2014 Limited New 3.5l V6 24v Automatic Fwd Suv on 2040-cars

Auto blog

More evidence GT500-replacement will be named GT350

During the recent unveiling of the 2015 Ford Mustang, we saw the car in both V6 and GT form, but we'll have to wait a little bit longer to see the successor to the Shelby GT500. In the meantime, though, it looks like SVTPerformance.com has confirmed reports that this high-performance model will bring the Shelby GT350 name back to Ford.
According to the forum post, a user found the Shelby GT350 name on a Ford promo website listing its 2015 lineup. The Shelby GT350 name was first used on a Mustang back in 1965, and most recently it has been a model created for customers as a post-title purchase by Shelby American. As for that car, Shelby confirmed earlier in the year that its GT350 would be phased out at the end of this month.
The million-dollar question for Mustang and Shelby enthusiasts is when we'll see next factory Shelby GT350. Last we heard it was planned for a debut at the New York Auto Show. We've included our previous spy shots of this hi-po, sixth-gen Mustang, and we've also captured it on spy video showing off its exhaust note.

Ford recalls 434k vehicles for several unrelated issues

It seems that the hard winter in much of the country has been as rough on some Fords as it has on many people. The Blue Oval is recalling roughly 434,000 vehicles in two separate recalls, and one of them partially caused by the salt used to melt the snow on roads.
The first recall covers 385,750 2001-2004 Escape models in the Midwest, Northeast and Canada because a subframe could rust and eventually fail. This is partially due to the road salt used in those areas, and about 349,000 of the affected vehicles are in the US. To remedy the problem, dealers are installing a reinforcement cross brace on the frame to strengthen them. There has been one crash caused by the failure but no injuries. According to The Detroit News, this is not the first rust-related recall for Ford. It estimates the company has repaired over two million vehicles since 2010 for problems on vehicles related to the iron oxide, including the rear wheel wells of the Freestar minivan.
The second recall covers 48,950 2013-2014 Ford Fusion, Escape, C-MAX and Lincoln MKZ models because welds in their seatbacks don't meet National Highway Traffic Safety Administration standards. The fault affects the front seats, and the sub-standard welds joining the setback to the recliner could increase the chance on injury. There have been no reported injuries or accidents caused by the problem, but there are 42,972 affected vehicles in the US and 4,744 in Canada.

Recharge Wrap-up: Ford 1.0L EcoBoost a hit in Europe; Build a tiny inverter, win $1 million

In Europe, Ford's 1.0-liter EcoBoost engine is the best-selling turbocharged gasoline engine. The three-cylinder motor powers 20 percent of new Fords sold in Europe. Earlier this year, it won its third International Engine of the Year award, and between January and June, it was sold in about 120,000 cars. So far this year, 38 percent of Fords sold in the Netherlands, 35 percent in Denmark and 32 percent in Switzerland have been powered by the 1.0-liter EcoBoost. The engine's turbocharger spins at 248,000 rpm, and provides 24 psi of pressure. The engine produces up to 138 horsepower, depending on the version. Read more in the press release below. When lithium-ion battery packs are retired from the road, remanufacturing, repurposing, and recycling are worthwhile options, according to a study by Mineta Transportation Institute. The study included a cost-benefit analysis of those three options, and found remanufacturing to be the best route. To get the most out of them, batteries should be tested and have their damaged cells replaced then put back to use. Repurposing is the second best option, using the remaining available charge for something besides cars. Recycling on its own isn't profitable, but it could make economic sense with "increased technological breakthroughs." Learn more at Recycling International or download the report here. A smaller inverter for EVs can win you $1 million. The Little Box Challenge is an open competition to build a power inverter with a density of at least 50 watts per cubic inch. Google and the Institute of Electrical and Electronics Engineers (IEEE) are offering the hefty prize to the team that builds the inverter with the highest power density within an enclosed volume of 40 cubic inches. Teams must register by September 30. Read more at Green Car Congress or learn more at the Little Box Challenge website.