1965 Ford Mustang on 2040-cars

Auto blog

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

Nuclear-powered concept cars from the Atomic Age

In the 1950s and early 60s, the dawn of nuclear power was supposed to lead to a limitless consumer culture, a world of flying cars and autonomous kitchens all powered by clean energy. In Europe, it offered the then-limping continent a cheap, inexhaustible supply of power after years of rationing and infrastructure damage brought on by two World Wars.
The development of nuclear-powered submarines and ships during the 1940s and 50s led car designers to begin conceptualizing atomic vehicles. Fueled by a consistent reaction, these cars would theoretically produce no harmful byproducts and rarely need to refuel. Combining these vehicles with the new interstate system presented amazing potential for American mobility.
But the fantasy soon faded. There were just too many problems with the realities of nuclear power. For starters, the powerplant would be too small to attain a reaction unless the car contained weapons-grade atomic materials. Doing so would mean every fender-bender could result in a minor nuclear holocaust. Additionally, many of the designers assumed a lightweight shielding material or even forcefields would eventually be invented (they still haven't) to protect passengers from harmful radiation. Analyses of the atomic car concept at the time determined that a 50-ton lead barrier would be necessary to prevent exposure.

J Mays retiring from Ford design, succeeded by Moray Callum

Ford's highly influential head of design, J Mays, has announced that he'll be retiring from his position after 33 years in the industry, 16 of which were at the Dearborn, MI-based company. Upon departure, he'll be succeeded as group vice president of design by Moray Callum. If that last name sounds familiar, yes, he's the brother of Jaguar's Ian Callum.
It's difficult to explain just how big of a role Mays had on not just Ford's design over the years, but on the entire industry. Before heading to Dearborn, Mays worked for Audi, BMW and then Volkswagen, where he was involved in concept cars that paved the way for design icons like the first-generation Audi TT and the Volkswagen New Beetle. As for his Ford resume, it's extensive.
Mays joined the company in 1997 as design director for Ford, Lincoln, Mercury and Mazda, as well as the Premier Automotive Group (Volvo, Land Rover, Jaguar and Aston Martin). He was heavily involved in the Ford Fusion, Focus, Fiesta, Taurus, F-150 and Mustang, while also contributing to concept cars like the Atlas, Evos, 427, Forty-Nine, Shelby GR-1, Lincoln MKZ and the MKC.