1969 Mustang 302 Hi Po, Barn Find ,project,ratrod,hotrod,*low Reserve,must Sell* on 2040-cars
San Andreas, California, United States
Body Type:COUP
Engine:302 HI PO
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:OWNER
Interior Color: GREY/WHITE
Make: Ford
Number of Cylinders: 8
Model: Mustang
Trim: 2 DOOR
Drive Type: REAR
Mileage: 30,000
Exterior Color: White
Warranty: Vehicle does NOT have an existing warranty
***LOW RESERVE****
THIS IS A 44 YEAR OLD CAR THAT NEEDS WORK
I HAVE THE TITLE IN HAND IF YOU WOULD LIKE TO SEE I DID NOT POST THE VIN DUE TO FACT THAT EBAY SCAMS ARE GETTING TOO FREQUENT
ALL VIN NUMBERS MATCH ON THE TITLE THE FRAME AND THE BODY,DOOR JAMB AND WINDSHILED DASH BOARD
NO OIL LEAKS,JUST REDID THE FRONT AND REAR MAIN SEAL ON THE TRANS.AND PUT IN A NEW FLEX PLATE AND STARTER..
1.THIS IS A GREAT RUNNING MUSTANG THAT HAS A NEWER 302 HI PO WITH ABOUT 30K MILES
2.IT IS A RUNNING AND DRIVING LITTLE PROJECT CAR
3.C4 AUTO TRANS
4.NICE HEADERS WITH FLOW MASTERS.
5.NEW STARTER.
6.EDELBROCK INTAKE WITH NEWER EDELBROCK CARB.
7.ALSO HAS NEW TIRES AND WHEELS.
8.INTERIOR IS IN GOOD SHAPE SEATS DOOR PANELS, HEADLINER ECT,CARPET IS DIRTY BUT SHOULD CLEAN UP OR YOU COULD REPLACE IT YOUR CHOICE
*****THIS CAR DOES RUN GOOD AND SOUNDS GREAT STARTS RIGHT UP AND DRIVES BUT NEEDS FRONT END WORK B4 YOU SHOULD DRIVE IT ANY DISTANCE.******
HERE IS A LIST OF WHAT NEEDS TO BE DONE..
1.FRONT END WORK ,I WOULD REBUILD THE FRONT END AND DO A ALIGHMENT
.2.NEEDS A NEW DASH PAD.AND PASS.SIDE DASH PIECE BELOW THE PAD,AND A HEATER BOX ON THE INSIDE I DO HAVE A NEW HEATER CORE FOT IT
3.I WOULD CHECK OUT THE BRAKES THEY WORK BUT I WOULD CHECK THEM OUT ANYWAY.
4.SEAT BACK ON DRIVERS SIDE IS BROKEN AND NEEDS REPAIR.
5.POWER STEERING WORKS BUT MAKES NOISE.
6.FINISH BODY WORK AND PAINT AGAIN IF YOU DESIRE TO DO SO OR DRIVE IT AS IS.
7.INSTALL PASS SIDE ARM REST.
8.FIX DRIVERS SIDE DOOR IT NEEDS HINGES AND HITS THE FENDER WHEN YOU OPEN IT....THIS FENDER AND DOOR NEED WORK.....THE OLD OWNER BENT THE FENDER TO GET THE DOOR OPEN
9. SMALL RUST REPAIR NEEDED ON PASS SIDE FRONT FLOOR BOARD ABOUT THE SIZE OF A ORANGE,I WILL NEED A PATCH REPAIR.
10.SOME GUAGES WORK SOME DO NOT
11.EMERGENY BRAKE NEEDS NEW CABLE.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
ALL LIGHTS WORK.....HEADLIGHTS HIGH AND LOW BEAM....TURN SIGNALS WORK ...BRAKE LIGHTS WORK...DASH LIGHTS WORK....
