1965 Ford Mustang 2+2 Fastback, A-code Car, 289 4bbl Automatic, Beautiful on 2040-cars

Auto blog

Ford cuts F-150 fuel use through CNG-capable fleet sales, EcoBoost

The possibility of $1-a-gallon fuel would make a lot of US governmental entities sit up and take notice. The state of Oklahoma and the city of Dallas are making that happen. Those two entities are buying up a bunch of Ford F-150 pickups retrofitted to run on compressed natural gas (CNG), all in the name of cost savings and emissions reduction. Oklahoma is buying 256 of the F-150s, while Dallas is buying another 65. The trucks, which cost between $6,000 and $9,500 to retrofit (on top of the original price), can run on either CNG or liquefied petroleum gas (LPG). And while that's a substantial hit, conversion costs are typically paid back in three years thanks to lower refueling costs. CNG prices are as low as $1.07 a gallon in parts of Oklahoma. How much lower? The national average price for CNG is about a buck and a half less than the $3.67 average per-gallon cost of gasoline. And CNG prices are as low as $1.07 a gallon in parts of Oklahoma, where CNG is plentiful. CNG also cuts tailpipe greenhouse gas emissions by about 20 percent compared with gasoline, while the retrofitted trucks can go as far as 450 miles from their CNG tanks in addition to the 300-mile range from their conventional tanks. That's useful in a bit state like Texas. This week, the US Energy Department trumpeted a $5.9-billion loan program that Ford accessed to upgrade its factories for production of its EcoBoost engines, noting that Ford has sold a half-million F-150 trucks with EcoBoost engines. Those trucks have collectively cut fuel use by almost 57 million gallons of gas during the past three-plus years. Check out Ford's press release on the F-150 purchases below and the Energy Department's statement about its loan program here. OKLAHOMA, DALLAS ORDER 300-PLUS CNG-CAPABLE FORD F-150 PICKUPS AS DEMAND GROWS FOR ALTERNATIVE FUEL OPTION The state of Oklahoma and its agencies to buy 256 Ford F-150 trucks prepped to run on compressed natural gas; Dallas orders 65 for its fleet 2014 F-150 available with gaseous-fuel prep option on 3.7-liter V6 engine; can run on CNG or liquefied petroleum gas (also called propane autogas) By summer, Ford will offer eight vehicles that can run on clean-burning, affordable CNG; the company is on track to sell more than 15,000 such vehicles in 2014 The state of Oklahoma, its agencies and the city of Dallas have ordered a total of 321 Ford F-150 pickups that can run on compressed natural gas.

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

Ford unveils all-new 2016 F-650 and F-750 at NTEA

Medium-duty work trucks might not be the most exciting vehicles, but they perform necessary jobs everyday. Ford is in the process of a complete refresh of its entire commercial vehicle lineup over the next 18 months, and it is debuting the all-new versions of its F-650 and F-750 trucks at the NTEA Work Truck Show in Indianapolis, IN.
"The all-new F-650/F-750 allow us to leverage our strengths and sales leadership in Classes 1 to 5 to create a better F-650/F-750 that's designed, engineered and built by Ford in the USA," said Ford spokesperson Mike Levine to Autoblog via email.
Huge amounts of torque is vital for trucks like these, and both models are offered with some of Fords biggest engines. Buyers can opt for either the 6.7-liter Power Stroke V8 diesel with TorqShift 6-speed automatic with available power takeoff or a gasoline-fueled 6.8-liter V10 with a 6-speed automatic. The V10 can also be ordered from the factory to be fueled by compressed natural gas or liquid propane gas.