1965 Ford Mustang 1965 Ford Mustang 289 Manual Transmission on 2040-cars

Auto blog

Rising aluminum costs cut into Ford's profit

When Ford reports fourth-quarter results on Wednesday afternoon, it is expected to fret that rising metals costs have cut into profits, even as rivals say they have the problem under control. Aluminum prices have risen 20 percent in the last year and nearly 11 percent since Dec. 11. Steel prices have risen just over 9 percent in the last year. Ford uses more aluminum in its vehicles than its rivals. Aluminum is lighter but far more expensive than steel, closing at $2,229 per tonne on Tuesday. U.S. steel futures closed at $677 per ton (0.91 metric tonnes). Republican U.S. President Donald Trump's administration is weighing whether to impose tariffs on imported steel and aluminum, which could push prices even higher. Ford gave a disappointing earnings estimate for 2017 and 2018 last week, saying the higher costs for steel, aluminum and other metals, as well as currency volatility, could cost the company $1.6 billion in 2018. Ford shares took a dive after the announcement. Ford Chief Financial Officer Bob Shanks told analysts at a conference in Detroit last week that while the company benefited from low commodity prices in 2016, rising steel prices were now the main cause of higher costs, followed by aluminum. Shanks said the automaker at times relies on foreign currencies as a "natural hedge" for some commodities but those are now going in the opposite direction, so they are not working. A Ford spokesman added that the automaker also uses a mix of contracts, hedges and indexed buying. Industry analysts point to the spike in aluminum versus steel prices as a plausible reason for Ford's problems, especially since it uses far more of the expensive metal than other major automakers. "When you look at Ford in the context of the other automakers, aluminum drives a lot of their volume and I think that is the cause" of their rising costs, said Jeff Schuster, senior vice president of forecasting at auto consultancy LMC Automotive. Other major automakers say rising commodity costs are not much of a problem. At last week's Detroit auto show, Fiat Chrysler Automobiles NV's Chief Executive Officer Sergio Marchionne reiterated its earnings guidance for 2018 and held forth on a number of topics, but did not mention metals prices. General Motors Co gave a well-received profit outlook last week and did not mention the subject. "We view changes in raw material costs as something that is manageable," a GM spokesman said in an email.

2015 Ford Expedition stays the course, adds EcoBoost power

The era of the body-on-frame, fullsize SUV is rapidly vanishing in favor of smaller, unibody crossovers. However, Ford still sees life in the segment with the reveal of the updated 2015 Expedition, now available (solely) with the company's 3.5-liter EcoBoost V6. The new truck will make its public debut at the 2014 DFW Auto Show in Dallas on February 19.
The loss of the previous 5.4-liter V8 in favor of Ford's 3.5-liter, direct-injected, twin-turbocharged V6 engine might rankle some of the Expedition's fans, but Ford claims that the change gives the SUV better fuel economy, more power and increased low-end torque than before. Unfortunately, official engine specifications won't be released until later this year, but Ford says engine output will be similar to the 365 horsepower and 360 pound-feet of torque that this powerplant produces in other applications. The EcoBoost is mated to a six-speed automatic transmission, and the SUV now uses electrically assisted power steering, for an even greater fuel economy advantage. Ford claims this also allows for better maneuverability at low speeds and better feel at high speeds.
Exterior styling is basically unchanged for 2015. The front end has the same three-bar chrome grille and headlight design, but the lower air dam gets added chrome and LED lamps. The rear gets more brightwork on the hatch, and there's a chrome-tipped exhaust pipe. As before, Ford is offering the Expedition in two wheelbase lengths - 119 inches and 131 inches. A new, optional, continuously controlled damping system alters suspension settings constantly based on 46 parameters and offers comfort, normal and sport modes (just like the Expedition's sister, the recently refreshed and decidedly less-attractive Lincoln Navigator).

The next-generation wearable will be your car

This year's CES has had a heavy emphasis on the class of device known as the "wearable" – think about the Apple Watch, or Fitbit, if that's helpful. These devices usually piggyback off of a smartphone's hardware or some other data connection and utilize various onboard sensors and feedback devices to interact with the wearer. In the case of the Fitbit, it's health tracking through sensors that monitor your pulse and movement; for the Apple Watch and similar devices, it's all that and some more. Manufacturers seem to be developing a consensus that vehicles should be taking on some of a wearable's functionality. As evidenced by Volvo's newly announced tie-up with the Microsoft Band 2 fitness tracking wearable, car manufacturers are starting to explore how wearable devices will help drivers. The On Call app brings voice commands, spoken into the Band 2, into the mix. It'll allow you to pass an address from your smartphone's agenda right to your Volvo's nav system, or to preheat your car. Eventually, Volvo would like your car to learn things about your routines, and communicate back to you – or even, improvise to help you wake up earlier to avoid that traffic that might make you late. Do you need to buy a device, like the $249 Band 2, and always wear it to have these sorts of interactions with your car? Despite the emphasis on wearables, CES 2016 has also given us a glimmer of a vehicle future that cuts out the wearable middleman entirely. Take Audi's new Fit Driver project. The goal is to reduce driver stress levels, prevent driver fatigue, and provide a relaxing interior environment by adjusting cabin elements like seat massage, climate control, and even the interior lighting. While it focuses on a wearable device to monitor heart rate and skin temperature, the Audi itself will use on-board sensors to examine driving style and breathing rate as well as external conditions – the weather, traffic, that sort of thing. Could the seats measure skin temperature? Could the seatbelt measure heart rate? Seems like Audi might not need the wearable at all – the car's already doing most of the work. Whether there's a device on a driver's wrist or not, manufacturers seem to be developing a consensus that vehicles should be taking on some of a wearable's functionality.