Find or Sell Used Cars, Trucks, and SUVs in USA

1931 Ford Model A Tudor Coupe on 2040-cars

Year:1931 Mileage:122222
Location:

Bay Minette, Alabama, United States

Bay Minette, Alabama, United States
Advertising:

Nice original 1931 Ford Model A Tudor Coupe. Has original wood (except floorboards) and original doors. Also has original gas tank. $500 deposit through paypal within 48 hours of auction close, remaining balance to be paid in cash within 7 days. Can assist with loading. Questions call 251-232-9594. This vehicle does not have a Title. Do not know actual mileage.

Auto Services in Alabama

Tucker Glass ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Windshield Repair
Address: 435 Prophecy Ln, Springville
Phone: (205) 907-4083

Stephenson Tire & Alignment Inc ★★★★★

Auto Repair & Service, Tire Dealers, Wheel Alignment-Frame & Axle Servicing-Automotive
Address: 1954 Florence Blvd, Florence
Phone: (256) 767-4113

Southside Automotive ★★★★★

Auto Repair & Service
Address: 2806 Dartmouth Ave, Midfield
Phone: (205) 683-1624

Smith`s Transmission ★★★★★

Auto Repair & Service, Auto Transmission, Automobile Consultants
Address: 2514 E Central St, Smiths
Phone: (706) 689-3346

Silverhill Auto Repair ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Tire Dealers
Address: 16125 Silverhill Ave, Silverhill
Phone: (251) 947-3397

Scottsboro Tire & Auto Repair ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Tire Dealers
Address: 504 S Broad St, Rainsville
Phone: (256) 259-2505

Auto blog

NHTSA investigating Ford's solution to May 2014 power steering recall

Tue, Apr 7 2015

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.

NHTSA closes Ford F-150 EcoBoost acceleration probe

Mon, 14 Apr 2014

Typically when we report on the findings of an investigation from the National Highway Traffic Safety Administration, it's because the government body has discovered a safety issue and prescribed a recall. In this case, however, NHTSA has closed an investigation into a reported performance deficit without ever getting to the recall stage.
The issue revolves around the Ford F-150 - specifically those equipped with the 3.5-liter EcoBoost engine - of which some 360,000 were built in the 2011, 2012 and 2013 model years. After receiving an initial 95 complaints, NHTSA opened an investigation last May - almost a year ago - into the reported issue of reduced engine power under hard acceleration. The agency has since received a total of 525 such complaints, and Ford itself reported receiving over 4,000.
Together, NHTSA and Ford determined that the problem resulted from cylinders misfiring, an issue itself stemming from water getting into the charge air cooler (CAC) mated to the turbochargers. In particularly humid or rainy conditions, water was found to get into the CAC, causing some of the cylinders to misfire, which in turn triggered the ECU to disable those cylinders in order to protect the catalytic converter from damage.

Ford to spread all-wheel drive across performance range

Tue, Feb 10 2015

Car and Driver took a closer look at the all-wheel-drive system in the Focus RS, Ford reps having made "broad hints" about it being applied to other performance vehicles. One spokesperson even said that he "can see this as one of those technologies of the future." That would make sense because, as C/D notes, it couldn't have been an inexpensive job to engineer the torque-vectoring unit for the Focus – one that can send 70 percent of torque to the rear wheels, and send 100 percent of that portion to either wheel if needed. C/D also clues into the system's close similarity to the AWD unit in the recently updated Range Rover Evoque, which is manufactured by Sweden's GKN Driveline. In the Evoque, torque vectoring is brake based and two electronically controlled clutches turn the Range into a front-wheel-drive crossover under 22 miles per hour. Ford wouldn't comment on the GKN Driveline connection, or even if there is one. No matter where it might come from, more performance Fords are good for every enthusiast, and we do not look an AWD, torque-vectoring gift horse in the mouth. Featured Gallery 2016 Ford Focus RS News Source: Car and Driver Ford Technology Hatchback Performance