TRUNK IS RUST FREE NO RUST ISSUES (SEE PICS)
THIS CAR HAS A CLEAN CA. TITLE IT HAS 155.00 IN REG DUE IF IT IS SOLD IN CA I WILL PAY THIS FEE,IF THIS CAR IS SOLD OUT OF STATE THEN THEY ARE NOT REQUIRED TO BE PAID.
TITLE IS SIGNED OF BY PREVIOUS OWNER I TOOK THIS CAR ON A TRADE...FOR A MERCEDES I HAD FOR SALE....I HAVE NO DESIRE FOR MUSTANGS.....I AM A CHEVY GUY...
I HAVE THE TITLE IN HAND AND A COPY OF IT IF YOU WOULD LIKE TO SEE IT.
PLEASE READ THE ENTIRE ADD B4 YOU BID I DO NOT WANT A UNHAPPY BUYER...THIS IS A GREAT RUNNING PROJECT THAT WILL REQUIRE WORK B4 YOU PUT IT ON THE ROAD.....FRONT END WORK REQUIRED....
THIS IS A PROJECT THAT NEEDS LOVE BUT ITS A PRETTY EASY ONE TO DO ALL THE DRIVE TRAIN IS PRETTY RECENTAT 30K MILES.
I THINK THIS WAS AN ORIGINAL 6 CYLINDER AUTO CAR.....
I WILL WORK WITH ALL SHIPPERS DAY OR NIGHT AND STORAGE FOR 30 DAYS AFTER PURCHASE IS FINE WITH ME LONGER IF NEEDED IS OK TOO
PLEASE GIVE ME A CALL...WITH YOUR QUESTIONS...
I HAVE 100% FEEDBACK PLEASE FEEL FREE TO TAKE A LOOK I ONLY SELL REAL CARS NO B.S. TO SELL THEM........THESE CARS ARE FROM MY COLLECTION...I AM TRYING TO THIN THE HERD I HAVE NO ROOM TO KEEP THEM ALL
THANKS I HOPE THIS CAR GOES TO A MUSTANG LOVER THAT WANTS TO FINISH HER UP.... PRETTY EASY ONE TO DO I JUST DONT LIKE MUSTANGS SORRY :(
PLEASE GIVE ME A CALL OR EMAIL...OR TEXT....
THANK YOU,
BILL......(209) 304-7352
On Apr-13-13 at 13:57:01 PDT, seller added the following information:
I have been asked about the ear end in this car it has a ford 9" rear but I have no idea what the gear ratio is.
thanks,
Bill
On Apr-13-13 at 14:00:00 PDT, seller added the following information:
I have been asked about the rear end its a ford 9" but no idea what the gear ratio is
Thanks,
Bill
On Apr-16-13 at 07:59:54 PDT, seller added the following information:
here is a list of the bolt ons added to the motor I have has several questions about the motor in this car.
1.mild cam (no idea which one i dont have the cam card)
2.high rise edelbrock intake
3.edelbrock carb.
4.HEI electronic ignition.
5.8 MM spark plug wires
6.Headers.
7.New exhaust with flowmaster mufflers.
8.new starter and flex plate..
AND A B&M SHIFTER FOR THE TRANS.
******THANKS FOR THE INTEREST IN MY CAR........IT HAS MET RESERVE AND WILL BE SOLD TO THE HIGHEST BIDDER GOOD LUCK....THIS CAR IS SELLING ..........
THIS CAR RUNS STRONG AND SOUNDS VERY GOOD.......................
