2007 Ford Focus Ses Hatchback 5-door 2.0l on 2040-cars

Auto blog

2015 Ford Mustang EcoBoost loses big power on 87 octane

The 2015 Ford Mustang with the 2.3-liter EcoBoost four-cylinder is a pretty potent package on paper. With 310 horsepower and 320 pound-feet of torque, it boasts better performance numbers than the 3.7-liter V6, but with better fuel economy as an added benefit. However, if you're in the market for one of these boosted 'Stangs, you should probably keep in mind that it really prefers to gulp premium, 93-octane fuel. It can drink 87-octane swill in a pinch, but you're going to find significantly less power underfoot when pulling away. While it's not shocking that the ponies are dialed back with a lower grade of gasoline, an alleged page from a Ford training manual obtained by Mustang 6G purports to show just how much power is lost, though. According to this document, the 2.3-liter EcoBoost makes 275 horsepower and 300 pound-feet of torque when running on lower octane fuel. That's a substantial reduction of about 11.3 percent compared to when the engine drinks 93 octane. Interestingly, according to Mustang 6G, that finding was a bit better than expected, because a Ford engineer reportedly said power would be down about 13 percent without altering peak torque. In speaking with Autoblog, Paul Seredynski of Ford powertrain communications, objected to part of this document. While he couldn't confirm the specific losses listed for the Mustang EcoBoost, "torque remains unchanged" with lower octane gasoline, Seredynski said. He speculated this training manual page was "possibly from before the engine was certified" and therefore showed incorrect figures. Serendynski did confirm that the automaker recommends using 93 octane, and like all modern engines, the software adapts if it's lower. "Peak power would be reduced" by using a lesser grade, he confirmed. Featured Gallery 2015 Ford Mustang EcoBoost: First Ride View 20 Photos News Source: Mustang 6GImage Credit: Copyright 2015 AOL, Ford, Mustang 6G Ford Technology Convertible Coupe Performance ecoboost ford mustang ecoboost

Ken Block's 1965 Ford Mustang Hoonicorn RTR and CR Supercars Villain are retro done right

Gymkhana king Ken Block has had a pretty simple car history in his trademark videos, starting out with Subaru Impreza rally cars before moving into Ford Focus racers for the past four installments. His next video, though, Gymkhana Seven, kind of goes back in time.
Rather than the cutting-edge rally racers of past videos, Block will pilot a heavily modified 1965 Ford Mustang, called the Hoonicorn. How heavily modified is it? Well, Block's Hooligan Racing Division, ASD Motorsports and Vaughn Gittin Jr.'s RTR, spent two years working on it, ditching the standard engine and rear-wheel-drive layout and replacing it with a 410-cubic-inch Roush Yates V8. Yes, that's a NASCAR engine, and it produces 845 horsepower.
A NASCAR-powered Mustang would be news in itself, but it's the other powertrain changes made by Block and Co. that really makes headlines. Power is channeled through a one-off Sadev transmission and all-wheel-drive system, meaning that Block has basically married a NASCAR stock car with a WRC racer. ASD also developed the customized suspension, tubular chassis and roll cage. The wide Mustang body is the work of RTR and Block's own Hoonigan Racing Division, while the 18-inch fifteen52 wheels are shod in Pirelli Trofeo R tires that use a specialized compound exclusive to Block.

Rising aluminum costs cut into Ford's profit

When Ford reports fourth-quarter results on Wednesday afternoon, it is expected to fret that rising metals costs have cut into profits, even as rivals say they have the problem under control. Aluminum prices have risen 20 percent in the last year and nearly 11 percent since Dec. 11. Steel prices have risen just over 9 percent in the last year. Ford uses more aluminum in its vehicles than its rivals. Aluminum is lighter but far more expensive than steel, closing at $2,229 per tonne on Tuesday. U.S. steel futures closed at $677 per ton (0.91 metric tonnes). Republican U.S. President Donald Trump's administration is weighing whether to impose tariffs on imported steel and aluminum, which could push prices even higher. Ford gave a disappointing earnings estimate for 2017 and 2018 last week, saying the higher costs for steel, aluminum and other metals, as well as currency volatility, could cost the company $1.6 billion in 2018. Ford shares took a dive after the announcement. Ford Chief Financial Officer Bob Shanks told analysts at a conference in Detroit last week that while the company benefited from low commodity prices in 2016, rising steel prices were now the main cause of higher costs, followed by aluminum. Shanks said the automaker at times relies on foreign currencies as a "natural hedge" for some commodities but those are now going in the opposite direction, so they are not working. A Ford spokesman added that the automaker also uses a mix of contracts, hedges and indexed buying. Industry analysts point to the spike in aluminum versus steel prices as a plausible reason for Ford's problems, especially since it uses far more of the expensive metal than other major automakers. "When you look at Ford in the context of the other automakers, aluminum drives a lot of their volume and I think that is the cause" of their rising costs, said Jeff Schuster, senior vice president of forecasting at auto consultancy LMC Automotive. Other major automakers say rising commodity costs are not much of a problem. At last week's Detroit auto show, Fiat Chrysler Automobiles NV's Chief Executive Officer Sergio Marchionne reiterated its earnings guidance for 2018 and held forth on a number of topics, but did not mention metals prices. General Motors Co gave a well-received profit outlook last week and did not mention the subject. "We view changes in raw material costs as something that is manageable," a GM spokesman said in an email.