1972 Ford Ranchero on 2040-cars

Auto blog

Ford Recalls Nearly 435,000 Vehicles

Ford is recalling nearly 435,000 cars and SUVs to fix rusting frame parts or faulty seats. The biggest of the two recalls covers nearly 386,000 Ford Escapes from the 2001 through 2004 model years. Ford says the subframes can rust, allowing a control arm to separate and hamper steering control. Ford is aware of one crash but no injuries linked to the problem. The SUVs were originally sold or registered in 20 states and Washington, D.C., where salt is used to clear snow and ice from roads. Six Canadian provinces also are included. Dealers will install a reinforcement brace to fix the problem. The Escapes covered by the recall were built from Oct. 22, 1999 through Dec. 19, 2003 at the Kansas City Assembly plant, and from May 1, 2003 through Jan. 23, 2004 at the Ohio Assembly plant, Ford said in a statement issued Monday. They were originally sold or registered in Connecticut, Iowa, Minnesota, Ohio, Wisconsin, Delaware, Maine, Missouri, Pennsylvania, Maryland, New Hampshire, Rhode Island, Illinois, Massachusetts, New Jersey, Vermont, Indiana, Michigan, New York, West Virginia and Washington, D.C. Also covered are Escapes sold or registered in Ontario, Quebec, Prince Edward Island, New Brunswick, Nova Scotia, and Newfoundland & Labrador. The second recall covers 49,000 Ford Fusion, Lincoln MKZ, Ford Escape and C-MAX vehicles from 2013 and 2014. Dealers will replace seat back frames that weren't welded properly. No crashes or injuries have been reported from the problem, Ford said. Recalls Ford

NHTSA closes investigations into Ford Taurus, Hyundai Santa Fe

Ford and Hyundai are out from under the scrutinizing eyes of the National Highway Traffic Safety Administration after the government agency said it was closing investigations against both automakers over vehicle safety concerns.
Ford was being investigated for reported damaged speed control cables on Ford Taurus (shown above) and Mercury Sable models, both built between 2000 and 2003. Vehicles with the company's Duratec engines allegedly failed to allow owners to brake as expected. Owners lodged 100 complaints and were involved in five accidents, according to NHTSA records. The American automaker responded to the reports, and on June 21 of this year, said that it would inspect and repair all affected vehicles, regardless of the mileage.
Hyundai was under investigation for a reported loose fastener on the steering shaft of its 2011 Santa Fe (shown in the gallery below). After NHTSA launched its inquiry, the Korean automaker responded with its own investigation that yielded four affected vehicles. Following the inspection of 680 vehicles at its assembly plant, Hyundai said the issue was due to employee error and that no further defects have been found.

Ford F-150 EcoBoost in NHTSA probe for acceleration issue

According to Automotive News, the National Highway Traffic Safety Administration is launching a probe into 400,000 Ford F-150 models over possible acceleration problems. According to the article, NHTSA has received 95 reports "alleging incidents of reduced engine power during hard accelerations" on 2011 to 2013 F-150 models equipped with the company's 3.5-liter EcoBoost V6 engine.
Automotive News reports that Ford has issued three technical service bulletins "related to intermittent stumble/misfire on acceleration from highway cruise in humid or damp conditions," according to the government agency's documents. About one third of the 95 reports NHTSA has received cited humid or rainy conditions when these problems allegedly occurred.
These technical service bulletins have allowed dealers to address a "condition related to moisture accumulation in the charge air cooler during extended highway cruising at constant throttle in humid or damp conditions," AN reports, citing NHTSA documents. Furthermore, the TSB outlines details for "reprogramming the powertrain control module with the latest calibration and installing a new CAC and air deflector plate."