1966 Ford Galaxy 500 390 Hp 4 Door on 2040-cars

Auto blog

Ford dealers offered discounts on tools to fix aluminum

With the introduction of the aluminum-bodied 2015 Ford F-150 (and the likely use of aluminum in future Ford products), Ford is looking to help its dealerships reduce costs related to repairing this more labor-intensive material. Automotive News is reporting that Ford dealers with body shops will require an estimated $30,000 to $50,000 in equipment and training to work on aluminum, and to help alleviate the financial burden of the new F-150, Ford has announced a special 20-percent discount on this equipment.
Dealers will be able to save up to $10,000 on tools such as welders, air-filtration systems and rivet guns and to create aluminum-specific work stations. The new F-150 goes on sale in the fourth quarter, and dealers have until October 31 to take advantage of this deal, according to the report.

Ford F-150 EcoBoost in NHTSA probe for acceleration issue

According to Automotive News, the National Highway Traffic Safety Administration is launching a probe into 400,000 Ford F-150 models over possible acceleration problems. According to the article, NHTSA has received 95 reports "alleging incidents of reduced engine power during hard accelerations" on 2011 to 2013 F-150 models equipped with the company's 3.5-liter EcoBoost V6 engine.
Automotive News reports that Ford has issued three technical service bulletins "related to intermittent stumble/misfire on acceleration from highway cruise in humid or damp conditions," according to the government agency's documents. About one third of the 95 reports NHTSA has received cited humid or rainy conditions when these problems allegedly occurred.
These technical service bulletins have allowed dealers to address a "condition related to moisture accumulation in the charge air cooler during extended highway cruising at constant throttle in humid or damp conditions," AN reports, citing NHTSA documents. Furthermore, the TSB outlines details for "reprogramming the powertrain control module with the latest calibration and installing a new CAC and air deflector plate."

William Clay Ford Sr. dead at 88

William Clay Ford, retired vice chairman of Ford Motor Company and the last surviving grandchild of company founder Henry Ford, died this morning after a bout with pneumonia. He was 88.
Ford spent 57 years with his grandfather's company, joining the board of directors in 1948 before graduating from college. Ford also held a position as chairman of the design committee, as well as the chairman of the executive committee and vice chairman of the Board of Directors during his tenure with the company. In a 2013 Detroit Free Press story, retired CFO Allan Gilmour said Ford had an eye for design, and was once able to pick out when a fiberglass model of a Ford Contour was asymmetrical, off by an inch on one side. He retired and assumed the position of director emeritus in 2005.
"My father was a great business leader and humanitarian who dedicated his life to the company and the community," said Bill Ford, Jr., Ford's current executive chairman. "He also was a wonderful family man, a loving husband, father, grandfather and great-grandfather. He will be greatly missed by everyone who knew him, yet he will continue to inspire us all."