Find or Sell Used Cars, Trucks, and SUVs in USA

1964 1/2 Ford Mustang Convertible-same Owner Since 1989-fresh Restoration! on 2040-cars

Year:1965 Mileage:84215
Location:

Saint Louis, Missouri, United States

Saint Louis, Missouri, United States
Vehicle Title:Clear
For Sale By:Dealer
Engine:289 CID V8
Condition:
Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ...
VIN (Vehicle Identification Number)
: 5F08D215853
Year: 1965
Drive Type: RWD
Make: Ford
Mileage: 84,215
Model: Mustang
Trim: CONVERTIBLE

Auto Services in Missouri

Wise Auto Repair ★★★★★

Auto Repair & Service
Address: 1302 Erie St, Pleasant-Valley
Phone: (816) 474-3825

Wicke Auto Service & Body Co ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Inspection Stations & Services
Address: 453 N Newstead Ave, Breckenridge-Hills
Phone: (314) 533-0339

Vincel Infiniti ★★★★★

Used Car Dealers
Address: 3500 E Sunshine St, Fair-Grove
Phone: (901) 745-9600

Union Tires & Wheels ★★★★★

Auto Repair & Service, Tire Dealers
Address: 2348 Central Ave, Independence
Phone: (913) 342-3599

Truck Centers Inc ★★★★★

New Car Dealers, Used Car Dealers, New Truck Dealers
Address: 747 E Taylor Ave, Breckenridge-Hills
Phone: (314) 381-3800

Tri -Star Imports ★★★★★

New Car Dealers, Used Car Dealers
Address: 16360 Truman Rd, Crescent
Phone: (636) 489-2532

Auto blog

NHTSA closes Ford F-Series Super Duty steering probe without recall

Wed, 05 Feb 2014

The National Highway Traffic Safety Administration's investigation into 2008 Ford F-250 and F-350 Super Duty pickups, which was originally opened last year, has now ended without a recall. NHTSA was looking into steering failures on some 336,000 trucks.
The issue rested with the steering gear - NHTSA received five complaints of failures - which was redesigned in 2005. According to the report on the matter, investigators "found evidence of broken sector shaft gear teeth and piston damage consistent with incidents of single event overload."
NHTSA investigators, however, "found no evidence of fatigue or material property defects in any of the fractures. Analysis of complaint rates by vehicle build month showed no patterns indicating potential manufacturing quality issues and no difference before and after Ford introduced design changes to the input shaft and sector shaft seals in July 2007 to address potential leak concerns," according to the report, obtained by The Detroit News.

2015 Ford F-150 claims segment's best payload, towing ratings

Mon, 29 Sep 2014

While we are set to drive the new, 2015 Ford F-150 in the coming days, there's a big piece of news on the latest-generation of the Blue Oval's bread-and-butter pickup coming out of Dearborn, and it focuses on the truck's hauling and towing abilities.
The new F-150 will have a maximum payload of 3,300-pounds (V8 models), and, perhaps more importantly, a 12,200-pound tow rating (EcoBoost V6 models), which for the first time are compliant with the Society of Automotive Engineer's J2807 standards. Those best-in-class figures are significant feathers in Ford's cap as the Detroit Three continue duking it out for the title of top pickup.
"As founding members of the SAE trailer towing committee, we will meet SAE trailer towing standards," Ford's Aaron Miller told Autoblog.

Detroit 3 and UAW set for showdown over tiered wages

Mon, Mar 23 2015

This week, thousands of United Auto Workers will converge on Cobo Center in Detroit for the Special Convention on Collective Bargaining, an every-four-year event that lets members tell UAW leaders what the negotiating priorities should be during contract negotiations. This is where a lot of sand and a lot of lines start coming together in preparation for contract negotiations between the UAW and the Detroit 3 automakers, which will happen later this year. Number one on the UAW agenda is the end of the two-tier wage system created in 2007 to help the automakers get through bankruptcy; veteran workers are paid the Tier 1 rate of around $29.00 per hour, new hires are paid the Tier 2 rate of between $15 and $20 and get about half the benefits of Tier 1. Tier 2 hiring has been an undoubted success for the automakers, allowing them to keep factories in the US and hire more workers. By agreement, it is capped at a certain percentage of each automaker's workforce, and while the union's ultimate position is to get rid of the dual-scale system entirely; one leader said Ford could easily afford the $335 million it would take to convert all its workers to Tier 1 out of its $6.9 billion in 2014 North American profit, and General Motors could do the same out of the $5 billion it is handing to investors through the (admittedly forced) share buyback. Other delegates say that at the very least they'd be happy with enforcement of the current caps in the new contract. The automakers, conversely, would welcome expansion of the Tier 2 ranks. Including benefits, import automakers pay workers "in the high $40 range" per hour, according to an analyst, while Ford and GM pay about $59 in wages and benefits per hour. More Tier 2 workers on the rolls would let those two companies get labor cost parity with the competition. Fiat-Chrysler pays wages closer to the imports because of special exceptions in its UAW contract that allow unlimited Tier 2 hiring; those exceptions will end on September 14 and bring FCA into line with the other domestics, unless the new contract maintains them. FCA CEO Sergio Marchionne is opposed to the two-tier system, having called it "almost offensive." One analyst says the UAW might win a sizable pay raise for Tier 2 and a small increase for Tier 1, but the keystone issue will be how the hiring matrix can help the automakers keep overall wages in line with the imports.