2013 Ford Fusion Titanium Sedan 4-door 2.0l on 2040-cars

Auto blog

Ford, GM to collaborate on 9- and 10-speed transmissions

Back in October, there were reports that General Motors and Ford Motor Company were hard at work co-developing new nine- and ten-speed automatic transmissions, and now both automakers have confirmed this joint operation. While there are no specific vehicles mentioned to receive either transmission, a collaborative press release issued by GM and Ford mention that the transmission will be designed for front- and rear-wheel-drive cars, crossovers, trucks and SUVs.
These aren't the first powertrain components developed jointly between these cross-town rivals, either. The six-speed automatic currently used in vehicles like the Ford Edge, Ford Fusion, Chevrolet Cruze and Chevrolet Equinox was engineered in a similar fashion. As is the case with this existing transmission, both automakers will assist in the design, development and testing of the new transmissions, but each will build its own units in its own factories. Scroll down for the official press release.

Shelby to auction 2012 GT350 No. 1 in Vegas

With Shelby preparing to wind down production of its brutal GT350, a 624-horsepower Mustang that's meant to go up against the Roush Stage 3 in the world of tuned Ford ponycars, the Las Vegas-based tuner is looking to give back to one lucky customer. It'll auction off the very first GT350 ever produced, at the 2013 Barrett-Jackson auction in Las Vegas, a three-day event that runs from September 26 through September 28.
The GT350 is a monster, with a 5.0-liter, supercharged V8 that's been tuned well past 600 horsepower in a time when Ford's own Shelby-branded GT500 barely reached 550 horsepower. The GT350 is much louder than Ford's effort, too, both visually and audibly. The wide body look isn't what we'd call conventional, but on a car that sounds and goes like this, something extreme is needed. According to Shelby American's vice president of production, Gary Davis, "Carroll was very excited about the new wide body option, so that was included on this car. It's the first 2012 GT350 serial number from our anniversary year. It is a very special car." Wilwood brakes, a massaged suspension, and some very fat, sticky tires add to the Shelby experience.
This particular GT350 will be lot number 750, and will cross the Barrett-Jackson stage on Sunday, September 28.

2014 Ford Transit unveiled in Chassis Cab and Cutaway versions

As a leader in commercial vehicles here in the US, we knew Ford wouldn't take too long to show off the chassis cab and cutaway versions of its 2014 Ford Transit van. Set to go on sale this fall, Ford already revealed the full-body version of the Transit, and now it has pulled the cover off exposed-frame models just in time to to compete against the all-new Ram Promaster.
The term "chassis cab" refers to models with a fully enclosed cabin used for box vans or rental trucks, while cutaway models leave the cabin open behind the B-pillars for a pass-through on vehicles such as Class C motorhomes or ambulances. Both will offer three wheelbase options (138, 156 and 178 inches), the choice of single or dually rear axles, and plenty of upfitter-friendly touches including a pre-wired body harness and multiple body mount locations.
The new design will also help make upfitting a little easier since the fuel filler is now built into the cab (just behind the driver's door). Those integrated fuel filler necks will serve to feed either a 3.7-liter V6, a 3.5-liter EcoBoost V6, or a 3.2-liter Power Stroke diesel. Transit chassis cab and cutaways will wear varying Gross vehicle weight ratings from 9,000 pounds to 10,360 pounds depending on spec.