2008 Ford Focus Se Sedan 4-door 2.0l on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

2017 Ford Super Duty trucks recalled because the fuel tank could fall off

Bad news from Dearborn. Ford just announced a pair of recalls, including a particularly worrying flaw in the new F-Series Super Duty. According to Ford's official announcement, there are roughly 8,000 of its big trucks on the roads with a missing reinforcement bracket – if it's not there, the fuel tank could separate from the frame. Yes, Ford is basically saying the fuel tank could fall out. We don't need to explain why this would be a very bad thing. Fortunately, no owners have experienced said bad things – Ford claims it's unaware of any fires, injuries, or accidents resulting from the flaws. The Kentucky Truck Plant built the affected pickups between August 10 and September 17. The bulk of the vehicles are in the US – 7,103, to be precise. Another 964 are cruising around the frozen Canadian tundra, while two more are in "federalized territories." The other recall is smaller, but reaches across a broad swath of the Blue Oval's family vehicles. Ford says there are 1,352 Taurus sedans, Flex crossovers, Explorer SUVs – including the Police Interceptor Utility variant – and Lincoln MKTs equipped with the company's 3.5-liter EcoBoost V6 that could catch fire. In this case, the danger isn't a detached fuel tank, but an "improperly brazed turbocharger oil supply tube" that could leak and spill engine oil on the turbocharger. Again, Ford isn't aware of any fires, accidents, or injuries due to the flaw. Here's the breakdown of manufacturer dates and location: 2016 Ford Taurus vehicles built at Chicago Assembly Plant, Oct. 18, 2016 to Nov. 2, 2016 2016-17 Ford Flex vehicles built at Oakville Assembly Plant, Oct. 18, 2016 to Nov. 10, 2016 2017 Ford Explorer vehicles built at Chicago Assembly Plant, Oct. 15, 2016 to Nov. 12, 2016 2017 Ford Police Interceptor Utility vehicles built at Chicago Assembly Plant on Nov. 2, 2016 2016-17 Lincoln MKT vehicles built at Oakville Assembly Plant, Oct. 18, 2016 to Nov. 10, 2016 As with the Super Duty recall, most of the affected cars, crossovers, and SUVs are in the US market. There are 126 units in Canada and six in the same "federalized territories" mentioned above. In the case of both recalls, dealers will inspect the affected parts and replace or add them as necessary. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.

Ford to build next F-150, outgoing model concurrently?

Ford is rumored to be considering concurrent production for old and new F-150 models in a bid to minimize supply chain disruptions and inventory. Automotive News is reporting that the Blue Oval will build both the current F-150 and its replacement, which we showed you testing just last month, side by side for about half a year before switching over entirely to next-generation production.
As IHS Automotive analyst Mike Jackson told AN, "In order to ramp up, you have to retool...and that means you have to take capacity offline." Building both models alongside could allow Ford to cope with the still strong demand for the current F-150, while populating dealer supplies and working out supply chain kinks for the new model before making a full-time switch.
A loss of capacity when demand is so strong, even for a short period, could spell bad news for Ford, which nets an estimated 90 percent of its global profit on pickups and large SUVs. As AN states, Ford produces the F-150 in both Kansas City, Missouri and Dearborn, Michigan, which allows it to maintain some degree of flexibility in production. The new F-150 is expected to arrive at the 2014 North American International Auto Show as a 2015 model, with a design inspired by the Atlas Concept first shown at the Detroit Auto Show last January.