Repairable Rebuildable Salvage Wrecked Runs Drives Ez Project Needs Fix Save Big on 2040-cars

Auto blog

2014 Saleen George Follmer Edition Mustang debuts at Lagun Seca

Saleen used the occasion of the race-fueled Rolex Monterey Motorsports Reunion at Mazda Raceway Laguna Seca to announce its new Heritage Collection Lineup. The event was punctuated with the debut of the collection's first member, the 2014 Saleen George Follmer Edition Mustang.
Follmer's name will likely sound familiar to fans of American racing in the 1960s and '70s. The driver competed in Formula One with the Shadow team in 1973, ran the Indianapolis 500, was the Can-Am champion in 1972 and drove stock cars in NASCAR's Winston Cup as well. The multi-disciplined driver is now one of three -the other two being Mark Donohue and Swede Savage - with the honor of upcoming, limited edition Saleen-tuned vehicles..
Follmer's name will likely sound familiar to fans of American racing in the 1960s and '70s.

VW going turbo-only in 3 to 4 years

This really was a matter of when, rather than if. Volkswagen will apparently be the first manufacturer to phase out naturally aspirated engines in favor of turbocharging its full slate. VW is kind of responsible for ushering in this push towards small-displacement, turbocharged engines that's taken the industry by storm. When it dropped its direct-injection, 2.0-liter turbo in the 2005 GTI it demonstrated that strapping an iron long to an engine can enhance the powertrain as a whole. VW made fuel economy gains, while also giving a linear, non-laggy turbo experience that it has replicated, model-after-model, to this day.
Speaking with The Detroit News, Volkswagen's executive Vice President of Group Quality, Marc Trahan, told the paper that, "We only have one normally aspirated gas engine, and when we go to the next generation vehicle that it's in, it will be replaced. So three, four years maximum."
Really, it's hard to get teary-eyed about either of these engines going away. VW has access to smaller powerplants that could easily match the performance of the 2.5 five-cylinder and the 3.6 V6, while gobbling up less fuel and providing a better driving experience. What we are sad about is that a similar statement about the extinction of NA engines came from the Vice President of Powertrain Engineering at Ford, Joe Bakaj. We'd certainly get teary-eyed over a world without Ford's excellent 5.0-liter V8.

2015 Ford F-150's aluminum body not expected to hurt resale value

A cloud of skepticism has hung over the 2015 Ford F-150 since even before it went on sale. The issue had nothing to do with the truck's capabilities but instead over reservations about the switch to aluminum body panels. The change helped shed about 700 pounds off the scales, but the lighter metal also came with the potential for higher repair costs. Edmunds even recently whacked its pickup with a hammer just to find out how much it would cost. However, this might not be a problem, because the latest calculations indicate resale value for the new F-150 is on the rise. The residual experts at ALG estimate that the 2015 F-150 is going to hold 58 percent of its value over the next three years, versus 52 percent for the 2014 model, according to Bloomberg. That figure also gives the Ford the highest forecasted resale value among American fullsize pickups. The 2015 Toyota Tundra leads the segment by holding 63 percent. Meanwhile, the 2015 Chevrolet Silverado and GMC Sierra both come in with 51 percent, and the Ram 1500 holds 46 percent. Finally, the 2015 Nissan Titan comes in at 42 percent. The researchers believe that the improvement in fuel economy for the 2015 F-150 at up to 26 miles per gallon highway offsets higher body repair costs. "We are giving credit for the aluminum construction in the fuel efficiency we're seeing," Eric Lyman, ALG vice president of industry insights, said to Bloomberg. "We are not putting in a negative adjustment for concerns around repair costs or durability associated with aluminum." Ford has long-been preparing for the switch to aluminum. The company purposefully designed the body sections to make repairs easier, and it also partially subsidized dealers' investments for new equipment to do the work. Related Video: