down to read all about it in designer Troy Trepanier's own words.

Mustang Cobra Jet prototype garners $200k for charity at Barrett-Jackson

A few weeks ago we brought you news of a one-off Mustang Cobra Jet that Ford was donating to charity. The car was set to be auctioned off by Barrett-Jackson in Las Vegas to benefit the National Multiple Sclerosis Society. Now that auction has taken place, bringing in an impressive $200,000 for MS research.
That's a lot of zeros for a Mustang, much less one you can't even drive on the street. But the unique pony car, bearing serial number 2014 BJMS CJXX1, packs a 5.0-liter supercharged V8, competition gearbox, wheelie bar, roll cage... all you could want, in short, in a turn-key drag racer. And all that for a good cause.