Ford: Mustang 2dr Fastback Gt Premium on 2040-cars

Auto blog

Martini Mustang is a 'what if moment' gone right

Feast your eyes on a masterpiece. This is Steve Strope's Ford Mustang in the classic fastback bodystyle, and as you'll notice, it sports the signature colors of Martini Racing, a livery that's as legendary as any Gulf Racing-styled car. But the red, white and blues of the Martini stripe down this Mustang's middle tell only a very small part of the story, in the latest video from Petrolicious.
What would you guess is under the hood? A 289-cubic-inch V8? Maybe a 302, or some absurd Ford crate engine? Maybe Strope went all Tokyo Drift - he's actually responsible for the "Hammer" Plymouth Satellite driven by Vin Diesel at the end of the movie - and found an RB26DETT to drop into the pony car? You'd be wrong on all counts.
This mad, mad man somehow finagled a Ford-Lotus engine from a 1966 Indianapolis 500 car into the Mustang's engine bay. Yes, a Mustang with an engine designed for a 160-mile-per-hour, open-wheel racecar. That's like someone in 40 years dropping McLaren's 2.4-liter V8 from the MP4-28 into a Scion FR-S. It'd just make a monster.

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

John Hennessey's personal 2015 HPE700 Supercharged Ford Mustang GT hits 195 mph

Dressed in a coat of menacing black paint, the 2015 Hennessey Performance HPE700 Supercharged Ford Mustang GT definitely looks like one mean muscle machine. The 717-horsepower 'Stang proved that it can back up that aggressive appearance recently when company founder John Hennessey took his personal example to see just how fast it would go. The result down the 1.1-mile straight at the Continental Tires Proving Grounds in Uvalde, Texas, was over 195 miles per hour. The Mustang is nothing but a black blur and wall of supercharger wail as it buzzes by the camera at top speed. Despite the strong result, Hennessey doesn't seem done with the 'Stang yet. The car still seems to be pulling when it hits the rev limiter, and there's some straight track left ahead. After getting out, John Hennessey immediately says he thinks 200 mph is possible. The heart of the HPE700 is a 2.9-liter Roots-Type supercharger running at 7.25 psi. That's a pretty massive blower, especially when considering the 2.4-liter unit on the Hellcat V8. The engine also gets upgrades like improved injectors, a new fuel pump, stainless steel exhaust and recalibrated management. The company claims the upgraded Mustang can hit 60 in around 3.6 seconds and do the quarter-mile in 11.2 seconds at 131 mph. Prices for the package start at $59,500, but this one would would ring up for $65,874. Hennessey Performance is limiting production to 500 of them for the 2015 model year. 2015 HPE700 Supercharged Mustang Rockets to 195.2 mph John Hennessey takes his personal Mustang GT on a Texas road trip Uvalde, Texas-Everything is bigger in Texas, especially when it comes to automotive performance. Texas also lays claim to the highest posted speed limit in America at 85 mph. Enter the team from Hennessey Performance Engineering (HPE) who are located just west of Houston. John Hennessey and his merry band of performance car builders like to go fast, so much so that they have their own 1/4 mile dragstrip next to their workshop. Recently, the Hennessey team wanted to test their 717 horsepower HPE700 Supercharged Mustang development car (John's personal car and occasional daily driver) beyond the 130+ mph speeds that they have seen on the dragstrip. "Thankfully, we had recently received an invitation from the guys at the Continental Tires proving grounds in Uvalde to come over and do some testing on their 8.0 mile high speed oval", said Hennessey.