1930 Ford Model A Standard 4 Door Sedan on 2040-cars
Zimmerman, Minnesota, United States
Vehicle Title:Rebuilt, Rebuildable & Reconstructed
Make: Ford
Drive Type: rear wheel
Model: Model A
Mileage: 99,999
Trim: standard 4 door
this sedan is very solid, the wood is very good except the roof bows are bad, the seats are there but needs interior refurbish. the front crossmember is bad but a good one goes with it. the front end is apart to replace crossmember but didn't get finished. motor and trans is there but out. no headlights or bar and no horn. I have wheels for the front to roll but no tires. tires are on back. this is a murray body. There is NO TITLE. Bill of sale only
Ford Model A for Sale
- 1929 ford model a rat rod cruiser(US $13,900.00)
- 1929 ford model a coupe rumble seat runs great
- Ratrod
- 1931 model a cabriolet(US $46,500.00)
- 1930 ford model a coupe(US $8,000.00)
- '31 ford coupe, chop top, street legal, ex-drag car
Auto Services in Minnesota
T K Automotive ★★★★★
Steve`s Alignment Service ★★★★★
St. Paul Automotive ★★★★★
R.B. Auto ★★★★★
R & S Automotive ★★★★★
Napa Auto Parts - Genuine Parts Company ★★★★★
Auto blog
2013 Ford Mustang V6
Mon, 10 Jun 2013Secretary Trim, Evolved
There was a time not so long ago when opting for a base Ford Mustang meant getting little more than some sheetmetal, an anemic four-cylinder engine and what may very well have been the world's most disappointing automatic transmission. During the Fox Body years, Ford seemed hell-bent on living up to Carroll Shelby's derogatory description of the coupe as little more than a runabout for demure office assistants, and the result was a base model with fewer sporting intentions than a Dilbert day calendar.
Some 20 years later, hopping behind the wheel of an entry-level pony is an entirely different experience. With all of the menacing aesthetics of the brawnier GT, a well-equipped interior and a drivetrain that toes the line between efficiency and power better than few before it, the 2013 Ford Mustang V6 is an attractive option for buyers in the big coupe market. But is it attractive enough to forgo the beastly GT?
Ford Fiesta ST GRC Racecar is hungry for podiums in 2013
Thu, 07 Feb 2013As we reported earlier, the Chicago showing of this plucky Ford Fiesta ST GRC racer points to bigger and brighter days for Global RallyCross. For the upcoming season, you can expect to see Ken Block and Tanner Foust both driving the Ford racecar, and if last season's results are any indication, you can anticipate quite a few podium appearances, as well.
The Fiesta seen here was built by the Swedes at OlsbergsMSE, and will be driven in anger by Foust in 2013. Modifications are, as you'd expect, extensive, and include an engine, exhaust and braking upgrades, a racing style short-throw shifter and a limited-slip differential. As you can see, the car has been fully stripped out and caged for maximum speed and safety, too.
Refresh your memories with the details of the car, in the press releases below. And if you head out to the Chicago Auto Show this year, don't forget to drop by the Ford stand to have a look.
Performance CNG wants to crowdfund natural gas-powered Ford Mustang
Fri, May 16 2014Soliciting investments to develop a street-legal compressed natural gas (CNG) powered Ford Mustang that can deliver 470 horsepower certainly wouldn't make sense on a site called Indiestopstop. Nope, Indiegogo is the more-appropriately-named site that one Michigan entrepreneur is using to try and crowdfund his CNG 'Stang. He's looking to raise $55,000. Michigan's Daryl Patrishkoff and his company Performance CNG LLC showed off their converted 2003 Mustang last year at the Woodward Dream Cruise in Royal Oak, MI in an effort to get some exposure for the car, which can run on both gas and CNG. The company and its three-man team is looking to further develop the project in the name of a fueling source that is 40 percent cheaper than gasoline, throws off as much as 30 percent fewer tailpipe greenhouse gas emissions and makes the country less dependent on foreign oil. Performance CNG estimates that just 120,000 of the world's 15 million CNG-powered vehicles are in the US and is calling for more. As for the $55 grand, Patrishkoff estimates that more than half of that amount would be committed to the Environmental Protection Agency (EPA) testing of emissions, fuel economy and horsepower. The problem? As of right now, only $150 has been raised. Check out Performance CNG's press release below and see the fundraising effort on Indiegogo here. Eco-Friendly Muscle Car? CNG vehicles save money, emit less pollution and creates jobs from American-mined fuel SHELBY TOWNSHIP, Mich., May 5, 2014 /PRNewswire/ -- Daryl Patrishkoff of Shelby Township, MI, has a vision for the American automotive industry. He firmly believes that our fuel of choice should be Compressed Natural Gas (CNG), not gasoline. Until the full CNG infrastructure is in place a Bi-Fuel vehicle, fueled by either CNG or gasoline upon the drivers command, is the bridge vehicle that can lead this transition. Patrishkoff heads up a (3) man technical team developing this technology. The advantages are: 40 percent savings in fuel costs at the pump 25-30 percent reduction in harmful emissions 100 percent US provided natural gas Meaningful employment for the US economy The most important benefit, however, is that a CNG-powered vehicle runs on fuel that can be mined in America, eliminating the need for foreign oil. "After decades of political rhetoric, these types of vehicles can truly lead the US to energy independence," he said.