Ford Fusion 2012 - 4-speed Auto- 2wd- 4-cylinder Gas- Warranty Books on 2040-cars

Auto blog

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

Airbag recall widens to include BMW, Chrysler, Ford and Toyota

The recall of faulty airbag inflators supplied by Takata has exploded today to grow to seven automakers. In most cases, only models in certain high-humidity regions were affected because the National Highway Traffic Safety Administration found in its investigation that moisture played a roll in determining whether there would be a problem. However, some companies opted for national campaigns. The exact number of affected models for these campaigns isn't yet known at this time.
BMW is recalling an undisclosed number of 325i, 325Xi, 330i and 330Xi models from the 2001 through 2005 model years and the 2001-2006 model year versions of the 325Ci and 330Ci for the driver side and passenger side inflators. Only vehicles currently registered in Florida, Puerto Rico, Hawaii and the US Virgin Islands are covered under this recall.
Neither Chrysler's filing with NHTSA nor its press release list the specific models affected, but a company spokesperson told Autoblog that at this time it only covers the driver and passenger side inflators for the 2006 Dodge Charger in Florida, Puerto Rico, Hawaii and the US Virgin Islands

Ford car-camo artist works his craft on Australia's new Falcon XR8

Ford is among the kings of concealment when it comes to test cars. On one recent Mustang SVT mule, the automaker went to the extreme of putting baffles over the exhausts to hide how many there were. Sounds like a lot of work, right? In a new video, the Blue Oval has decided to take fans behind the scenes to show them what it takes to camouflage a prototype. In this case the subject was the recently unveiled 2014 Falcon XR8 for Australia.
Ford's prototype build coordinator Down Under has the very appropriate name of Neil Trickey, and it's his job to obfuscate the important bits of test cars to keep them out of spy shooters' camera lenses. Trickey calls his job a "dark art," and he shows off some of the tricks of his trade in the video. It turns out that the fabric we often see on mules is a type of lycra, but his team isn't above getting out a can of spray paint to conceal parts, too.
Scroll down to watch a video about a man who you probably wish could be a little worse at his job.