Ford Mustang for Sale
- 2013 ford mustang 5.0 boss 302 laguna seca black on black track key activated
- 2008 ford mustang shelby gt500 convertible 2-door 5.4l 4681 miles(US $39,900.00)
- 2013 ford mustang gt coupe 2-door 5.0l(US $29,995.00)
- Roush 427r manual convertible 4.6l cd 4.6l sohc 24-valve v8 engine torch red a/c(US $33,980.00)
- 1984 ford mustang gt low miles one owner
- 2003 ford mach 1 coupe 4.6l leather shaker hood am/fm/cd mach 460 etr abs brakes
Auto Services in California
Yoshi Car Specialist Inc ★★★★★
WReX Performance - Subaru Service & Repair ★★★★★
Windshield Pros ★★★★★
Western Collision Works ★★★★★
West Coast Tint and Screens ★★★★★
West Coast Auto Glass ★★★★★
Auto blog
Daimler consulting with Ford about 3-cylinder engines
Mon, 27 May 2013Soon enough, Ford will offer its 1.0-liter EcoBoost three-cylinder engine under the hood of the Fiesta here in the United States, building on the success of the small powerplant overseas. In fact, this success has caused other automakers to take notice, and according to Automotive News Europe, Daimler is now talking to Ford about this engine for use in its own products.
In other markets, Ford offers the 1.0-liter mill under the hood of the Focus (we had the chance to sample this package on our home turf), as well as the B-Max MPV. For this new collaboration, Daimler would use the turbo-three in the next-generation Smart ForTwo, as well as the Renault Twingo, which the German automaker will be collaborating on as part of its alliance with Renault-Nissan. Speaking to AN, a Mercedes-Benz engineer called the 1.0-liter mill an "interesting and impressive engine."
In exchange for details about the EcoBoost inline-three, Daimler will supply Ford with information regarding its Euro6 stratified lean-burn gasoline engine, which is found in the new E-Class sedan.
Ford builds one-off 50th anniversary Mustang Convertible for charity
Thu, 08 May 2014At the New York Auto Show this year, Ford revealed a special-edition Mustang to honor the iconic pony car's 50th anniversary. Only 1,964 highly symbolic examples will be made, all of them fixed-roof coupes. But the Blue Oval automaker has just announced that it's also building a single 50 Years edition convertible that it will raffled off for charity.
The first production example of the new Mustang Convertible to roll off the line this fall, this one-off will pack many of the features on the 50 Years coupe, including its white paintjob, chrome trim, aluminum dashboard, two-tone upholstery, contrast stitching, special 19-inch wheels and special-edition badging throughout.
This unique cabrio will also be fitted with a special performance pack including Pirelli PZero rubber, Brembo brakes and a limited-slip differential to help get the 420 horsepower and 390 pound-feet of torque from the 5.0-liter V8 through the six-speed manual transmission and down to the road. It'll also feature a serial plaque with the number 0001 of 0001 and chairman Bill Ford's signature.
Lincoln Continental production likely to shift to Flat Rock
Fri, Jun 12 2015Lincoln production may be returning to Michigan, according to a new report from Automotive News. While the brand's current big sedan, the MKS, is built alongside the Ford Taurus, Ford Explorer, and their Police Interceptor counterparts at the Blue Oval's Chicago, IL factory, the production version of the Continental won't be screwed together in the Windy City. According to AN, "industry sources" claim the Continental will join the Ford Mustang and Ford Fusion – on which the big Lincoln is loosely based – at the company's Flat Rock, MI factory. The move isn't just based on convenience, though. Ford is selling a lot of Explorers, and shifting Lincoln production away from Chicago Assembly frees up production capacity for the popular SUV. "Chicago Assembly Plant is vital to our global manufacturing footprint and will continue to manufacture the Ford Taurus, Ford Explorer and Police Interceptor vehicles even after we phase out production of the MKS in 2016," Ford told Automotive News. "We will continue to match production to demand." Looking at the numbers further backs up the argument against Lincoln production in Chicago. Last year alone, Ford built nearly 285,000 Explorers and over 73,000 Taurus sedans, compared to just 8,300 Lincolns. Finally, as AN tells it, Ford is almost telegraphing the Continental's arrival in Flat Rock. The facility has a four-week shut down scheduled from June 15 through July 13, which is twice as long as the typical summer vacation, while there's another two weeks off slated for September. Related Video: